Question is ⇒ The maximum efficiency of class A amplifier is, Options are ⇒ (A) 1, (B) 0.818, (C) 0.5, (D) 0.4, (E) , Leave your comments or Download question paper.

Question is ⇒ The maximum efficiency of class A amplifier is, Options are ⇒ (A) 1, (B) 0.818, (C) 0.5, (D) 0.4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The maximum efficiency of class A amplifier is
A.	1 [Wrong Answer]
B.	0.818 [Wrong Answer]
C.	0.5 [Correct Answer]
D.	0.4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC

⇒ In a 3 phase system, the zero sequence component of line to line voltages is zero
if line to line voltages are balanced
if line to line voltages are unbalanced
if line to line voltages are balanced or unbalanced
if degree of unbalanced in line to line voltages is small

⇒ The law J = σE, where J is current density, σ is electrical conductivity and E is field strength is
Ohm's law
Gauss law
Ampere's law
Biot-Savart law

⇒ Most popular IF for receivers tuning to 540 to 1650 kHz is
433 kHz
455 kHz
545 kHz
555 kHz

⇒

Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.

Reason (R): The time base generator develops a saw tooth voltage.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒ An one sided abrupt junction has 10²¹/m³ of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^-19 C, ε_r =16, ε₀ = 8.87 x 10^-12 F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm

⇒ Which of following antenna not produces circular polarisation?
Helical
Parabolic
Disc
Yagi

⇒

Assertion (A): The main use of positive feedback is in oscillator circuits.

Reason (R): In an oscillator the loop gain Aβ is kept slightly more than unity

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ High frequency oscillations can be caused by
electric coupling
magnetic coupling
ground loop
all of the above

⇒ Neutralization is used in RF amplifiers to
stop oscillation
increase bandwidth
improve selectivity
all of the above

⇒ If R_T, R_h represent condition for reciprocity in case of transmission parameter and hybrid parameter respectively and similarly S_T, S_h represent condition for symmetry in case of transmission parameter and hybrid parameter respectively then match the followi
1 - c 2 - d 3 - a 4 - f
1 - c 2 - b 3 - e 4 - d
1 - e 2 - d 3 - a 4 - b
1 - e 2 - d 3 - a 4 - f

⇒ The scale factor for half wave and full wave rectifier is __________ respectively.
1.11, 1.414
1.11, 1.57
1.57, 1.11
1.414, 1.11

⇒ An XOR gate with 8 variable is as foll
255
127
128
256

⇒ Kell factor is about
5
3
0.7
0.2

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ The colour code on a carbon resistor is brown-black-red-gold. The value of resistance is
100 Ω
1000 Ω
1000 Ω ± 5%
1000 Ω ± 10%

⇒ The write cycle time of memory is 200 nsec. The maximum rate of data which can be stored is
200 words/sec
5 x 10³ words/sec
5 x 10⁶ word/sec
5 x 10⁹ words/sec

⇒

Assertion (A): Interfacing means synchronisation of digital information transmission between input output devices and computer.

Reason (R): A computer with higher bit word size executes programs at a faster rate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The impurity commonly used for realizing the base region of a n-p-n transistor is
gallium
indium
boron
phosphorus

⇒ A 2 bit binary multiplier can be implemented using
2 I/P only
2 I/P XOR_s and 4 I/P and gates only
two 2 I/P_s NOR and one XNOR gate
XOR gates and shift Register

⇒ A thyristor is reverse biased. A positive gate pulse is applied. The thyristor
will be turned on
may or may not turn on
will not turn on
will turn on after sometime

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ The ripple factor of power supply is a measure of
its filter efficiency
diode rating
its voltage regulation
purity of power output

⇒ A universal shift register can shift left or right.
TRUE
FALSE

⇒ One of the advantages of base modulation over collector modulation of a transistor class C amplifier is
improved efficiency
better linearity
high power output per transistor
the lower modulating power requirement

⇒ For a NAND SR latch of input is the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 1, R = 0
S = R = 0

⇒ What does the instruction 'PCHL' in 8085 do?
Load the program counter with contents of register pair H L
Double the contents of register pair H L
Shift the contents of register pair H L by one bit to the right
Shift the contents of register pair H L by one bit to left

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above