Question is ⇒ Which one the following is an advantage of AM over FM?, Options are ⇒ (A) FM has wide bandwidth, (B) FM has better, (C) FM is more immune to noise, (D) Probability of noise spike generation is less in AM, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one the following is an advantage of AM over FM?, Options are ⇒ (A) FM has wide bandwidth, (B) FM has better, (C) FM is more immune to noise, (D) Probability of noise spike generation is less in AM, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one the following is an advantage of AM over FM?
A.	FM has wide bandwidth [Wrong Answer]
B.	FM has better [Wrong Answer]
C.	FM is more immune to noise [Wrong Answer]
D.	Probability of noise spike generation is less in AM [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ Loading of a line means
increasing inductance of line
increasing distributed inductance of line
decreasing distributed inductance of line
decreasing inductance of line

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ Overall efficiency of class B amplifier is
0.72
0.75
0.785
0.7

⇒ Which of the following real expressions is correct in Pascal?
- Z + P * X
(X + Y) (A + B)
Z ** M
Z P * M

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ ADC 0804 is a
dual slope A/D converter
single slope A/D converter
successive approximation A/D converter
either (a) or (b)

⇒ Three point tracking can be achieved with
gang condenser
variable selectivity
paddar capacitor
any of the above

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ The resistance of a 125 Ω strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is
1.5
2
2.5
3

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, V_D is found to be 0.3 V. If V_D = 0.4 V then forward current will be
400 mA
475 mA
477 mA
480 mA

⇒ Consider the expression b = acd (xz). The correct C statement for above expression is
a c d (x * z)
a* c* d* (x z)
a * c * d (x * z)
None of the above

⇒ For low impedance SAW filter the most suitable material for substrate of SAW filter is
PZT ceramics
ZnO
Lithium titanate
Lithium neobate

⇒ Consider the following statements : A clamper circuit

adds or subtracts a dc voltage to a waveform
does not change the waveform
amplifiers the waveform

Which are correct?
1, 2
1, 3
1, 2, 3
2, 3

⇒ SCR can be turned on by

applying anode voltage at a sufficient fast rate
applying sufficiently large anode voltage
increasing the temperature of SCR to a sufficiently
applying sufficiently large gate current.

1, 2, 4 only
4 only
1, 2, 3, 4
none

⇒ Transmitted voltage level is:
11
7.8
7.348 V
none of these

⇒

Match the following:

	List I (Circuit)		List II (Characteristics)
A.	Darlington pair	1.	uses pnp and npn transistors used as power amplifier
B.	CB amplifier	2.	Voltage gain nearly 1 and high input impedance
C.	Cascade amplifier	3.	low input impedance used for high frequency isolation

A-1, B-2, C-3
A-2, B-3, C-1
A-2, B-1, C-3
A-3, B-1, C-2

⇒ The phenomenon of creep occurs in
energy meters
voltmeters
ammeters
wattmeters

⇒ Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?
Tilting
Loss of line-of-eight conditions
Interference from the sky wave
Maximum single hop distance limitation

⇒ In audio cassettes the width of each recording track is
5 mm
2.5 mm
1.5 mm
1 mm

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ Consider a silicon p-n junction at room temperature having the following paramet
is 0.70V
is 0.76V
is 0.82V
cannot be estimated from the data given

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

⇒ A line has an attenuation of 0.054 Np/m. The attenuation in decibels is
4.7 dB/m
0.47 dB/m
0.54 dB/m
5.4 dB/m

⇒ Which of the following devices has a silicon dioxide layer?
NPN transistor
Tunnel diode
JFET
MOSFET

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct