Question is ⇒ If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get, Options are ⇒ (A) zero power, (B) ∞ power, (C) depend upon input signal strength, (D) depend on frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get, Options are ⇒ (A) zero power, (B) ∞ power, (C) depend upon input signal strength, (D) depend on frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a electromagnetic signal is incident at 0° in a waveguide then at other port of waveguide we will get
A.	zero power [Correct Answer]
B.	∞ power [Wrong Answer]
C.	depend upon input signal strength [Wrong Answer]
D.	depend on frequency [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above

⇒ Which inverter circuit uses coupled inductors?
Modified McMurray full bridge inverter
McMurray Bedford half bridge inverter
Modified McMurray Bedford half bridge inverter
Both (b) and (c)

⇒ Silicon diodes have __________ reverse resistance than germanium diodes.
a much smaller
a much larger
an infinite
a negligible

⇒ An ac voltage 20 sin 1000t feeds an R-C series circuit. R = 8 Ω and active power is 4 W. The power factor is
1
0.8
0.6
0.4

⇒ In a rare gas, the molecules of some atoms have an excess positive or negative charge. The electric field tends to shift positive ions relative to negative ions. This is known as ionic polarization.
TRUE
FALSE

⇒ The factor η for a UJT is about
0.1
0.2
0.6
0.9

⇒

Assertion (A): Industrial robots improve productivity.

Reason (R): Robots can handle monotonous and complex jobs without error in operation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): In some materials, ∈_r is independent of temperature while in others, ∈_r depends on temperature.

Reason (R): If permanent dipoles are absent, ∈_r varies with temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The slope of log magnitude asymptote changes by - 40 dB/ decade at a certain frequency and the error between asymptote and actual curve is - 6 dB. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
either a pole or zero at that frequency is present

⇒ In the balanced bridge shown in figure. X should
a self inductance having resistance
a capacitance
a non-inductive resistance
an inductance and capacitance in parallel

⇒ Which of the following devices exhibit negative resistance characteristics?
UJT
PUT
Both UJT and PUT
UJT, PUT and SBS

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ The resolution of a DAC depends on which of the following?
The number of bits
Monotonicity
Reference voltage
The values of resistance

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒

Assertion (A): The hybrid p model of a transistor can be reduced to h parameter model and vice versa.

Reason (R): Hybrid p and h parameter models are interrelated as both of them describe the same device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one of the following gain equations is correct for a MOSFET common-source amplif
A_V = g_m/(1 - R_D)
A_V = g_m/R_D
A_V = g_m/(1 + R_D)
A_V = R_D/g_m

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ AE 139 is a
tunnel diode
germanium power transistor
photoconductive cell
silicon diode

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ A transducer must have
good dynamic response
good sensitivity
good resolution
all of the above

⇒ How many cascaded stage of CE amplifiers will result in polarity inversion of the input signal?
Two
Three
Four
None

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ Consider an arbitrary distribution of conducting bodies in a charge free space according to the uniqueness theorem, which of following are required to be specified in order that the field is uniquely determined everywhere?

Total charge on each conductor
Potential at each conductor surface
Potential at same of conductor and total charge on the remainder
Total charge as well as potential gradient on each conductor surface

Select the correct answer using the codes given below codes
1 and 3
2 and 4
1, 2, and 3
1, 2, 3, 4

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The maximum power that can be transferred to the load is resistor R_L from the voltage source in the figur
1 W
10 W
0.25 W
0.5 W

⇒ In figure, the curre
is 2 A from A to B
is 2 A from B to A
depends on the value of R
none of the above

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒ In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be
0.0125 μF
0.0311 μF
0.0521 μF
0.0622 μF

⇒ If the atomic number of germanium is 32, the number of electrons in the outer most shell will be
2
3
4
6