Question is ⇒ Y = A + A B is the same as, Options are ⇒ (A) Y = AB, (B) Y = A + B, (C) Y = A + B, (D) Y = A + B, (E) , Leave your comments or Download question paper.

Question is ⇒ Y = A + A B is the same as, Options are ⇒ (A) Y = AB, (B) Y = A + B, (C) Y = A + B, (D) Y = A + B, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Y = A + A B is the same as
A.	Y = AB [Wrong Answer]
B.	Y = A + B [Correct Answer]
C.	Y = A + B [Wrong Answer]
D.	Y = A + B [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ CE mode input V-I characteristic can be shown by a plot of
V_BE versus i_B for constant values of V_CE
V_CB versus i_C for constant values of I_E
V_CE versus i_E for constant values of V_EB
V_CE versus i_E for constant values of V_CE

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A function is given f(t) = sin²t + cos²t. Which of the following is true?
f has frequency components at 0 and 1/2p Hz
f has frequency components at 0 and 1/p Hz
f has frequency components at 1/2p and 1/p Hz
f has frequency components at 0, l/2p and 1/p Hz

⇒ In a N-P-N transistor the function of the emitter is
to emit or inject holes into the collector
to emit or inject electrons into the collector
to emit or inject electrons into the base
to emit or inject holes into the base

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ Which of the antenna is best excited by a waveguide?
Horn
Discone
Helical
Biconical

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ For the K map of the given figure the simplified Boolean expressio
ACD + ABD + BCD
ACD + BCD
ACD + ABD
none of the above

⇒ In elemental dielectrics, the orientation and ionic polarization are absent.
TRUE
FALSE

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage

⇒ A resistor R of 1 Ω and two inductor L₁ and L₂ of inductances 1 H and 2 H respectively, are connected in parallel. At some time, the current through L₁ and L₂ are 1 A and 2 A, respectively. The current through R at time t = ∞ will be
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ In a reflex klystron oscillator, repeller electrode is at
low positive potential
high positive potential
negative potential
zero potential

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ A dielectric should have poor heat conductivity.
TRUE
FALSE

⇒ It is best to use for coupling a coaxial line to a parallel wire transmission line.
directional Coupler
balun
slotted line
tee

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ The op-amp circuit shown in the figure is a filter. The type of filter and its cut off type of filter and its cut off frequency are respectiv
high Pass, 1000 rad/sec
low Pass, 100 rad/sec
high Pass, 10000 rad/sec
low pass, 10000 rad/sec

⇒ In the circuit of figure, Thevenin's resistance is 10 &
25 Ω
10 Ω
13.33 Ω
6 Ω

⇒ In a CE amplifier the Q point is very close to cutoff point on the load line. This results in
saturation clipping
cut off clipping
both saturation and cut off clipping
either saturation clipping or cut off clipping

⇒ For a transmission line open circuit and short circuit impedances are 20 Ω and 5 Ω. Then characteristic impedance is
100 Ω
50 Ω
25 Ω
10 Ω

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is
40 A
20 A
0.416666666666667
0.208333333333333

⇒ In a 3 phase system, the zero sequence component of line to line voltages is zero
if line to line voltages are balanced
if line to line voltages are unbalanced
if line to line voltages are balanced or unbalanced
if degree of unbalanced in line to line voltages is small

⇒ The circuit I in figur
1 mA
4 mA
8 mA
10 mA

⇒ For F₂ layer the critical frequency is about
500 MHz
100 MHz
25 MHz
10 MHz

⇒ The residual resistivity of a binary alloy at 0°K is
the sum of the residual resistivities of the component metals
the difference of the residual resistivities of the component metals
the product of the residual resistivities of the component metals
depend on the concentration of the minor component in the alloy

⇒ Power spectral density of white noise
is constant with frequency
increases with frequency
decreases with frequency
none

⇒ Which of the following statements is correct?
In the magnetic circuit energy is needed continuously to maintain the flux
In the magnetic circuit energy is needed continuously to maintain the flux
The flow of current in the electric circuit involves discontinuous expedition of energy
The flow of current in the electric circuit requires energy for creating the current but not to maintain it

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω