Question is ⇒ With which decoder it is possible to obtain many code conversions?, Options are ⇒ (A) 2 line to 4 line, (B) 3 line to 8 line, (C) not possible with any decoder, (D) 4 line to 16 line decoder, (E) , Leave your comments or Download question paper.

Question is ⇒ With which decoder it is possible to obtain many code conversions?, Options are ⇒ (A) 2 line to 4 line, (B) 3 line to 8 line, (C) not possible with any decoder, (D) 4 line to 16 line decoder, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	With which decoder it is possible to obtain many code conversions?
A.	2 line to 4 line [Wrong Answer]
B.	3 line to 8 line [Wrong Answer]
C.	not possible with any decoder [Wrong Answer]
D.	4 line to 16 line decoder [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Three capacitors each 9 μF are connected in delta. The value of each capacitor in equivalent star connection is
3 μF
6 μF
27 μF
81 μF

⇒ The specified maximum junction temperature of thyristors is about
50°C
80°C
120°C
200°C

⇒ In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0⁺ the current supplied by batter
0.25
0.125
3.6 A
1.5 A

⇒ Frequencies in the UHF range propagate by means of
space wave
surface waves
sky waves
ground waves

⇒ A bulb rated at 60 W, 120 V is used for 30 minutes. The charge associated with this operation is
3600 C
900 C
7200 C
600 C

⇒ Ferroelectric materials are those which
cannot be polarized
have a permanent polarization
have a_e equal to zero
have μ_p = 0

⇒ The Fourier series representation of a periodic current (2 + 62 cos ωt +48 sin 2ωt) A. The effective value is
(2 + 6 + 24) A
0.333333333333333
0.25
0.0833333333333333

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above

⇒ In the graphical analysis of an amplifier circuit, the slope of dc load line depends on
load resistance only
collector supply voltage only
both load resistance and collector supply voltage
none of the above

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M_{1M₁ = (P OR Q) XOR R
M₁ = (P AND Q) XOR R
M₁ = (P NOR Q) XOR R
M₁ = (P XOR Q) XOR R}

⇒ In figure, I_C &as
I₁
I_B
0.5 I₁
0.5 I_B

⇒ The essential condition for antenna array to be linear is that
individual antennas of the array must be of equal size
individual antennas of the array must be equally spaced along a straight line
any two individual antennas of the array must not be in the same direction
none of the above

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum
at t = RC
at t = ∞
at t = 0⁺
none of the above

⇒ If transmission path, in PCM, is very long then
repeater stations are used
pulse width may be increased
pulse amplitude is increased
pulse spacing is reduced

⇒ For the system of the given figure, the undamped natural frequency of closed loop pole
2 rad/sec
1 rad/sec
0.5 rad/sec
0.25 rad/sec

⇒ An RLC series circuit has a variable inductance. The value of L for resonance conditions at fundamental frequency is 0.18 H. For resonance conditions at third harmonic frequency the value of inductance is
0.54 H
0.06 H
0.02 H
1.62 H

⇒ Which of the following circuits come under the class of combinational logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 only
3 and 4
4 and 5
1, 2 and 3

⇒ A parity check usually can detect
one-bit error
double-bit error
three-bit error
any-bit error

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒

Match the following:

	List I (Instrument)		List II (Parameters)
A.	Moving coil galvanometer	1.	High inertia, soft spring control
B.	Ballistic galvanometer	2.	No control, high damping
C.	Vibration galvanometer	3.	Soft spring control, critical damping
D.	Moving coil flux meter	4.	Low inertia, tuned spring control

A-4, B-2, C-3, D-1
A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ DC amplifiers have a tendency to be unstable.
TRUE
FALSE

⇒ Which one is true for writing array variable in Pascal?
The general form of an array variable is an integer or a real variable name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The general form of an array variable must be an integer name followed by subscripts enclosed within square brackets. The subscripts are separated by commas
The subscripts in array variable must be separated by dots
The subscripts must be enclosed within parenthesis

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ The drift velocity of electrons is
very small as compared to speed of light
equal to speed of light
almost equal to speed of light
half the speed of light