Question is ⇒ Most of the amplification of the received signal is obtained in a superheterodyne receiver from the, Options are ⇒ (A) IF stage, (B) RF stage, (C) power amplification stage, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Most of the amplification of the received signal is obtained in a superheterodyne receiver from the, Options are ⇒ (A) IF stage, (B) RF stage, (C) power amplification stage, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
A.	IF stage [Correct Answer]
B.	RF stage [Wrong Answer]
C.	power amplification stage [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Short-circuited stubs are preferred to open circuited stubs because the latter are
more difficult to make and connect
incapable of giving a full range of reactances
made of transmission line with a different characteristic impedance
liable to radiate

⇒ The conductivity of intrinsic semiconductor is given by
en_i(μ_p - μ_n)
en_i(μ_p + μ_n)
n_i(μ_p + μ_n)
n_i(μ_pμ_n)

⇒ Two capacitors of 1 μF and 2 μF are connected in series across a 10 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
10 μC each
20 μC each
10 μC and 20 μC
20 μC and 10 μC

⇒ FM broadcast lies in which band?
HF
SHF
UHF
VHF

⇒ In a positive edge triggered JK flip flop, J = 1, K = 0 and clock pulse is rising Q will
be 0
be 1
show no change
toggle

⇒ In the circuit shown in figure the current I of sinusoidal sourc
25 A
0.166666666666667
20 A
Not determinable from given data

⇒ Dielectric constant of transformer oil is about
1
4
10
20

⇒ A microwave link uses only line-of-sight propagation.
TRUE
FALSE

⇒ Bandwidth of an antenna is related with where Q is quality factor
Q ∝ B
Q ∝ 1/B
Q ∝ B²
Q ∝ 1/B²

⇒ If we connect two silicon unilateral switches in anti- parallel we get
SCR
SBS
SCS
UJT

⇒ Which instrument is based on induction principle?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

⇒ In 8085
RST 6.5 and RST 5.5 are high level sensitive interrupts
RST 6.5 and RST 5.5 are low level sensitive interrupts
RST 5.5 is low level sensitive interrupt but RST 5.5 is high level-sensitive interrupt
RST 5.5 is low level sensitive interrupt but RST 6.5 is high level sensitive interrupt

⇒ A memoryless source emits n symbols each with a probability p. The entropy of the source as a function of n
increases as log n
decreases as log (1/n)
increases as n
increases as n log n

⇒ In the given figure the E and H lines in a coaxial c
The radial lines are E lines and circular lines are H lines
Radial lines are H lines and circular lines are E lines
The directions of E and H lines are wrong
Radial lines may be E and H lines depending an direction of current

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ The factor n in the equation for calculating current for a silicon diode is
1
2
2.5
2 for low levels of current and 1 for high levels of current

⇒ The correct form of expression B³ -2 A C in FORTRAN 77 is
B * * 3 - 2 * A * C
B * 3 - 2 * A AC
B * * 3 - 2 ** A * C
B *** 3 - 2 * A * C

⇒ Figure shows a Wheatstone bridge with RTD to one arm. If resistance of RTD = 1020 Ω, the voltage V₀
49 mV
51 mV
48 mV
45 mV

⇒ A dynamic RAM cell which holds 5 V has to be refreshed every 20 ms so that the stored voltage does not fall by more than 0.5 V. If the cell has a constant discharge current of 0.1 pA, the storage capacitance of cell is
4 x 10^-6 F
4 x 10^-9 F
4 x 10^-12 F
4 x 10^-15 F

⇒ The main difference between the broadside arrays and end fire arrays is that
individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays
in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively
the total number of elements in broadside array is always one and a half times that of elements in end fire arrays
in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ Foster Seeley discriminator uses a
double tuned circuit in which primary and secondary are tuned to different frequencies
double tuned circuit in which primary and secondary are tuned to same frequencies
single tuned circuit
three triodes in series

⇒ In ionic bonding, the valence electron is donated by one atom and accepted by the other atom.
TRUE
FALSE

⇒ RESET OUT signal when high indicates that
program counter etc. are being set
program counter etc. are being reset
either (a) or (b)
none of the above

⇒ Which of the following is the poorest conductor of electricity?
Aluminium
Nichrome
Copper
All of the above

⇒ A cut set schedule shows
incidence of branches to loops
incidence of branches to nodes
incidence of nodes to loops
none of the above

⇒ In 8085 microprocessor the value of the most significant bit of the result following the execution of any arithmetic or Boolean instruction is stored in
the carry status flag
the auxiliary carry status flag
sign status flag
zero status flag

⇒ What will be conversion rate for a counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
125
125 x 10³
125 x 10⁶
None

⇒ The response to sinusoidal excitation can be found by
setting s = jω in the network function
setting s = -jω in the network function
taking inverse transform of network function
none of the above

⇒ When a material becomes a superconductor, its resistivity becomes
very small
zero
about 10% of normal value
about 20% of normal value

⇒ 'Rotate instruction' in microprocessor belongs to
data transfer group
arithmetic group
logic group
branch group