Question is ⇒ Wire-wound resistors are unsuitable for use at high frequencies because they, Options are ⇒ (A) are likely to melt under excessive eddy current heat, (B) exhibit unwanted inductive and capacitive effects, (C) create more electrical noise, (D) consume more power, (E) , Leave your comments or Download question paper.

Question is ⇒ Wire-wound resistors are unsuitable for use at high frequencies because they, Options are ⇒ (A) are likely to melt under excessive eddy current heat, (B) exhibit unwanted inductive and capacitive effects, (C) create more electrical noise, (D) consume more power, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Wire-wound resistors are unsuitable for use at high frequencies because they
A.	are likely to melt under excessive eddy current heat [Wrong Answer]
B.	exhibit unwanted inductive and capacitive effects [Correct Answer]
C.	create more electrical noise [Wrong Answer]
D.	consume more power [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As the frequency increases, the absorption of ground wave by earth's surface
decreases
increases
remains the same
either (a) or (c)

⇒ Some possible functions of AGC in a TV receiver are

To increase gain for weak signals
To decrease gain for strong signals
To change the contrast when we switch from one channel to other
To reduce flutter

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2, 3
2, 3, 4

⇒ A flip flop is a
combinational circuit
memory element
arithmetic element
memory or arithmetic element

⇒ Force = Electric intensity x current.
TRUE
FALSE

⇒ At a very low temperature, a semiconductor
becomes a conductor
becomes an insulator
may become a conductor or an insulator
will remain a semiconductor becomes a conductor or an insulator

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒

Assertion (A): Shunt of an ammeter has a low resistance.

Reason (R): Shunt may be connected in series or in parallel with ammeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The number of digit 1 present in the binary representation of 3 x 512 + 7 x 64 + 5 x 8 + 3 is
8
9
10
12

⇒ Measurement of hall coefficient enables the determination of
mobility of charge carriers
type of conductivity and concentration of charge carriers
temperature coefficient and concentration of charge carriers
fermi level and forbidden energy gap

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ The ROC of sequence x[n] = (0.8)ⁿ ∪[n] + (0.4)ⁿ ∪[n]
|z| > 0.8
|z| > 0.4
0.4 < |z| < 0.8
|z| < 0.8

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ A signal m(t) amplitude modulates a carrier A_c cos ω_ct. The final signal will be
[A_c m(t)] cos ω_ct]
A_c . [1 + m(t)] cos ω_ct
A_c + [m(t)] cos ω_ct
A_c cos ω_ct + m(t)

⇒ The number of inputs and outputs of a full adder are
3 and 2 respectively
2 and 3 respectively
4 and 2 respectively
2 and 4 respectively

⇒ In 8085, high level on INTR line can be recognised only if
TRAP and RST lines are high
TRAP and RST lines are not high
TRAP line is high but not RST line
RST line is high but not TRAP line

⇒ Assuming a minimum angle of elevation of 5°, a geosynchronous satellite remains in line-of-sight for __________ percentage of Earth's surface.
30.3
42.4
50
25

⇒ The dual of A + [B + (AC)] + D is
A + [(B (A + C))] + D
A [B + AC] D
A + [B (A + C)] D
A [B (A + C)] D

⇒ Which of the following READ statements is correct in FORTRAN 77?
READ *, HONEY (I), I = 1, 5
READ *, (HONEY (I), I = 1, 5)
READ * HONEY I, I = 1, 5
READ HONEY I, I = 1, 5

⇒ In intrinsic semiconductor, the fermi level
lies at the centre of forbidden energy gap
is near the conduction band
is near the valence band
may be anywhere in the forbidden energy gap

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ Which of the following is not a valid real constant in C?
1.2 e 2.0
-2.3 e - 2
-2.3 E 2
-2.3 e 2

⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE

⇒ In FM reception, amplitude disturbances due to static change
reduce the signal frequencies
increase the signal frequencies
disturb the signal frequencies
do not affect the signal frequencies

⇒ DC ampere hour meter is an indicating instrument.
TRUE
FALSE

⇒ In most transistor the collector region is made physically larger than the emitter region
for dissipating heat
to distinguish it from other regions
as it is sensitive to ultraviolet rays
to reduce resistance in the path of flow of electrons

⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
current, voltage
current, current
voltage, current
voltage, voltage