Question is ⇒ Sparking occurs when a load is switched off because the circuit has high, Options are ⇒ (A) resistance, (B) inductance, (C) capacitance, (D) impedance, (E) , Leave your comments or Download question paper.

Question is ⇒ Sparking occurs when a load is switched off because the circuit has high, Options are ⇒ (A) resistance, (B) inductance, (C) capacitance, (D) impedance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Sparking occurs when a load is switched off because the circuit has high
A.	resistance [Wrong Answer]
B.	inductance [Correct Answer]
C.	capacitance [Wrong Answer]
D.	impedance [Wrong Answer]
View Answer 13 -11 Explanation:- Answer : B Discuss it below : Sreeju s Said on 2019-05-26 11:15:42 the maximum connected load permissible to a three phase LT Consumer is !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ All good conductors have high
conductance
resistance
reluctance
thermal conductivity

⇒ For testing appliances, the wattage of test lamp should be
very low
low
high
any value

⇒ In the case of direct current
magnitude and direction of current remains constant
magnitude and direction of current changes with time
magnitude of current changes with time
magnitude of current remains constant

⇒ If a very flexible wire is laid out in the shape of a hair pin with its two ends secured, what shape will the wire tend to assume if a current is passed through it?
Parabolic.
Straight line.
Circle.
Ellipse.

⇒ When electric current passes through a bucket full of water, lot of bubbling is observed. This suggests that the type of supply is
A.C.
D.C.
any of above two
none of the above

⇒ A steady current flows in a metallic conductor of non-uniform cross-section. Out of the following physical quantities, the one which remains constant is
Current
Current-density
Drift speed
Electric field

⇒ Which ofthe following lamps will have least resistance at room temperature?
25 W, 220V
100 W, 220V
200W, 220 V
60W, 220 V

⇒ The electric current in a liquid is due to the flow of
Electrons only
Positive ions only
Negative and positive ions both
Electrons and positive ions both

⇒ When resistance element of a heater fuses and then we reconnect it after removing a portion of it, the power of the heater will
decrease
increase
remain constant
none of the above

⇒ When electric current passes through a metallic conductor, its temperature rises. This is due to
collisions between conduction electrons and atoms
the release of conduction electrons from parent atoms
mutual collisions between metal atoms
mutual collisions between conducting electrons

⇒ An instrument which detects electric current is known as
voltmeter
rheostat
wattmeter
galvanometer

⇒ Electric pressure is also called
resistance
power
voltage
energy

⇒ As the temperature of hot junction increases, the thermo emf :
Always increases
Always decreases
May increase or decrease
Neither increase nor decrease

⇒ The Thomson coefficient for lead is
Less than zero
Zero
More than zero but less than 1
More than 1

⇒ Seebeck effect is inverse of
Peltier effect
Joule's effect
Thomson's effect
None of these

⇒ The draft velocity of electrons is
larger than speed of light.
almost equal to speed of light
equal to speed of light.
very small in comparison to speed of light.

⇒ The thickness of insulation provided on the conductor depends on
the magnitude of voltage on the conductor
the magnitude of current flowing through it
both (a) and (b)
none of the above

⇒ How may 200 W/220 V incandescent lamps connected in series would consume the same total power as a single 100 W/220 V incandescent lamp?
not possible.
4
3
2

⇒ A 500 W, 220 V bulb is supplied with 110V. Power consumption by the bulb will be
slightly less than 125 W
slightly greater than 125 W
exactly 125 W
250 W

⇒ In gases the flow of current is due to
electrons only
positive ions only
electrons and positive ions
electrons, positive ions and negative ions

⇒ The flow of electric current in a conductor is due to flow of
electrons.
protons.
electrons and ions.
charged particles.

⇒ According to the fuse law, the current carrying capacity varies as
1/(diameter)²
1/diameter
diameter
(diameter)^3/2

⇒ Resistance of a tungsten lamp____ as applied voltage increases
decreases
increases
remains same
none of the above

⇒ An isolated conducting sphere is given a positive charge. Its mass
Increases
Decreases
Remain the same
Mass is not involved

⇒ Which of the following is not reversible ?
Seebeck effect
Peltier effect
Joule's effect
Thomson's effect

⇒ An electron charge (e) is revolving in a circular orbit of radius r round a nucleus of charge Ze with speed y. The equivalent current is
Zero
ev/2πr
Zev/2πr
e.2πr/v

⇒ Three conductances in parallel have the values G1 = 2000 µ mho, G2 = 3000 µ mho and Gs = 4000 µ mho. The total conductance will be
6000 µ mho
7000 µ mho
9000 µ mho
10000 µ mho

⇒ While using electricity and paying the electric bills one pay for
Electric charge
Electric power
Electric energy
Electric current

⇒ A region surrounding a stationary electric dipole has
Magnetic field only
Electric field only
Both electric and magnetic fields
No electric and magnetic fields

⇒ Which of the following statement is correct?
A semi-conductor is a material whose conductivity is same as between that of a conductor and an insulator
A semi-conductor is a material which has conductivity having average value of conductivity of metal and insulator
A semi-conductor is one which conducts only half of the applied voltage
A semi-conductor is a material made of alternate layers of conducting material and insulator