Question is ⇒ A series resonant circuit has R = 2 Ω, L = 0.1 H and C =10 μF. At resonance applied voltage = 10 ∠0 V. Voltage across inductance is likely to be, Options are ⇒ (A) 10 ∠0 V, (B) 10 ∠45° V, (C) 100 ∠90° V, (D) 100 ∠-90° V, (E) , Leave your comments or Download question paper.

Question is ⇒ A series resonant circuit has R = 2 Ω, L = 0.1 H and C =10 μF. At resonance applied voltage = 10 ∠0 V. Voltage across inductance is likely to be, Options are ⇒ (A) 10 ∠0 V, (B) 10 ∠45° V, (C) 100 ∠90° V, (D) 100 ∠-90° V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A series resonant circuit has R = 2 Ω, L = 0.1 H and C =10 μF. At resonance applied voltage = 10 ∠0 V. Voltage across inductance is likely to be
A.	10 ∠0 V [Wrong Answer]
B.	10 ∠45° V [Wrong Answer]
C.	100 ∠90° V [Correct Answer]
D.	100 ∠-90° V [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Poynting theorem relates the electric intensity E, magnetic intensity H to the rate of energy flow per unit area at a point P as
P = E/H
P = H/E
E = 1/E x H
P = E x H

⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as
f
f²
f⁴
f^1/2

⇒ In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually
Less than n
2n
n
greater than 2n

⇒ Consider the following statements about Rhombic antenna

It is non resonant
It is a broad band antenna
It is ideally suited for HF transmission

Which of the above are correct?
1, 2, 3
1, 3 only
2, 3 only
1 only

⇒ Magnetic deflection is inversely proportional to
voltage
(voltage)^0.5
(voltage)^1.5
(voltage)²

⇒ The gate current required to turn on an SCR is
few amperes
a few mA
almost equal to anode current
about 50% of anode current

⇒ If E is energy level of electron and E_F is Fermi level, then
all quantum states with E less than E_F will be occupied at T = 0
all quantum states with E less than E_F will be empty at T = 0
some quantum states with E less than E_F will be occupied at T = 0
none of the above

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ In the below figure, the load is highly inductive. The firing angle is a for each of the thyristors. The periods of conduction of Th₁ and Th₂ respectively
0 to p and p to 2p
a to p and p + a to 2p
a to p + a and p + p to 2p + a
a to p - a and p + a to 2p - a

⇒ In a rectifier circuit the filter capacitance is increased. Then the ripple will
increase
decrease
remain the same
either (a) or (b)

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ A noise can be represented as superposition of spectral components. When this noise is passed through a narrow band filter, the output of filter should look like
sinusoidal
rectangular
triangular
none of the above

⇒ Two coils are connected in parallel. Their fluxes are adding. If the connections of one of the coils are reversed, the total inductance of the arrangement
will decrease
may increase or decrease
will remain the same
will increase

⇒

Assertion (A): The number of basic loops is equal to number of links.

Reason (R): The graph theory helps in choosing independent variables in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statement about receivers is false?
Double conversion is used to improve image rejection
Double conversion is used to improve selectivity
Variable sensitivity is used to improve selectivity
Variable sensitivity is used to eliminate selective fading

⇒ A n-port network is said to be active if power in the ckt is __________ .
P > 0
P < 0
P = 0
P = ∞

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
1 kV/cm
5 kV/cm
10 kV/cm
26 kV/cm

⇒ In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then
C = log₂ N
C = (δf) log₂ N
C = 2 (δf) log₂ N
C = 0.5 (δf) log₂ N

⇒ A step voltage E is applied to an R-L series circuit. At t = 0, the current in the circuit is
E/R
E/L
infinity
zero

⇒ The A.C. resistance of the emitter diode will be
5.05 Ω
50.5 Ω
505 Ω
5050 Ω

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒ A series resonant circuit has inductance L. If L is increased, the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ The resistance R_AB in the circui
10 Ω
12 Ω
9 Ω
3 Ω

⇒ Which circuit is called emitter follower?
CC
CE
CB
Both (a) and (b)

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ For an ideal antenna, numerical value of directivity must be
∞
0
1
any value

⇒ The following table gives some time functions and the Laplace transf
2 and 4
1 and 4
3 and 4
1 and 2

⇒ In a directional coupler
isolation (dB) equals coupling plus directivity
coupling (dB) equals isolation plus directivity
directivity (dB) equals isolation plus coupling
isolation (dB) equals (coupling) (directivity)

⇒ The network
First order system and the pole
Second order system of the two poles are
Second order system of the poles is
none of the above