Question is ⇒ While selecting a memory chip the feature which should be examined is, Options are ⇒ (A) capacity, (B) ac characteristics, (C) dc characteristics, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ While selecting a memory chip the feature which should be examined is, Options are ⇒ (A) capacity, (B) ac characteristics, (C) dc characteristics, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	While selecting a memory chip the feature which should be examined is
A.	capacity [Wrong Answer]
B.	ac characteristics [Wrong Answer]
C.	dc characteristics [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒ Transverse electric (TE) waves have
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ The Thevenin Resistance of the circui
94/7 kΩ
54/7 kΩ
7/54 kΩ
0

⇒ The circuit shown I/P in the figure repres
Low pass filter
High pass filter
Band Pass filter
Band stop filter

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒

Assertion (A): The access time of memory is lowest in the case of DRAM

Reason (R): DRAM uses refreshing cycle.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If F(t) = δ(t - a), F(s)=
0
1
e^-as
e^as

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ As the ratio R_f/R_L increases the efficiency of a rectifier increases.
TRUE
FALSE

⇒ Which of the following cannot provide as much time interval accuracy as the oscilloscope but can capture and display eight or more signals simultaneously, something that scopes cannot do?
Logic analyzer
Digital oscilloscope
Frequency analyzer
Wave analyzer

⇒ An oscillator at 4.2 MHz is followed by two frequency doublers and two triplers. The output frequency will be
84 MHz
112.4 MHz
151.2 MHz
303.4 MHz

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ At absolute zero temperature a semiconductor behaves like
an insulator
a super conductor
a good conductor
a variable resistor

⇒ In a series inverter
the commutating elements L and C are in parallel
the commutating elements L and C are in series with load
the commutating L and C may be in series or parallel with the load
none of the above

⇒ The self bias provides
stable Q point
large voltage gain
high input impedance
high base current

⇒ A cycloconverter uses
natural commutation
forced commutation
either natural or forced commutation
both natural and forced commutation together

⇒ Some sources of TV programs are

TV camera
Telecine
VTR
External signal

Which of the above are actually present in a TV studio?
1, 2, 3 and 4
1, 2, 3
1 and 3
1 2 and 4

⇒ For the transport lag G(jω) = e^-jωT, the phase angle
is constant
varies linearly with frequency
varies linearly with low frequencies only
values as per square law

⇒ The purpose of connecting a coupling capacitor in the output circuit of an amplifier is
to increase voltage gain
to increase collector current
to block dc collector voltage
all of the above

⇒ The essential condition for antenna array to be linear is that
individual antennas of the array must be of equal size
individual antennas of the array must be equally spaced along a straight line
any two individual antennas of the array must not be in the same direction
none of the above

⇒

Match the following:

	List I (BHE, A0)		List II (Word is read/write)
A.	0, 0	1.	1 byte from/to odd address
B.	0, 1	2.	1 byte from/to even address
C.	1, 0	3.	16 bit word
D.	1, 1	4.	None

A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ A TRIAC can be turned on :
by applying a positive signal to gate
by applying a negative signal to gate
by applying either positive or negative signal to gate
none of the above

⇒ In TV transmitter some possible advantages of IF modulation are

The modulator section and visual exciter can be solid state devices
VSB filter can be introduced at low power level
The subsequent stages following VSB filter can be tuned permanently for wideband linear operation
It is economical

which of the above are true?
1 and 2
1, 2 and 3
2, 3 and 4
1, 2, 3 and 4

⇒ For an amplifier the power gain in decibels will be equal to voltage gain in decibels only when
R₀ = 0
R₀ = R_i = 90
R₀ = R_i
R_i = 0

⇒ If damping ratio is 0.5, the lines joining complex poles with origin are inclined to negative real axis at
± 90°
± 60°
± 45°
± 30°

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ Which of the following is not a valid variable name in C?
p_ce1
1p_ce
p1_ce
p _ced

⇒ In an n channel JFET, V_GS = V_GS(off). Then
I_D is zero
I_D may be zero or positive
I_D is positive
I_D may be zero or negative

⇒ The number of key words in C is
4
8
16
32