Question is ⇒ For an amplifier, the coupling method which gives the highest gain in, Options are ⇒ (A) impedance coupling, (B) transformer coupling, (C) capacitance coupling, (D) resistance coupling, (E) , Leave your comments or Download question paper.

Question is ⇒ For an amplifier, the coupling method which gives the highest gain in, Options are ⇒ (A) impedance coupling, (B) transformer coupling, (C) capacitance coupling, (D) resistance coupling, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an amplifier, the coupling method which gives the highest gain in
A.	impedance coupling [Wrong Answer]
B.	transformer coupling [Correct Answer]
C.	capacitance coupling [Wrong Answer]
D.	resistance coupling [Wrong Answer]
View Answer 15 -10 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The access time of a word in 4 MB main memory is 100 ms. The access time of a word in a 32 kb data cache memory is 10 ns. The average data cache bit ratio is 0.95. The efficiency of memory access time is
9.5 ns
14.5 ns
20 ns
95 ns

⇒ Access time of a storage is the time required
to write one word into the memory
to read one word from the memory
to write one word into and to read one word from the memory
either to write one word or to read one word

⇒ A multiple emitter transistor has many emitters and collectors.
TRUE
FALSE

⇒ For the wave shown in figure, the average valu
14.14 A
15 A
17.17 A
19.19 A

⇒ If V_in is 0.99 V, what is the digital output of the ADC 0801 after INTER goes low?
0011 0011
0101 1111
0111 1100
1111 1111

⇒ Two coils are connected in parallel. Their fluxes are adding. If the connections of one of the coils are reversed, the total inductance of the arrangement
will decrease
may increase or decrease
will remain the same
will increase

⇒ The function Y = AC + BD + EF is
POS
SOP
Hybrid
none of the above

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ In a CE amplifier connection, the emitter is at ground potential for
AC quantities
DC quantities
all quantities
none of the quantities

⇒

Assertion (A): In n-p-n transistor conduction is mainly due to electrons.

Reason (R): In n type materials electrons are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this mod
Two times its band rate
Four times its band rate
Same as band rate
Sufficient information is not given to give the answer

⇒ The dc voltage on plate modulated class C amplifier is 8 kV. If the peak modulating voltage is 4 kV, the peak RF voltage delivered to load is
32 kV
12 kV
0.5 kV
24 kV

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒ In terrestrial microwave links, the number of 'fades' per unit increases as
both the transmission and the distance between the antennas are increased
the transmission frequency is increased but the distance between the antennas is decreased
the transmission frequency is decreased but the distance between the antennas is increased
both the transmission frequency and distance between the antennas are decreased

⇒ In a backward wave oscillator the efficiency
is much higher than in TWT
is much lower than in TWT
is almost the same as in TWT
either (a) or (b)

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ The temperature coefficient of resistance for a thermistor is
low and negative
low and positive
high and negative
high and positive

⇒ Which of the following instruments is used almost exclusively to measure radio frequency currents?
Moving coil
Rectifier
Moving iron
Thermocouple

⇒ PA radar means
Phased Array radar
Pulsed Array radar
Pulse Amplitude radar
None of the above

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will
decrease to finite non-zero value
remain the same
increase
decrease to zero

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ Which of the following is Doppler effect not used?
CW radar
FM radar
MTI system
Moving target plotting on PPI

⇒ In the following limiter circuit, an input voltage V₁ = 10 sin 100pt applied. Assume that the diode drop is 0.7 V when it is forward biased. The zener breakdown voltage is 6
6.1 V, -0.7 V
0.7 V, -7.5 V
7.5 V, -0.7 V
7.5 V, -7.5 V

⇒ When an electric field E is applied to solid and liquid insulating materials, the internal field E_i acting at the location of atom is such that
E_i = E
E_i > E
E_i < E
E_i may be equal to or less than E

⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8

⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers
WESTAT
INSAT-IC
ARABSAT
INSAT-ID

⇒ Which of the following is not a transducer in true sense?
Thermocouple
Piezo electric
Photo electric cell
LCD

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒ The transfer function G₁₂ (s) for a two port is
V₂/V₁
V₂ (s)/V₁ (s)
V₂ (s)/I₁ (s)
I₂ (s)/I₁ (s)