Question is ⇒ Which of the following noise becomes of great importance at high frequencies?, Options are ⇒ (A) Shot noise, (B) Agitation noise, (C) Flicker noise, (D) Transit time noise, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following noise becomes of great importance at high frequencies?, Options are ⇒ (A) Shot noise, (B) Agitation noise, (C) Flicker noise, (D) Transit time noise, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following noise becomes of great importance at high frequencies?
A.	Shot noise [Wrong Answer]
B.	Agitation noise [Wrong Answer]
C.	Flicker noise [Wrong Answer]
D.	Transit time noise [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a perfect conductor the resistor noise is
maximum
zero
very high
almost infinite

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒ For operation of enhancement only N-channel MOSFET, value of gate voltage has to be
zero
low positive
high negative
high positive

⇒ Entropy gives
measure of Uncertainty
rate of Information
average information
probability of Information

⇒ BCD equivalent of - 8₁₀ is
110
10110
11000
1000

⇒ When one operand is real and one integer in Pascal, which of the following operations are not allowed?
+ and -
*
/
Div and Mod

⇒ It is required that a strain gauge has gauge factor of 100. The proper strain gauge is
constantan strain gauge
nichrome strain gauge
semiconductor strain gauge
alloy strain gauge

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.
TRUE
FALSE

⇒ The scale of dynamometer wattmeter is non linear.
TRUE
FALSE

⇒ In a three cavity klystron amplifier, the oscillations are excited in
input cavity
output cavity
intermediate cavity
both (a) and (b)

⇒ X and Y are two random variables and Z = X + Y . Letmz, m_z, m_x, m_y represent mean of Z, X and Y. Then
m_z = m_x + m_y
m_z ≤ m_x + m_y
m_z< m_x + m_y
m_z > m_x + m_y

⇒ If the resolution of a printer is 1200 dpi, the number of dots per square inch is
1200
800
1200 x 1200
either (a) or (b)

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase-shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either o.c or s.c

⇒ In figure as the load resistance is cha
the zener current remain constant
the load current remains constant
the output voltage remains constant
the output voltage and current through R remain constant

⇒ An insulator will conduct when the
voltage applied is more than the breakdown voltage
temperature is raised to very high level
either (a) or (b) above
none of the above

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ A half adder adds __________ bits and a full adder adds __________ bits.
two, three
three, four
four, six
two, four

⇒ A series RL circuit is excited by a voltage v(t) = V_msin (ωt + Φ). The transient current will be zero if
Φ = 0
ω = 0
Φ = tan^-1 (ωL/R)
ω - tan^-1 (ωL/R) = p/2

⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒ Out of SR and JK flip flops, which is susceptible to race condition?
SR
JK
Both SR and JK
None of the above

⇒ Decimal 1932 when converted into 10's complement will become
8868
8060
8608
8806

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ The signal m(t) = 10 cos 100 pt is sampled at the rate of F_s = 75 H_z, then determine signal after sampling.
4 cos 100 pt + 8 sin 200 pt
4 cos 100 pt + 8 sin 200 pt + cos 75 pt
4 cos 25 pt + 8 sin 50 pt + cos 75 pt
none

⇒ A standard waveguide W R90 has inside wall dimensions of a = 2.286 cm and b = 1.016 cm. What is the cut-off wavelength for TE₀₁ mode?
4.572 cm
2.286 cm
2.032 cm
1.857 cm

⇒ In an n type semiconductor
number of free electrons and holes are equal
number of free electrons is much greater than the number of holes
number of free electrons may be equal or less than the number of holes
number of holes is greater than the number of free electrons

⇒ In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the maximum frequency deviation is
175 Hz
525 Hz
3 Hz
58.33 Hz

⇒ A memoryless source emits n symbols each with a probability p. The entropy of the source as a function of n
increases as log n
decreases as log (1/n)
increases as n
increases as n log n

⇒ Norton's theorem reduces a two terminal network to
a constant current source and an impedance is parallel
a constant current source and an impedance in series
a constant voltage source and an impedance in parallel
a constant voltage source and an impedance in series