Question is ⇒ Which one of the following statement is correct?, Options are ⇒ (A) Both Laplace's (L) and Poisson's (P) equation are non linear, (B) L is non linear but P is linear, (C) L is linear but P is non linear, (D) L, P both is linear, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following statement is correct?, Options are ⇒ (A) Both Laplace's (L) and Poisson's (P) equation are non linear, (B) L is non linear but P is linear, (C) L is linear but P is non linear, (D) L, P both is linear, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following statement is correct?
A.	Both Laplace's (L) and Poisson's (P) equation are non linear [Correct Answer]
B.	L is non linear but P is linear [Wrong Answer]
C.	L is linear but P is non linear [Wrong Answer]
D.	L, P both is linear [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The sum of two or more arbitrary sinusoidal is
always periodic
periodic under certain conditions
never periodic
periodic only if all the sinusoidals are identical in frequency and phase

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite

⇒ If the p and T circuits in figure are equivalent, then R₁, R₂, R₃ respectively
9 Ω, 6 Ω, 6 Ω
6 Ω, 6 Ω, 9 Ω
9 Ω, 6 Ω, 9 Ω
6 Ω, 9 Ω, 6 Ω

⇒ Transconductance characteristics of JFET depict the relation between
I_D and V_GS for different value of V_DS
I_D and V_DS for different value of V_GS
V_GS and V_DS for different values of I_D
V_DS and I_D for different values of V_GS

⇒ Audio systems use transverse recording.
TRUE
FALSE

⇒ The frequencies in ultra high frequency range are propagated by means of __________ waves
surface
ground
sky
space

⇒ Diffraction of EM waves
arises only with spherical wave front
may occur around the edge of an obstacle
occurs when waves pass through a big slot
none of the above

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ The minimum gate current which can turn on SCR is called :
trigger current
holding current
junction current
breakover current

⇒ In order to achieve accuracy, the slide wire of a potentiometer should be
as long as possible
as short as possible
neither too long nor too short
very thin

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output, frequency for the carrier will be
26 MHz
26.1 MHz
10 kHz
160 kHz

⇒ A uniform wave have components
in the perpendicular direction E existing while H is zero
in the direction of propagation E existing while H is zero
E and H are zero in direction perpendicular to direction of propagation
E and H existing only in direction perpendicular to direction of propagation

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.
TRUE
FALSE

⇒ BPSK stands for
Binary Phase Shifting Key
Broad Phase Shifting Key
Bit Phase Shifting Key
Binary Pulse Shifting Key

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ A line has an attenuation of 0.054 Np/m. The attenuation in decibels is
4.7 dB/m
0.47 dB/m
0.54 dB/m
5.4 dB/m

⇒

Assertion (A): SSB transmitter is generally smaller than AM transmitter

Reason (R): SSB systems mostly use combined transmitter receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A line has Z₀ = 300 ∠ 0° Ω. If Z_L = 150 ∠ 0° Ω, reflection coefficient is
0.5
0.3333
-0.3333
-0.5

⇒ A circuit has two branches in parallel and each branch has only one element. The applied voltage and source current are v = 200 sin (200t + 30°) and i = 50 sin (200t + 50°). If one branch has capacitor, the other branch contains
resistance
inductance
capacitance
resistance or capacitance

⇒ Which of the following cannot be the Fourier series expansion of a periodic signal?
x(t) = 2 cos t + 3 cos 3t
x(t) = 2 cos pt + 7 cos t
x(t) = cos t + 0.5
x(t) = 2 cos 1.5pt + sin 3.5 pt

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒ The effect of a finite gain of operational amplifier used in an integrator is that
it would not integrator
slope of the O/P will varied with time
final value of the O/P
there will be instability in the cirucuit

⇒ The total number of leads in reverse conducting thyristor is
2
3
1
4

⇒ Consider the cascade structure of two filte
1 and 3
only 2
2 and 3
only 3

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ The dielectric losses do not depend on frequency.
TRUE
FALSE

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒

Match the following:

	List I (Oscillator)		List II (Features)
A.	Wien Bridge	1.	RF oscillator, uses two inductors and one capacitor
B.	Colpitt's	2.	LC oscillator for radio frequencies uses three capacitances and one inductance
C.	Hartley	3.	RC oscillator for audio frequencies
D.	Clapp	4.	RF oscillator, uses two capacitances and one inductance

A-2, B-1, C-4, D-3
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2