Question is ⇒ The unit of ∇ x H is, Options are ⇒ (A) Ampere, (B) Ampere/meter, (C) Ampere/m<sup>2</sup>, (D) Ampere-meter, (E) , Leave your comments or Download question paper.

Question is ⇒ The unit of ∇ x H is, Options are ⇒ (A) Ampere, (B) Ampere/meter, (C) Ampere/m<sup>2</sup>, (D) Ampere-meter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The unit of ∇ x H is
A.	Ampere [Wrong Answer]
B.	Ampere/meter [Wrong Answer]
C.	Ampere/m² [Correct Answer]
D.	Ampere-meter [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equation ∇ . J = 0 is called
Poisson's equation
Kirchoff's node equation
Continuity equation for static currents
Continuity equation for sampling currents

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ The absorption of radio waves by atmosphere depends on
their frequency
their distance from the transmitter
the polarization of atmosphere
the polarization of the waves

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒

Match the following:

	List I		List II
A.	Reflex Klystron	1.	High efficiency
B.	Dielectric loaded wave guide	2.	Slow wave structure
C.	TWT	3.	Cross field device
D.	Multi Cavity Klystron	4.	Oscillator

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2

⇒ The main systems used for generation of SSB are
filter method
phase cancellation method
third method
all of the above

⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above

⇒

Assertion (A): The rms value of v = 1 + sin ωt is 1.5

Reason (R): If i = I₀ + I_1m sin ω₁t + I_3m sin 3ω₁t,
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In TE mode of waveguide E_z = 0
TRUE
FALSE

⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
0 V
10 V
20 V
40 V

⇒ With increase in temperature, the electrical conductivity would
increase in metals as well as in intrinsic semiconductor
increase in metals but decrease in intrinsic semiconductor
decrease in metals but increase in intrinsic semiconductor
decrease in metals as well as in intrinsic semiconductor

⇒ When transient and steady state response require improvement; a __________ is used.
Lead compensator
Lag - Lead compensator
Lag compensator
Integrator

⇒

Match the following:

	List I (Laws of Boolean)		List II (Relation algebra)
A.	Distributive law	1.	x + x = x
B.	DeMorgans law	2.	x(y + z) = xy + xz
C.	Idempotent law	3.	(x) = x
D.	Involution law	4.	(x + y) = xy

A-1, B-2, C-3, D-4
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-4, B-1, C-2, D-3

⇒ The term critical frequency denotes
the lowest frequency that is reflected by the ionosphere
the highest frequency that is reflected by the ionosphere at vertical distance
the lowest frequency by which communication is possible between two given points
none of the above

⇒ In a 3 phase semiconverter, the freewheeling diode comes into operation only if firing angle
is zero
is 60°
is more than 60°
is more than 90°

⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE

⇒

Assertion (A): Microprocessor 8085 has 16 address bus lines and 8 data bus lines.

Reason (R): Address bus in 8085 is unidirectional.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In C a character constant is either a single alphabet or digit or special symbol enclosed within single inverted commas.

Reason (R): In C the maximum length of a character constant can be 2 characters.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Thyristors connected in series need :
static equalizing circuit
dynamic equalizing circuit
both static and dynamic equalizing circuits
none of the above

⇒ Let JCOKE = 20 and LPEPSI =15. Consider the statement 25
23
15
17

⇒ If a sample of germanium and a sample of silicon have the same impurity density and are kept at room temperature
both will have equal value of resistivity
both will have equal negative resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than that of germanium

⇒ A limiter circuit can be built using a diode and resistance.
TRUE
FALSE

⇒ A linear diode detector uses RC filter. As modulation index increases the maximum permissible value of time constant RC
increases
decreases
remains constant
either (a) or (c)

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ When a thyristor is conducting, the voltage drop across it
is absolutely constant
decreases with increase in load current
increases slightly with increase in load current
none of the above

⇒ Which of the following is not a data base function?
DAVERAGE
MAX
DCOUNT
DSTDEV

⇒ The iron core of a coil is removed so that it becomes an air cored coil. Its inductance will
increase
decrease
remain the same
may increase or decrease

⇒

Match the following:

	List I		List II
A.	GTO	1.	Widely used in digital computers
B.	UJT	2.	Used for freewheeling
C.	Power Diode	3.	Can be turned off by negative gate signal
D.	MOSFET	4.	Used in generating triggering pulses

A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1
A-3, B-4, C-2, D-1
A-2, B-1, C-3, D-4

⇒ The power requirement of a RADAR used in military operations is
a few watts
about 500 W
about 2000 W
a few megawatts

⇒ Which of the following characteristic are necessary for a sequential circuit?

It must have 6 gates
It must have feedback
Its output should depend on past value

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3