Question is ⇒ Which statement is true for an ac circuit?, Options are ⇒ (A) Active power is always less than apparent power, (B) Active power cannot be more than apparent power, (C) Active power is always more than reactive power, (D) Active power cannot be more than reactive power, (E) , Leave your comments or Download question paper.

Question is ⇒ Which statement is true for an ac circuit?, Options are ⇒ (A) Active power is always less than apparent power, (B) Active power cannot be more than apparent power, (C) Active power is always more than reactive power, (D) Active power cannot be more than reactive power, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which statement is true for an ac circuit?
A.	Active power is always less than apparent power [Wrong Answer]
B.	Active power cannot be more than apparent power [Correct Answer]
C.	Active power is always more than reactive power [Wrong Answer]
D.	Active power cannot be more than reactive power [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Waveguides are generally used above
20 MHz
100 MHz
200 MHz
1000 MHz

⇒ For the BJT shown in figure, β = 50, the value of V_CE
3.13 V
4.24 V
5.18 V
none

⇒ Which of the following statements about the matched filter in a communication receiver are correct?

Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.

Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒

Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If F_n represents Fourier series coefficient of f(t), then Fourier series coefficient of f(t + t) =
F_ne ^-jω₀^t
F_ne ^jω₀^t
F_ne ^jnω₀^t
F_ne ^-jnω₀^t

⇒ Wire-wound resistors are unsuitable for use at high frequencies because they
are likely to melt under excessive eddy current heat
exhibit unwanted inductive and capacitive effects
create more electrical noise
consume more power

⇒ An electromagnetic wave incident on a perfect conductor is
fully transmitted
partially transmitted
entirely reflected
none of the above

⇒ M = (μ_r - 1)H.
TRUE
FALSE

⇒ Which chopper circuit uses saturable reactor?
Auxiliary commutated
Jones chopper
Morgan chopper
Load commutated

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of
1
-1
0
3

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ Consider the following

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

(1) is true and (2) is false
(1) and (2) both are true
(1) is false and (2) is true
(1) and (2) both are false

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒ At f = 7 GHz, a 120 cm dish antenna gives a gain of about
50
500
5000
50000

⇒ For maximum unclipped output from a CE amplifier, the Q point should be
at the centre of dc load line
at the centre of ac load line
at the centre of collector current
none of the above

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The current rating of dc tachogenerator is usually
small
high
medium
either (b) or (c)

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ The channel of JFET consists of
p type material only
n type material only
conducting material
either p or n type material

⇒

Assertion (A): For a given system only one of the static error constants is finite and significant.

Reason (R): If finite static error constant is large, the loop gain becomes smaller as ω approaches zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these

⇒

Assertion (A): Schering bridge is a low voltage bridge.

Reason (R): Schering bridge is very commonly used for measurement of capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the interconnection of ideal sources shown in the figure, it is known that the 60V source is absorbing p
0.416666666666667
13 A
15 A
18 A

⇒ In a mechanical accelerometer, the steady state displacement is a measure of
constant input acceleration
constant input velocity
either (a) or (b)
neither (a) nor (b)

⇒ In a circuit of figure, V_s = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power facto
0.3
0.4
0.6
none

⇒ In a CB amplifier the maximum efficiency could be
0.99
0.85
0.5
0.25

⇒ In a synchro error detector, the output voltage is proportional to [ω(t)]ⁿ, where ω(t) is the rotor velocity and n equals :
-2
-1
1
2

⇒ If f_s be the signal frequency and f_i be the intermediate frequency then image frequency is given by
f_s + f_i
f_s ± f_i
f_s ± 2f_i
f_s + 2f_i

⇒ Which of the following theorems is a manifestation of law of conservation of energy?
Tellegen's theorem
Reciprocity theorem
Thevenin's theorem
Norton's theorem

⇒ In order to obtain triangular pulses at the output of the circuit in the figure, the input should
grounded
a square wave
Triangular wave
Trigger