Question is ⇒ The rotor of a 3-phase induction motor rotates in the same direction as that of stator rotating field. This can be explained by, Options are ⇒ (A) Faraday's laws of electromagnetic induction., (B) Lenz's law., (C) Newton's laws of motion, (D) Fleming's right hand rule, (E) , Leave your comments or Download question paper.

Question is ⇒ The rotor of a 3-phase induction motor rotates in the same direction as that of stator rotating field. This can be explained by, Options are ⇒ (A) Faraday's laws of electromagnetic induction., (B) Lenz's law., (C) Newton's laws of motion, (D) Fleming's right hand rule, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The rotor of a 3-phase induction motor rotates in the same direction as that of stator rotating field. This can be explained by
A.	Faraday's laws of electromagnetic induction. [Wrong Answer]
B.	Lenz's law. [Correct Answer]
C.	Newton's laws of motion [Wrong Answer]
D.	Fleming's right hand rule [Wrong Answer]
View Answer 7 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A single-phase, 2,000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms respectively. The voltage regulationofthe alternatorat 100A load at 0.8 leadingpower-factor is
0.07
-0.089
0.14
0

⇒ The phenomenon of crawling in a 3-phase induction motor may be due to
unbalanced supply voltage.
7th space harmonics of air-gap field.
7th time harmonics of voltage wave.
5th space harmonics.

⇒ It is advisable to use auto-transformer if the transformation ratio is
greater than 1
near to 1
0.25
0.5

⇒ A dc shunt motor, running lightly at 1,000rpm, is operated under plugging. With plugging connections left as it is the final speed of the motor will be
zero.
1,000 rpm.
-1,000 rpm
-2,000 rpm.

⇒ Consider the following stetements
For a uniform plane electromagnetic wave
1. The direction of energy flow is the same as the direction of propagation of the wave.
2. Electric and magnetic fields are in time quadrature.
3. Electric and magnetic fields are in space quadrature
2 alone is correct.
1 and 2 are correct
1 and 3 are correct.
3 alone is correct

⇒ Drop in terminal voltage of an alternator due to armature reaction is countered by
damper winding.
effect of saliency.
increased prime mover output.
automatic voltage regulator.

⇒ A 3-phase synchronous motor provided with damper winding is started as a 3-phase
synchronous motor.
synchronous alternator.
induction motor.
induction generator

⇒ The voltage regulation of a dc generator at full load being zero implies that the generator is
shunt-connected.
differentially compounded.
cumulatively compounded.
series-connected

⇒ Slip-ring motors have the disadvantages of
low efficiency and low power factor in comparison to squirrel cage induction motors.
low power factor at light load.
sensitivity to fluctuations in supply voltage
all of the above.

⇒ A self excited dc shunt generator driven by its prime mover at the rated speed fails to build up voltage across its terminals at no load. What reason can be assigned for this?
The field circuit resistance is higher than the critical resistance.
The initial shunt field mmf does not assist the residual magnetism.
One of the interpole connection is reversed.
The brush-axis shifts slightly from the geometrical neutral axis of the machine.

⇒ The size of the transformer core depends upon
frequency.
permissible flux density in the core material.
area of the core.
both (a) and (b).

⇒ Armature of a dc machine is made of
conducting material.
insulating material
non-ferrous material.
silicon steel,

⇒ A P-pole lap wound dc machine had an armature current I_a. The conductor current in the armature winding is
I_a
I_a/P
PI_a
none of above

⇒ In a dc machine, the sparking between brushes and commutator surface may be due to
under commutation
over commutation.
too rapid reversal of current
any of the above

⇒ Unit of electric intensity is
joules/coulomb.
newton/coulomb.
volt/meter.
both (b) and (c).

⇒ Supply to one terminal of a delta-wye connected three phase core type transformer which is on no load fails. Assuming magnetic circuit symmetry, voltages on the secondary side will be
230, 230, 115
230, 115, 115
345, 115, 115
345, 0, 345

⇒ A dc series motor driving an electric train faces a constant power load. lt is running at rated speed and rated voltage. If the speed has to be brouiht down to 0.25. the supply voltage has to he approximately brought down to
0.75 pu
0.5 pu
0.25 pu
0.125 pu

⇒ A 20 kVA. 2000/200 V. I-phase transformer has name plate leakage impedance of 8%. Voltage required to be applied on the high-voltage side to circulate full-load current with the low-voltage winding short-circuited will be
16 V
56.66 V
160 V
568.68 V

⇒ What is the core loss in a high frequency ferrite core transformer used in SMPS power supply?
10% of rated power.
5% of rated power.
2% of rated power.
1% of rated power.

⇒ Flywheel is employed with a dc compound motor to reduce peak demand, The compound motor should be
level compound.
differential compound
cumulative compound.
none of these.

⇒ During rheostatic braking the braking torque is proportional to
speed.
1/speed
(speed)²

⇒ In a dc machine armature winding, the number of commutator segments is equal to the number of armature
coils.
coil sides.
conductors.
turns.

⇒ A 220 V dc machine supplies 20 A at 200 V as generator. The armature resistance is 0.2Ω . If the machine is now operated as a motor at the same terminal voltage and current but with the flux increased by 10% the ratio of motor speed to generator speed is
0.87.
0.95.
0.96.
1.06.

⇒ Thermocouple is based on
Seebeck effect.
Thomson.
Joule's.
None of these

⇒ An ideal dc generator has a regulation of____per cent.
zero
10
25
100

⇒ Two transformers of identical voltages but of different capacities are operating in parallel. For satisfactory load sharing
impedances must be equal.
per unit impedances must be equal.
per unit impedances and X/R ratio must be equal
impedances and X!R ratio must be equal.

⇒ A dual voltage single phase ac motor can he operated on either
230 or 400 V.
30 or 400 V
115 or 230 V.
160 or 320V

⇒ ____ depends upon loading in a mercury arc rectifier.
Anode drop
Cathode drop.
Drop in arc itself
Both anode and cathode drops

⇒ A high Q coil has
large bandwidth.
high losses.
low losses.
flat response.

⇒ A 3-phase. 480 V, 60 Hz induction motor is to be operated at 50 Hz supply. The most satisfactory supply voltage for the machine would be
480 V
400 V
600 V
440 V