Question is ⇒ The theoretical power of white noise is, Options are ⇒ (A) zero, (B) finite, (C) depend upon frequency of signal, (D) infninite, (E) , Leave your comments or Download question paper.

Question is ⇒ The theoretical power of white noise is, Options are ⇒ (A) zero, (B) finite, (C) depend upon frequency of signal, (D) infninite, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The theoretical power of white noise is
A.	zero [Wrong Answer]
B.	finite [Wrong Answer]
C.	depend upon frequency of signal [Correct Answer]
D.	infninite [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Noise can be measured by
D.C. voltmeter
A.C. voltmeter
either of the above
none of the above

⇒

Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In single phase half wave regulator, the average current over one full cycle
is always positive
may be positive or negative
may be negative
is always negative

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ The difference between resonant commutation and self commutation is
both these methods are based on entirely different principles
in resonant commutation, the commutating elements carry load current but in self commutation, the commutating elements do not carry load current
resonant commutation uses L and C but self commutation uses only capacitor
none of the above

⇒ The main reason why Ni-Zn ferrites are used for audio and T.V. transformers is that
they have large saturation magnetization
they are easy to fabricate by rolling
they are totally free from pores and voids
they have a high electrical resistivity

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒ In p channel JFET, V_GS is positive.
TRUE
FALSE

⇒ If resistance is 20 Ω and inductance is 2 H in a R-L series circuit, then time constant of this will be
0.001 s
0.1 s
10 s
100 s

⇒

Assertion (A): Capacitance of a solid conducting spherical body of radius 'a' is given by 4 pε₀a in free space.

Reason (R): Δ x H = jωεE + J.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Machine cycle is always the same as instruction cycle.
TRUE
FALSE

⇒ If the intrinsic resistivity at 300°K is 0.37 ohm-m and the electron and hole mobilities at 300°K are 0.28 and 0.15 m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .
2.92 x 10¹⁹/m³
2.92 x 10^-19/m³
1.92 x 10¹⁹/m³
3.92 x 10¹⁹/m³

⇒ With negative feedback the closed loop gain is always less than open loop gain.
TRUE
FALSE

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒ The Gain margin for the system with open loop transfer functi
∞
0
1
-∞

⇒ Occasionally a discrete amplifier user RF chokes instead of collector resistors. Such amplifiers are inherently
low pass amplifiers
high pass amplifiers
band pass amplifiers
none of the above

⇒ Consider the following program segment written for 8085 based sys
CE
20
indeterminate
none of these

⇒

Assertion (A): The root locus of a control system is symmetrical about real axis.

Reason (R): For all polynomials with real coefficients, complex poles always occur in conjugate pairs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ When a line short circuited at far end, the minimum voltage occurs at
far end
source end
midway between source and far end
none of the above

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on

⇒ A capacitor can be represented by a capacitance and resistance in parallel. For a good capacitor, this parallel resistance should be
negligible
low
high
very high

⇒ In carbon resistor colour code, the third band is red. It indicates
two zeros
three zeros
multiplier is 0.01
multiplier is 0.1

⇒ A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is
1250
330
2500
8330

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?
2 kΩ
4 kΩ
8 kΩ
32 kΩ

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively