Question is ⇒ While obtaining minimal SOP expression, Options are ⇒ (A) all do not care terms are ignored, (B) all do not care terms are treated as 1, (C) all do not care terms are treated as 0, (D) only such do not care terms which aid minimization are treated as 1, (E) , Leave your comments or Download question paper.

Question is ⇒ While obtaining minimal SOP expression, Options are ⇒ (A) all do not care terms are ignored, (B) all do not care terms are treated as 1, (C) all do not care terms are treated as 0, (D) only such do not care terms which aid minimization are treated as 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	While obtaining minimal SOP expression
A.	all do not care terms are ignored [Wrong Answer]
B.	all do not care terms are treated as 1 [Wrong Answer]
C.	all do not care terms are treated as 0 [Wrong Answer]
D.	only such do not care terms which aid minimization are treated as 1 [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ A phase shifting transformer is used in conjunction with
DC slide wire potentiometer
Crompton potentiometer
AC coordinate potentiometer
Drysdale potentiometer

⇒ As the diameter of a wire is doubled, the resistance becomes
twice
one half
one fourth
four times

⇒

Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I		List II
A.	IF amplifier	1.	Amplifier frequencies in the range of 100 kHz to 5 MHz.
B.	RF amplifier	2.	Current in the output flows only during a portion of the positive half of the input cycle
C.	AF amplifier	3.	Amplifier frequencies in the range of 0 Hz to 5 MHz
D.	Class operation	4.	Amplifier frequencies in the frequency range of 40 Hz to 15 kHz.

A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2
A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4

⇒ To produce p type semiconductor we add
acceptor atoms
donor atoms
pentavalent impurity
trivalent impurity

⇒ In a low power factor wattmeter, compensation for pressure coil current is provided.
TRUE
FALSE

⇒ DC amplifiers have a tendency to be unstable.
TRUE
FALSE

⇒ Consider the following statements: The radar pulse must be flat topped to

allow accurate range measurement
allow good minimum range
prevent frequency changes in magnetron
make the returned echoes easier to distinguish from noise.

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
1, 2
1, 3, 4

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ In household energy meters the flux of series magnet is in phase with current but the flux of shunt magnet lags the voltage by 88°. The reading of energy meters
will be correct
will have a negative error
will have a positive error
may have positive or negative error

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ The standard FORTRAN exponential form of decimal number 0.0000437 is
4.37 E - 5
4.37 E - 4
43.7 E - 5
43.7 E - 4

⇒ When there is rapid attenuation of field inside the conductor, the field current are concentrated close to the surface of the conductor; this phenomenon is called
skin effect
EM concentration effect
Faraday's effect
Ohm's effect

⇒ Polystyrene has a relative permittivity of 2.7. If the wave is incident at an angle θ_i of 30° from air into polystyrene, the angle of transmission will be nearly
0.2°
2°
18°
48°

⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
8 W
7.5 W
7.1 W
6.8 W

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ In a CE amplifier the input impedance is equal to the ratio of
ac base voltage to ac base current
ac base voltage to ac emitter current
ac emitter voltage to ac collector current
ac collector voltage to ac collector current

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒ Which of the following pulse communication system is inherently immune to noise?
PPM
PCM
PWM
PAM

⇒ DC servomotors are, generally
permanent magnet dc motors
shunt field motors
separately excited dc motors
none of the above

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒ The recently-introduces CD-ROM PC by Head Start Technologies Co. of New York enables users to view or play __________ .
vast amounts of text
graphics
music
all of the above

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ An amplifier of passband 450 kHz to 460 kHz will be named as
video amplifier
audio frequency amplifier
tuned voltage amplifier
wideband amplifier

⇒ Sparking affects amplitude modulation.
TRUE
FALSE

⇒ Which one of the following is not necessarily an advantage of the phase cancellation method of obtaining SSB over the filter method?
It is possible to generate SSB at any frequency
SSB with lower audio frequencies present can be generated
Switching from one sideband to other is simpler
There are more balanced modulators; therefore the carrier is suppressed better

⇒ The current I_CBO
increases with increases in temperature
is normally greater for silicon transistor than germanium transistors
mainly depends on the emitter base junction bias
depends largely on the emitter doping