Question is ⇒ A parallel in-parallel out shift register can be used to introduce delay in digital circuits., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ A parallel in-parallel out shift register can be used to introduce delay in digital circuits., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A parallel in-parallel out shift register can be used to introduce delay in digital circuits.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A reactance function
has a pole at origin
has a zero at origin
may have a pole or zero at origin
has a pole or zero at origin and a pole or zero at infinity

⇒ A multilevel decoder is more costly as compared to single level decoder.
TRUE
FALSE

⇒ A TTL circuit with totem pole output has
high output impedance
low output impedance
very high output impedance
none of the above

⇒ A 750 A circuit uses thyristor of current rating 175 A. If derating is 25%, the number of thyristors in parallel is
3
4
6
10

⇒ Figure is a 24 V_r stabilized power supply. The zener is 24 V, 600 mW. The minimum zener current is 10 mA. Proper values R and maximum load current
320 Ω, 10 mA
400 Ω, 15 mA
400 Ω, 10 mA
320 Ω, 15 mA

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ Serial in-serial out shift register can be built using D flip flops.
TRUE
FALSE

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in intensity of optical illumination results in
a change in o.c voltage
a change in s.c current
decrease in resistance
increase in resistance

⇒ In INHIBIT operation
output is 1 when both inputs are 0
output is 0 when blocking input is 1
output is 0 when blocking input is 0
output is 1 when blocking input is either 0 or 1

⇒ Induction wattmeter can be used in
ac circuit only
dc circuit only
both ac and dc circuit
ac 3 phase only

⇒ In a 4 bit weighted resistor D/A converter, resistor value corresponding to LSB is 32 k ohm. The resistor value corresponding to MSB is
32 k ohm
16 k ohm
8 k ohm
4 k ohm

⇒ A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
13 mm
1.3 mm
130 mm
none of the above

⇒ The amplitude of a modulated RF aerial current is 6 A on the peaks of modulation and 4 A on the troughs of modulation. The value of carrier amplitude is
5
15
20
30

⇒ In ASCII, letter B is coded as
1000001
1000010
100100
1001000

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ Electrical conductivity of metals expressed in ohm^-1 m^-1 is of the order of
10¹⁰
10⁵
10^-4
10^-6

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ A wire is carrying current I. The field intensity H at a distance r from the wire
is directed towards wire
is directed away from wire
is tangential every where to a circle of radius r
none of the above

⇒ Which one of following is a stataic system?
y(n) = x(n) - x(n - 1)
y(n) = x(2n) - x(2n-1)
y(n) = x(n - 1)
y(n) = e^x(n)

⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt

⇒ A 16 bit binary adder has
16 half adders
16 full adders
one half adders and 15 full adders
8 half adders and eight full adders

⇒ The turn off time of a bipolar transistor is about
0.5 ns
10 ns
70 ns
150 ns

⇒ In an ac circuit the fundamental component of current wave lags the corresponding voltage wave by 20°. The third harmonic component of current wave lags the corresponding voltage by an angle.
less than 20°
more than 20°
equal to 20°
equal to or more than 20°

⇒ The antenna current of an AM broad cast transmitter, modulated to a depth of 40% by an audio sine wave is 11 amperes. It increased to 12 ampere as a result of simultaneous modulation by another sine wave. The modulation index due to this second sine wave is :
0.4
0.757
0.643
0.8

⇒ The direction in a Yagi Uda antenna
is longer than the radiating element
is shorter than the radiating element
can be longer or shorter than the radiating element
does not exist

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following is a circularly polarized antenna?
Rhombic
Circular loop
Helical
Yagi

⇒

Assertion (A): A 4 input variable logic circuit can be implemented using a 8 : 1 multiplexer.

Reason (R): When a multiplexer is used as a logic function generator, the logic design is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A twisted ring counter consisting of 4 FF will have
4 states
8 states
2⁴ states
None of the above

⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
ω₁ = ω₀ + bandwidth
ω₁ = ω₀ + 0.5 (bandwidth)
ω₁ = ω₀ - 0.5 (bandwidth)
ω₁ = ω₀ + bandwidth