Question is ⇒ With JFETs cascade means, Options are ⇒ (A) a common source driving a common gate connection, (B) a common gate driving a common source connection, (C) two FETs connected in parallel, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ With JFETs cascade means, Options are ⇒ (A) a common source driving a common gate connection, (B) a common gate driving a common source connection, (C) two FETs connected in parallel, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	With JFETs cascade means
A.	a common source driving a common gate connection [Correct Answer]
B.	a common gate driving a common source connection [Wrong Answer]
C.	two FETs connected in parallel [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following integer expressions is correct in Pascal?
- A + B + M
A div B * mod C
A - 4.0
A / B + D

⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as
Frequency Division Multiple Access (FDMA)
Time Division Multiple Access (TDMA)
Code Division Multiple Access (CDMA)
All of the above

⇒ M circles are symmetrical with respect to
real and imaginary axis
M = 1 straight line and real axis
M = 1 straight line and imaginary axis
M = 1 straight line

⇒

Assertion (A): A presettable counter can be preset to any desired starting point

Reason (R): The maximum frequency of a ripple counter depends on the modulus.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The instruction LDA 20 in 8085 means
contents of memory location 20 are fetched into the accumulator
the value 20 is fetched into accumulator
either (a) or (b)
neither (a) nor (b)

⇒ If r_e is ac resistance of diode, the Thevenin input impedance of a differential amplifier is
r_e
br_e
2 br_e
0.5 br_e

⇒ In a plate modulated class C amplifier, the peak supply voltage is V. The maximum plate-cathode voltage can be
1 V
1.5 V
2.5 V
4 V

⇒ A 4 input AND gate is equivalent to
4 switches in parallel
2 switches in series and 2 in parallel
three switches in parallel and one in series
4 switches in series

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ The diameter and thickness of CD are
6 cm and 1.2 mm
6 cm and 0.6 mm
12 cm and 0.6 mm
12 cm and 1.2 mm

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is
in the off-state
in the ON state
reverse biased
at the point of breakdown

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ The circuit of figure is ca
current mirror
voltage mirror
impedance inversion
phase splitting

⇒ In control systems the word controller includes
error detector and feedback element
feedback element and control elements
error detector and control elements
error detector, control elements and feedback elements

⇒ If the AF voltage is raised to 10 V, while the AM is dropped to 200 Hz, what is the deviation?
10 kHz
15 kHz
20 kHz
40 kHz

⇒ In the series circuit shown in figure, for series resonance, the value of the coupling coefficient, K wil
0.25
0.5
0.1
1

⇒ A silicon controlled switch has :
2 leads
3 leads
4 leads
5 leads

⇒ The resonance frequency is
ω_r = a
ω_r = b
ω_r = k
ω_r = ba

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m)
262 x 10³
254 x 10³
352 x 10³
354 x 10³

⇒ If B, H and M denote flux density, field intensity and magnetisation, B = μ₀ (H + M).
TRUE
FALSE

⇒ A DC voltage source is connected across a series R - L - C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the
R only
C only
L only
R and L combination

⇒ RMS value of a square wave is the same as peak value.
TRUE
FALSE

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is
40 A
20 A
0.416666666666667
0.208333333333333

⇒ In a conductor which of the following relations hold good?
∇ x D = r
∇ . D = r
∇ x D = 0
∇ . D = 0

⇒ Which of the following binary product is incorrect?
1100 x 1010 = 1111000
1.01 x 10.1 = 11.001
1100110 x 1000 = 1100110000
None of the above

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ The modulation index of a narrowband FM signal is
nearly equal to 0.3
much less than unity
nearly 0.5
much more than unity