Question is ⇒ Which of these has semi-conductor metal junction?, Options are ⇒ (A) PIN diode, (B) Photo diode, (C) Tunnel diode, (D) Schottky diode, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of these has semi-conductor metal junction?, Options are ⇒ (A) PIN diode, (B) Photo diode, (C) Tunnel diode, (D) Schottky diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of these has semi-conductor metal junction?
A.	PIN diode [Wrong Answer]
B.	Photo diode [Wrong Answer]
C.	Tunnel diode [Wrong Answer]
D.	Schottky diode [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a level input sequential circuit
output in a level only
output is in the pulse form
output may be a pulse or a level form
none of these

⇒ A dielectric material must be
insulator
good conductor
resistor
semiconductor

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in illumination results in
a change in O.C. voltage
a change in S.C. current
a decrease in resistance
an increase in resistance

⇒ The transconductance curve of a JFET is
a straight line
parabolic
hyperbolic
inverted V-type

⇒ Which of the following finds application in pocket calculators?
TTL
CMOS
ECL
Both (a) and (c)

⇒ Full duplex operation-permits transmission in both directions at the same time.
TRUE
FALSE

⇒ Average latency time of magnetic tape memory is of the order of
1 μ sec
1 msec
1 sec
1 minute

⇒ In thermal ohm's law, temperature and power loss are analogous to
V and I respectively of ohm's law
I and V respectively of ohm's law
R and V respectively of ohm's law
I and R respectively of ohm's law

⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements

⇒

Match the following:

	List I (VCR system)		List II (Azimuth angle)
A.	VHS	1.	7°
B.	Video 2000	2.	15°
C.	Betamax	3.	6°

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-1, C-2
A-3, B-2, C-1

⇒ In shot noise
the current rises around mean value
the current rises to peak value, decreases to zero and then again rises
the current may become negative
the current is always less than the mean value

⇒ Class-B amplifier has less efficiency compared to
class A
class B
class C
class A, AB and C

⇒ Pre-emphasis circuit is used
after modulation
before modulation
before detection
after detection

⇒ In SSB generation, the most commonly used filter is
low pass
RC
LC
mechanical

⇒ In the circuit of figure the current through C at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ An electrically neutral semiconductor has
no free charges
no majority carriers
no minority carriers
equal number of positive and negative charges

⇒ In a bipolar transistor the barrier potential
0
a total of 0.7 V
0.7 V across each depletion layer
0.35 V

⇒ The smallest change in sound intensity that can be detected by human ear is __________ dB.
1
3
10
20

⇒ Shannon's Law relates
antenna gain to frequency
noise power to bandwidth
information-carrying capacity to S/N ratio
transmission losses to noise

⇒ In figure, V_{AB6 V
10 V
25 V
40 V}

⇒ To convert JK flip flop to D flip flop
connect D to both J and K
connect D to J directly and D to K through inverter
connect D to K directly and D to J through inverter
connect D to K and leave J open

⇒ A binary with a digits, all of which are unity has the value
n² - 1
2ⁿ
2(^{n - 1})
2ⁿ - 1

⇒ A linear discrete time system has the char. equation z³ - 0.81z = 0, the system is
stable
marginally stable
unstable
stability cannot be assessed from the given information

⇒ In a J-K flip flop the input J = K = 1 pulse is about
set
reset
no change
toggle

⇒ Which one of the following is true?
Characteristic impedance of twin wire feeder and coaxial cable are nearly the. same
The characteristic impedance of coaxial cable is more than that of twin wire cable
The characteristic impedance of twin wire cable is more than that of coaxial cable
The characteristic impedance of a twin wire feeder may be more or less than that of coaxial cable

⇒ For 200V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
280 V
346 V

⇒ For the network shown below, if V_D = 12 V and V_GSQ = - 2 V value of R_S wil
13.35 kΩ
3.35 kΩ
33.31 kΩ
3.95 kΩ

⇒ UHF range is
30 MHz to 300 MHz
300 MHz to 3000 MHz
3000 MHz to 30, 000 MHz
above 30, 000 MHz

⇒

Match the following:

	List I		List II
A.	RF amplifier	1.	Amplifier received carrier and sidebands
B.	Loudspeaker	2.	Gives acoustic output
C.	Demodulator	3.	Has IF input and AF output
D.	IF amplifier	4.	Fixed-tuned to intermediate frequency

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-1, D-2
A-1, B-4, C-3, D-2

⇒ What is the frequency of the modulated carrier wave?
1000 Hz
2000 Hz
1000 kHz
2000 kHz