Question is ⇒ In integral cycle control the period of on-off control should be more than mechanical time constant of load., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In integral cycle control the period of on-off control should be more than mechanical time constant of load., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In integral cycle control the period of on-off control should be more than mechanical time constant of load.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Broadcasting antennas are generally
omnidirectional type
vertical type
horizontal type
helical

⇒ For graph of figure, one set of fundamental cutsets woul
abc, cde, afe
afde, afe, abdc
cbfe, afe, bdf
cbd, adbe, cde

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The input impedance for a half dipole if radii of both the antenna is 4 and 8 meter respectively
600 Ω
100 Ω
657 Ω
650 Ω

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒ The pinch-off voltage is the drain voltage on the shorted gate drain curve above which the drain current becomes
almost negligible
very high
almost constant
highly variable

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ x = AX + Bu is a state equation.
TRUE
FALSE

⇒ Conductivity σ, mobility μ and Hall coefficient K_H are related as
μ = σK_H
σ = μK_H
K_H = μσ
K_H =(μσ)^1.1

⇒

Match the following:

	List I		List II
A.	Bode	1.	Asymptotic plots
B.	Evans	2.	Polar plots
C.	Nyquist	3.	Root locus technique
		4.	M and N circles

A-1, B-4, C-2
A-2, B-3, C-4
A-3, B-1, C-4
A-1, B-3, C-2

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then modulating frequency is
159 Hz
1590 Hz
1.59 MHz
15.9 MHz

⇒ The pre-emphasis circuit is used
prior to modulation
after demodulation
for low frequency components of the signal
none of the above

⇒ High intermediate frequency in a superheterodyne receiver
higher than
lower than
equal to
not comparable to

⇒ A function Z(s) has zero at infinity if
the degree of numerator and denominator are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒

Assertion (A): In a Schottky diode the reverse recovery time is almost zero.

Reason (R): A Schottky diode has aluminium silicon junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In MTI radar, clutter means
echos from moving targets
echos from stationary targets
atmospheric noise
thermal noise

⇒ Dielectric strength of polythene is around
10 kV/mm
40 kV/mm
100 kV/mm
140 kV/mm

⇒ A magnet does not attract
nickel
iron
copper
iron and copper

⇒ If transfer function of a system is H(z) = 6 + z^-1 + z^-2 then system is
minimun phase
maximum phase
mixed phase
none

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ The symbol in figure is
DIAC
P-N junction diode
Schottky diode
None of the above

⇒ A Wien bridge is suitable for
audio frequencies only
radio frequencies only
both audio and radio frequencies
very low frequencies only

⇒ The purpose of impedance matching in an amplifier circuit is to achieve
high efficiency
reduce distortion
maximum power transfer
none of the above

⇒

Match the following:

	List I		List II
A.	CTFS	1.	Periodic
B.	DTFS	2.	Non-periodic
C.	CTFT
D.	DTFT

A-2, B-1, C-2, D-2
A-2, B-1, C-2, D-1
A-1, B-2, C-2, D-2
A-1, B-2, C-2, D-1

⇒ What is the frequency of pulse at the points a, b, c in the circ
3 MHz
7.8 KHz
10 KHz
1 MHz

⇒ The peak factor is
rms value/peak value
rms value/average value
peak value/rms value
peak to peak value/rms value

⇒ In the context of error detection in satellite transmission, ARQ stands for
Automatic Repeat Request
Automatic Relay Request
Accelerated Recovery Request
Automatic Radiation Quenching