Question is ⇒ The "boundary sphere" between antenna region and free space region appears to "opaque", Options are ⇒ (A) along the dipole axis, (B) along perpendicular direction, (C) along the dipole axis as well as perpendicular direction, (D) neither along the dipole axis nor along the perpendicular direction, (E) , Leave your comments or Download question paper.

Question is ⇒ The "boundary sphere" between antenna region and free space region appears to "opaque", Options are ⇒ (A) along the dipole axis, (B) along perpendicular direction, (C) along the dipole axis as well as perpendicular direction, (D) neither along the dipole axis nor along the perpendicular direction, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The "boundary sphere" between antenna region and free space region appears to "opaque"
A.	along the dipole axis [Correct Answer]
B.	along perpendicular direction [Wrong Answer]
C.	along the dipole axis as well as perpendicular direction [Wrong Answer]
D.	neither along the dipole axis nor along the perpendicular direction [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ In given figure a silicon diode is carrying a constant current of 1 mA. When the temperature of the diode is 20°C, V_D is found to be 700 mV. If the temperature rises to 40°C, V_D becomes approximately equa
747 mV
660 mV
680 mV
700 mV

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the value of propagation constant P will be
15.9 radians/km
31.8 radians/km
63.6 radians/km
105.4 radians/km

⇒ The coil of a moving coil meter has 100 turns, is 40 mm long and 30 mm wide. The control torque is 240 x 10^-6 N-m on full scale. If B = 1 Wb/m², range of meter is
1 mA
2 mA
3 mA
4 mA

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ Which one of the following parameters does not exist for the two port network shown in the given fig
ABCD
y
h
z

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ In the given figure the phase angle of Fn is either 0 or &
TRUE
FALSE

⇒ At the peak of negative half cycle in fi
diode A is forward biased and diode B is reverse biased
both diodes are reverse biased
both diodes are forward biased
diode A is reverse biased and diode B is forward biased

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ Fourier transform of signal obtained after taking difference between step function and its reverse version is given as __________ .
2jω
2/jω
4/jω
4jω

⇒ For measuring mutual inductance we can use
Anderson bridge
Maxwell's bridge
Heaviside bridge
Either (a) or (b)

⇒ What is the result for expression (map metho
A + D + BC
A + D
A D + B C
A + D + BC

⇒ The phase velocity v in a transmission line is
LC
C/L
L/C
1/LC

⇒ In a coaxial line
the characteristic impedance is less than that of two wire line
the wave velocity is less than that of two wire line
both (a) and (b)
neither (a) nor (b)

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ A feedback amplifier has forward gains A₁, A₂ and feedback factor β as shown in signal flow graph of the given figure. Because of feedback as shown in signal noise ratio at output
increase
decrease
be unaffected
depend on value of β

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒ A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, V_D is found to be 0.3 V. If V_D = 0.4 V then forward current will be
400 mA
475 mA
477 mA
480 mA

⇒

Match the following:

	List I		List II
A.	Electro-encephalograph	1.	Diagnostic tool for heart ailment
B.	Electro-cardiograph	2.	Diagnostic tool for brain ailment
C.	Sphygmomanometer	3.	used for measuring BP
D.	Stethoscope	4.	used to heart pulse/ heart beat

A-2, B-1, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-1, C-4, D-3
A-1, B-2, C-3, D-4

⇒ Which of the following is used in automatic control of street lights?
Thermistor
Photoconductor
Transistor
Varistor

⇒

Match the following:

	List I		List II
A.	Anderson Bridge	1.	Low resistance
B.	Kelvin Bridge	2.	Medium resistance
C.	Schering Bridge	3.	Inductance
D.	Wheatstone Bridge	4.	Capacitance

A-4, B-2, C-3, D-1
A-3, B-2, C-4, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ A 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ then Resolution in percent and volt is __________ .
1%, 1 mv
10%, 10 mv
10%, 1 mv
1%, 10 mv

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ In applications where __________ input resistance is needed, the JFET is preferred to the bipolar transistor.
zero
very low
low
high

⇒ Value of Z_L for maximum power transfe
R
R + jωL
R - jωL
None of these

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is
sin^-1 ξ
cos^-1 ξ
tan^-1 ξ
cot^-1 ξ

⇒ For measuring inductance with high Q, we should use
Maxwell's bridge
Maxwell Wien bridge
Hay's bridge
Either (a) or (b)