Question is ⇒ Y signal has maximum percentage of, Options are ⇒ (A) red colour, (B) blue colour, (C) green colour, (D) red and blue colours, (E) , Leave your comments or Download question paper.

Question is ⇒ Y signal has maximum percentage of, Options are ⇒ (A) red colour, (B) blue colour, (C) green colour, (D) red and blue colours, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Y signal has maximum percentage of
A.	red colour [Wrong Answer]
B.	blue colour [Wrong Answer]
C.	green colour [Correct Answer]
D.	red and blue colours [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The total number of fundamental products of three variables is
3
5
8
16

⇒

Assertion (A): The h-parameter model of a BJT can be derived from its hybrid-p model and vice-versa.

Reason (R): The hybrid-p model has many more additional elements as compared to h-parameter model of the BJT.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The intrinsic impedance of free space
increases with increase of frequency
decreases with increase of frequency
is independent of frequency
none

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively

⇒ 5 skilled workers can build a wall in 20 days; 8 semi-skilled worker can build a wall in 25days; 10 unskilled workers can build a wall in 30 days, If a team has 2 killed, 6 semi-skilled and 5 unskilled workers, how long will it take to build the wall?
20 days
18 days
16 days
15 days

⇒ Which of the following can be used as a tachogenerator in control systems?
Microsyn
DC servomotor
AC servomotor
Magnetic amplifier

⇒ A characteristic property of crystal is its periodicity of structure.
TRUE
FALSE

⇒ Assuming V_{CE sat} = 0.2 V and β = 50, the minimum base current (I_B) required to drive the transistor in the given figure to saturatio
56 μA
140 μA
60 μA
3 μA

⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
5 ∠19° A
10 ∠19° A
10 ∠38° A
10 ∠9.5° A

⇒ The filter circuit for feeding tweeter has
an inductance in series and a capacitance in parallel
a capacitance in series and an inductance in parallel
a resistance in series and a capacitance in parallel
a capacitance in series and a resistance in parallel

⇒ The addition of a zero to the open loop transfer function
pulls the root locus to the left and makes the system more stable
pulls the root locus to the right and makes the system less stable
either (a) or (b)
neither (a) nor (b)

⇒ A transmission line terminates in two branches, each of length λ/4, as shown. The branches are terminated by 50Ω loads. The lines are lossless and have the characteristics impedances shown. Determine the impedance Z₁ as seen by the so
200Ω
100Ω
50Ω
25Ω

⇒ In directional coupler of the given figure, the terms |S₁₄| and |S₂₃| of scattering matrix are ne
1 each
0.5 each
0.1 each
1 and 0.5 respectively

⇒ A 2 bit binary multiplier can be implemented using
2 inputs ANDs only
2 inputs XORs and 4 input AND gates only
Two 2 inputs NORs and one XNOR gate
XOR gates and shift registers

⇒ In computers the size of secondary memory is usually much larger than that of primary memory.
TRUE
FALSE

⇒ For matching over a range of frequencies in a transmission line it is best to use
a balun
a broad band directional coupler
double stub
a single stub of adjustable position

⇒ Microwave resonators are used in
microwave oscillators
microwave narrow band amplifier
microwave frequency metres
all of the above

⇒ The disturbance from adjacent telephone line is known as
cross fire
cross talk
inductive disturbance
none of the above

⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
f times/sec
0.5 f times/sec
0.25 f times/sec
2 f times/sec

⇒

Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In position control system the device used for providing rate feedback voltage is
potentiometer
synchro-transmitter
synchro-transformer
tacho generator

⇒ The phase difference (jω - p₁ )
phasor directed from p₁ to jω
phasor directed from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒ In figure, the switch S is initially open and steady state conditions are reached. At t = 0 switch is closed. The initial current through 2C capacito
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ Which memory is available in all technologies?
PROM
EEPROM
ROM
EPROM

⇒ Available multiplexer IC package can have a maximum of 8 inputs.
TRUE
FALSE

⇒ In a superheterodyne radio receiver
RF amplifier normally operates at 455 kHz above carrier frequency
mixer input must be tuned to the signal frequency
local oscillator operates below signal frequency
local oscillator frequency is double the IF

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ For the high-pass circuit to act as a differentiator, the time constant must be
small
very small in comparison to the time period of the input signal
very high in comparison to the time period of the input signal (that is low pass circuit)
moderate value

⇒ An I/O processor controls the flow of information between
cache memory and I/O devices
main memory and I/O devices
two I/O devices
cache and main memory