Question is ⇒ Ohm's law is applicable to, Options are ⇒ (A) semiconductors & vacuum tubes., (B) electrolytes & carbon resistors., (C) arc lamps., (D) none of these., (E) , Leave your comments or Download question paper.

Question is ⇒ Ohm's law is applicable to, Options are ⇒ (A) semiconductors & vacuum tubes., (B) electrolytes & carbon resistors., (C) arc lamps., (D) none of these., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Ohm's law is applicable to
A.	semiconductors & vacuum tubes. [Wrong Answer]
B.	electrolytes & carbon resistors. [Wrong Answer]
C.	arc lamps. [Wrong Answer]
D.	none of these. [Correct Answer]
View Answer 34 -24 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following could be th value of resistivity of copper?
1.72 x 10^-4 ω-m
1.72 x 10^-5 ω-m
1.72 x 10^-6 ω-m
1.72 x 10^-7 ω-m

⇒ The resistance of human body is around
5 ohms
25 ohms
250 ohms
1000 ohms

⇒ The equivalent resistance in series combination is
Smaller than the largest resistance
Larger than the largest resistance
Smaller than the smaller resistance
Larger than the smallest resistance

⇒ Which of the following is not reversible ?
Seebeck effect
Peltier effect
Joule's effect
Thomson's effect

⇒ Three identical resistors are first connected in parallel and then in series. The resultant resistance of the first combination to the second will be
9 times
1/9 times
1/3 times
3 times

⇒ The electric current in a liquid is due to the flow of
Electrons only
Positive ions only
Negative and positive ions both
Electrons and positive ions both

⇒ For a fixed supply voltage the current flowing through a conductor will increase when its
area of x-section is reduced.
length is reduced.
length is increased.
length is increased and x-sectional area is reduced.

⇒ Which of the following does not use heating effect of electric current?
Electric furnace & Electric oven.
Electric iron.
Vacuum cleaner
Immersion heater.

⇒ Seebeck effect is inverse of
Peltier effect
Joule's effect
Thomson's effect
None of these

⇒ If the efficiency of a machine is to be high, what should be low?
Input power
Losses
True component of power
kWh consumed

⇒ Ohm's law in point form in field theory can be expressed as
V = RI
J = ^E/_σ
J = σE
R = ρ^l/_A

⇒ A 200 W, 230 V lamp is connected across 115 V supply. The lamp will draw power
slightly more than 50W.
slightly less than 50W.
exactly 100 W.
exactly 50W.

⇒ What is the name of graph between temperature and thermo emf. ?
Hyperbola
Parabola
Straight line
None of these

⇒ Out of the following which is not a poor conductor?
Cast iron
Copper
Carbon
Tungsten

⇒ The draft velocity of electrons is
larger than speed of light.
almost equal to speed of light
equal to speed of light.
very small in comparison to speed of light.

⇒ When current flows through heater coil it glows butsupply wiring does not glow because
current through supply line flows at slower speed
supply wiring is covered with insulation layer
resistance of heater coil is more than the supply wires
supply wires are made of superior material

⇒ When subjected to a transverse electric field, cathode rays move
Down the potential gradient
Up the potential gradient
Along a hyperbolic path
Along a circular path

⇒ Ohm's law is not applicable to
vacuum tubes
carbon resistors
high voltage circuits
circuits with low current densities

⇒ A field of force can exist only between
two molecules
two ions
two atoms
two metal particles

⇒ The minimum requirements for causing flow of current are
a voltage source, a resistor and a switch.
a voltage source and a conductor.
a power source and a bulb.
a voltage source, a conductor, an ammeter and a switch.

⇒ A steady current flows in a metallic conductor of non-uniform cross-section. Out of the following physical quantities, the one which remains constant is
Current
Current-density
Drift speed
Electric field

⇒ The electrical conductivity of metals is typically df the order of (in ohm^-1 m^-1)
10⁷
10⁵
10^-4
10^-6

⇒ Two heaters, rated at 1000 W, 250 V each are connected in series across a 250 V, 50 Hz ac mains. The total power drawn from the supply would be____ W.
1,000
500
250
2,000

⇒ Electric pressure is also called
resistance
power
voltage
energy

⇒ How may 200 W/220 V incandescent lamps connected in series would consume the same total power as a single 100 W/220 V incandescent lamp?
not possible.
4
3
2

⇒ One coulomb charge equals the charge on
6.24 x 10¹² electrons
6.24 x 10⁴ electrons
6.24 x 10¹⁶ electrons
6.24 x 10¹⁸ electrons

⇒ Through a metallic conductor an electric current is due to drift of
Free electrons
Positive and negative ions
Free electrons and holes
Protons

⇒ The flow of current in solids is due to
electrons
electrons and ions
atoms
nucleus

⇒ Which method can be used for absolute measurement of resistances?
Lorentz method
Releigh method
Ohm's law method
Wheatstone bridge method

⇒ A region surrounding a stationary electric dipole has
Magnetic field only
Electric field only
Both electric and magnetic fields
No electric and magnetic fields