Question is ⇒ The circuit shown in the figure is best described, Options are ⇒ (A) bridge rectifier, (B) ring modulator, (C) frequency discriminator, (D) voltage doubler, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit shown in the figure is best described, Options are ⇒ (A) bridge rectifier, (B) ring modulator, (C) frequency discriminator, (D) voltage doubler, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit shown in the figure is best described
A.	bridge rectifier [Wrong Answer]
B.	ring modulator [Wrong Answer]
C.	frequency discriminator [Wrong Answer]
D.	voltage doubler [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For making a capacitor, the dielectric should have
high ∈_r
low ∈_r
∈_r = 1
∈_r neither too high nor too low

⇒ The circuit in the given figur
positive logic OR gate
negative logic OR gate
negative logic AND gate
positive logic AND gate

⇒ The operating voltage of a megger is about
100 V
12 V
6 V
1 V

⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13

⇒ The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10^-6 N-m on full scale. If B = 1 Wb/m², range of meter is
1 mA
2 mA
3 mA
4 mA

⇒ Which of the following statement regarding the advantages of the phase discriminator over the slope detector is false?
Better linearity
Fewer tuned circuits
Much easier alignment
Greater limiting

⇒ Orbital disturbances of a geosynchronous satellite are caused by the
moon
sun
earth
all of the above

⇒ In a CE amplifier circuit the load resistance is open circuited. The output voltage will
increase
decrease
become zero
increase or decrease

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ In an RC impedance function
the highest critical frequency is a pole
the highest critical frequency is a zero
the highest critical frequency is a pole or zero
the highest critical frequency is a pole at s = 0

⇒ The decimal equivalent of the binary number 10110.0101011101 is
22.24082165
22.340821675
22.3408213125
22.3408203125

⇒ If average correlation between v₁(t) and v₂(t) is R₁₂(t) and average correlation between v₂(t) and v₁(t) is R₂₁(t) then
R₁₂(t) = R₂₁(t)
R₂₁(t) = R₁₂(t)
R₁₂(t) = - R₂₁(t)
none of these

⇒ The number of distinct Boolean expression of 4 variables is
16
256
1024
65536

⇒ Secondary emission is always decremental.
TRUE
FALSE

⇒ The IF amplifier in a superheterodyne receiver is
single-stage single-timed amplifier
two stage of single tuned amplifier
double tuned amplifier
class-C amplifier

⇒ In a two tone AM system the two modulating frequencies are 2000 p and 4000 p rad/sec. If carrier frequency is 2p x 10⁶ rad/sec the frequencies of upper sidebands are
1.002 MHz and 1.004 MHz
1.001 MHz and 1.002 MHz
1.001 MHz and 1.004 MHz
1.002 MHz and 1.008 MHz

⇒ If two networks are connected in series of individual Z parameter as Z_a and Z_b then equivalent Z is
[Z] = [Z_a] + [Z_b]
[Z] = [Z_a] [Z_b]
[Z] = [Z_a]/[Z_b]
[Z] = [Z_a] - [Z_b]

⇒ Which of these statements is correct?
Ridge guide is essentially a form of capacitively loaded guide.
Ridge guide is essentially a form of inductively loaded guide.
Ridge guide is essentially a form of resistively loaded guide.
Ridge guide has higher power handling capacity than rectangular waveguide.

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.
INSAT-IA
INSAT-IB
INSAT-IC
INSAT-ID

⇒ Ferrites are
hard materials
brittle materials
not easily machinable
materials with all above properties

⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons

⇒ The speed at which axial electric field due to signal advances in a TWT is equal to
speed of light
(speed of light) (helix pitch helix circumference)
(speed of light) (helix circumference helix pitch)
(speed of light) (helix pitch) (helix circumference)

⇒ Consider the following differences between QPSK and MSK

The side lobes in MSK are relatively much smaller in comparison to the main lobe
The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
The waveforms of both MSK and QPSK exhibit phase continuity

Which of the above statements are correct?
1 only
1 and 2 only
1, 2 and 3
2 and 3 only

⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
1 mV
2 mV
1.414 mV
4 mV

⇒ The Ni-Zn ferrites are used for audio and TV transformers is that
they have large saturation magnetisation
they are easy to fabricate by rolling
they are free from pores and voids
they have high electro-resistivity

⇒ Ferrites have
a low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ (11)₂ + (11)₃ = (11)_?
4
5
6
none