Question is ⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by, Options are ⇒ (A) forward characteristics of thyristors, (B) reverse recovery characteristics of thyristors, (C) both forward and reverse recovery characteristics of thyristors, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by, Options are ⇒ (A) forward characteristics of thyristors, (B) reverse recovery characteristics of thyristors, (C) both forward and reverse recovery characteristics of thyristors, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
A.	forward characteristics of thyristors [Wrong Answer]
B.	reverse recovery characteristics of thyristors [Correct Answer]
C.	both forward and reverse recovery characteristics of thyristors [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In TE and TM modes of rectangular waveguides having propagation in z direction
E_z and H_z are both zero
In TE mode E_z is zero and in TM mode H_z is zero
In TE mode H_z is zero and in TM mode E_z is zero
In both TE and TM modes both E_z and H_z are non-zero

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ Wagner earthing device is used to eliminate error due to
electromagnetic coupling
electrostatic coupling
both electrostatic and electromagnetic coupling
either (a) or (b)

⇒

Match the following:

	List I (Application of circuit)		List II (Circuit Name)
A.	Divider	1.	Astable multivibrator
B.	Clips input voltage at two predetermined levels	2.	Schmitt trigger
C.	Square wave generator	3.	Bistable multivibrator
D.	Narrow current pulse generator

A-4, B-2, C-1, D-3
A-3, B-2, C-1, D-4
A-4, B-1, C-2, D-3
A-3, B-1, C-2, D-4

⇒ ALE stands for
Address Latch Enable
Accumulator Latch Enter
Address Latch Enter
Accumulator Latch Enable

⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other

⇒

Match the following:

	List I		List II
A.	CTFS	1.	Periodic
B.	DTFS	2.	Non-periodic
C.	CTFT
D.	DTFT

A-2, B-1, C-2, D-2
A-2, B-1, C-2, D-1
A-1, B-2, C-2, D-2
A-1, B-2, C-2, D-1

⇒ A photoconductor is a
conductor
semiconductor
insulator
superconductor

⇒ The value of susceptibility in case of vacuum is taken as
zero
0.5
unity
infinity

⇒ In a hi-fi system the frequency response over the audio frequency range should be within
± 10 dB
5 dB
2 dB
1 dB

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4

⇒ A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as
6000 bits/sec
4500 bits/sec
3000 bits/sec
1500 bits/sec

⇒ A voltage V(t) which is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt² is measured by a true rms meter. The reading will be
0
4
2
16

⇒ If resistance is 20 Ω and inductance is 2 H in a R-L series circuit, then time constant of this will be
0.001 s
0.1 s
10 s
100 s

⇒

Match the following:

	List I		List II
A.	DMA controller	1.	Interface between computer and video display adapter
B.	CKT controller	2.	Used to read data directly from disk into directly memory
C.	Interrupt controller	3.	Supervises the operation of control signal

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-2, B-1, C-3

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ In figure, the time constant for the capacitor chargin
6 μs
10 μs
15 μs
25 μs

⇒ Which of the following has highest resistivity?
Mica
Paraffin wax
Air
Mineral oil

⇒

Assertion (A): Nyquist stability criterion uses the number of encirclements around (-1 + j0) point in GH plane to determine stability

Reason (R): The (-1 + j0) point in the s plane lies in the Nyquist path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of the following bridges is also used in an oscillator?
Maxwell
Schering
Hay
Wien

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒ A binary ladder network D/A converter requires
resistors of one value only
resistors of many different values
resistors of two different values
none of the above

⇒ Entropies associated with an extremely unlikely message and that with an extremely likely message are respectively
0 and 0
1 and 1
1 and 0
0 and 1

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒

Assertion (A): In Fortran 77 the statement IMPLICIT INTEGER (A - E) identifies all variable name which begin with A, B, C, D, or E as being of integer type.

Reason (R): IMPICIT statement in Fortran 77 is an improvement over earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒ An antenna is considered to be in free space where its height above the ground is
λ
2λ
less than 3λ
more than 5λ

⇒ The hexadecimal number system is
widely used in analyzing and programming microprocessors
an obsolete system no more in use
used in calculators only
none of the above