Question is ⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere., Options are ⇒ (A) 7.07, (B) 10, (C) 12.07, (D) 2.07, (E) , Leave your comments or Download question paper.

Question is ⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere., Options are ⇒ (A) 7.07, (B) 10, (C) 12.07, (D) 2.07, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
A.	7.07 [Correct Answer]
B.	10 [Wrong Answer]
C.	12.07 [Wrong Answer]
D.	2.07 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following circuits cannot be demodulate SSB?
Product detector
Balanced modulator
Phase discriminator
BFO

⇒ One of a loss-less transmission line having the characteristic impedance of 75 Ω and length of 1cm is short-circuit. At 3 GHz, the input impedance at the other end of the transmission line is
0
resistive
capacitance
inductive

⇒ A 1 μF capacitor is connected to 12 V battery. The energy stored in the capacitor is
12 x 10^-6 J
24 x 10^-6 J
48 x 10^-6 J
72 x 10^-6 J

⇒ A system with transfer function H(z) has impulse response h(.) defined as h(2) = 1, h(3) = -1 and h(k) = 0 otherwise. Consider the following statem
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, and S2 is a reason for S1
Both S1 and S2 are true, but S2 is not a reason for S1

⇒ A presettable counter with 4 flip flops can start counting from
0
1000
any number from 0000 to 1000
any number from 0000 to 1111

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ The enhancement type MOSFET is called a
normally on MOSFET
normally off MOSFET
P-type MOSFET
N-type MOSFET

⇒ The response of D'Arsonval galvanometer is over damped if
D² > 4CJ
D² > 2CJ
D² < 4CJ
D² < 2CJ

⇒ In the amplifier circuit figure the quiescent point voltage and current
12 V, 5 mA
12 V, 2 mA
10 V, 2 mA
10 V, 5 mA

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ The Fourier series of a real periodic function has only

Cosine terms if it is even
Sine terms if it is even
Cosine terms if it is odd
Sine terms if it is odd

Which of the above statements are correct?
(1) and (4)
(1) and (2)
(2) and (4)
(2) and (3)

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ The inverse of given Laplace transfor
sin t
cos t
e^t
e^2t

⇒ Consider the following statements as regards advantages of CCD sensors as camera pick up tube

High sensitivity
Good spectral response
Image lag absent

Out of the above which are correct
1, 2, 3
1, and 2 only
1 and 3 only
2 and 3 only

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ If e is the charge of an electron, R is the radius of its orbit and ω is the angular velocity of electron, the magnetic dipole moment μ_m of the orbit is |μ_m| = eωR².
TRUE
FALSE

⇒

Assertion (A): An amorphous material is obtained when mobility of atoms is inhibited during solidification.

Reason (R): Crystalline state is a natural state for most solids.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ The value of program counter of 6800 at power on are after reset is
0
FFFE
User Programmable
FFFF

⇒ In figure, V_CC = + 30 V, R₁ = 200 kΩ and R₂ = 100 kΩ. If V_BE = 0.7 V, the voltage a cross R_{E+20 V
+19.3 V
+10 V
+9.3 V}

⇒ Which of the following rotors are used in two phase ac servomotor?

Solid iron rotor
Squirrel cage rotor
Drag cup rotor

Of the above the correct ones are
1, 2, 3
1, 2
2, 3
1, 3

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V

⇒ Norton's theorem reduces a two terminal network to
a constant current source and an impedance is parallel
a constant current source and an impedance in series
a constant voltage source and an impedance in parallel
a constant voltage source and an impedance in series

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ At 20 GHz , the gain of a parabolic dish antenna of 1 meter diameter and 70% efficiency is
15 dB
25 dB
35 dB
45 dB