Question is ⇒ Which one of the following rules determines the mapping of s-plane to z-plane?, Options are ⇒ (A) Right half of the s-plane maps into outside of the unit circle in z-plane, (B) Left half of the s-plane maps into outside of the unit circle., (C) Imaginary axis in s-plane maps in to the circumference of the unit circle., (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following rules determines the mapping of s-plane to z-plane?, Options are ⇒ (A) Right half of the s-plane maps into outside of the unit circle in z-plane, (B) Left half of the s-plane maps into outside of the unit circle., (C) Imaginary axis in s-plane maps in to the circumference of the unit circle., (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following rules determines the mapping of s-plane to z-plane?
A.	Right half of the s-plane maps into outside of the unit circle in z-plane [Wrong Answer]
B.	Left half of the s-plane maps into outside of the unit circle. [Wrong Answer]
C.	Imaginary axis in s-plane maps in to the circumference of the unit circle. [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 3 -4 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒ The earliest uses of electromagnetic waves were
point to point communication
radar
both (a) and (b)
neither (a) nor (b)

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
2.16 x 10⁴ A/cm²
1.08 x 10⁴ A/cm²
4.32 x 10³ A/cm²
6.48 x 10² A/cm²

⇒ A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency f_OH with a second order HP filter having lower cut off frequency f_OL provided
f_OL < f_OH
f_OL > f_OH
f_OH = f_OL
f_OH < 0.5 f_OL

⇒ Tropospheric mode of propagation is used in
UHF
VLF
MF
HF

⇒ MEWS stands for
Missile Early Warning System
Moving Target Early warning System
Missile Early Warning Signal
Moving Target Early Warning Signal

⇒ Consider the following advantages of phase array radar

simple circuitry
ability to track and scan simultaneously
ability to track many targets together
very fast scanning

Which of the above are correct?
1, 2, 3
1, 3, 4
2, 3, 4
1, 4 only

⇒ The approximate value of input impedance of CE amplifier with emitter resistance R_E is given by
h_ie + A_i R_E
h_ie + (1 + h_fe) R_E
h_ie
(1 + h_fe) R_E

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒ The word size accessible at a time from the memory subsystem depends on
width of data bus
width of address bus
width of control bus
both (b) and (c)

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ In a CE amplifier circuit
Q point must lie on both dc and ac load lines
Q point lies on dc load line
Q point lies on ac load line
Q point lies may or may not lie on both dc and ac load lines

⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637

⇒

Assertion (A): Electronic and Ionic polarization in a polyatomic gas are independent of temperature.

Reason (R): The orientation polarization is independent of temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode

⇒ The disadvantage of FM over AM is that
high output power is needed
high modulating power is needed
noise is very high for high frequency
large bandwidth is required

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the velocity propagation will be
15.8303 km/s
15.830 km/s
1.583 km/s
0.1583 km/s

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ Floating gate is fabricated for making MOS
ROM
PROM
EPROM
EAROM

⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of
minority carriers in source
majority carriers in source
charge on gate electrode
minority carriers in drain

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ An antenna having an effective temperature of 27°K is fed into a microwave amplifier that has an effective noise temperature of 30 K. Calculate the available noise power per unit bandwidth
30 K
57 K
27 K
3K, K is Boltzmann constant

⇒

Match the following:

	List I		List II
A.	V_OH(min)	1.	2.4 V
B.	V_IH(min)	2.	1.5 V
C.	V_OL(max)	3.	0.4 V
		4.	2.0 V
		5.	0.8 V

A-1, B-3, C-4
A-1, B-4, C-3
A-5, B-4, C-3
A-1, B-5, C-2

⇒

Assertion (A): The function ke^st with both σ and ω positive and s > 0 depicts a sinusoid whose amplitude increases with time.

Reason (R): If σ = 0, ke^st becomes a sinusoid.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A phasor is
a line representing the magnitude and direction of an alternating quantity
a line which represents the magnitude and phase of an alternating quantity
an instrument used for measuring phases of an unbalanced 3-phase load
a coloured tag or band for distinguishing between different phases of a 3-phase supply

⇒ If f_h(t) is Hilbert transform of f(t), then Hilbert transform of f_h(t) is
-f(t)
+f(t)
f²(t)
f(t)

⇒ Which statement is correct?
BJT and MOSFET are current controlled devices
BJT is voltage controlled and MOSFET is current controlled device
BJT and MOSFET are voltage controlled devices
BJT is current controlled and MOSFET is voltage controlled device

⇒ A frequency multiplier stage should operate as
class A
class AB
class C
either of the above

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The current amplification is
2.5
12.5
25
125

⇒ In the given figure shows a 4 bit serial in parallel out right shift register. The initial contents as shown are 0110. After 3 clock pulses the contents wil
0
101
1010
1111