Question is ⇒ Which one of the following pairs is not correctly matched?, Options are ⇒ (A) NaCl : Diamagnetic, (B) Gd : Paramagnetic, (C) Ferrite : Ferrimagnetic, (D) Cr2 O3 : Ferromagnetic, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following pairs is not correctly matched?, Options are ⇒ (A) NaCl : Diamagnetic, (B) Gd : Paramagnetic, (C) Ferrite : Ferrimagnetic, (D) Cr2 O3 : Ferromagnetic, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following pairs is not correctly matched?
A.	NaCl : Diamagnetic [Wrong Answer]
B.	Gd : Paramagnetic [Correct Answer]
C.	Ferrite : Ferrimagnetic [Wrong Answer]
D.	Cr₂ O₃ : Ferromagnetic [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a system with transfer funct
2.828
5.2915
5.088
cannot be determined

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ Which of the following statements defines a full adder?
It adds two binary digits and produces their SUM and CARRY
It adds three inputs (two binary digits and a carry) and produces their SUM and CARRY
It has two inputs and two outputs
None of the above

⇒ Symbol in the given figure is IEEE symbol
AND
OR
NAND
NOR

⇒ The characteristic equation for the next state (Q_n+1) of a J-K flip-flop is
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n

⇒ The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave
0.33
0.5
2
1

⇒ The number of valence electrons in pentavalent impurity is
5
4
3
1

⇒ Which of the following input is not possible in case of a SR flip-flop?
S = 0, R = 0
S = 0, R = 1
S = 1, R = 0
S = 1, R = 1

⇒ Which of the following is wrong for a magic used to tee?
E and H arms are decoupled
coplanar arms are coupled
all ports are perfectly matched
A signal into coplanar arm splits equally between E and H arms

⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above

⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ For the circuit, let us assume that R = 1 Ω, L = 10^-3 H, and V(t) = 10 cos (1000t + 30°)V and the differential equation for I(t) is give
7.07 cos (1000t + 15°) A
70.7 cos (1000t - 30°) A
7.07 cos (1000t - 15°) A
7.07 cos (1000t + 15°) A

⇒ If two network is connected in series-parallel connection then
h = [h_a] + [h_b]
[a_a] + [b_b]
[Z] = [Z_a] - [Z_b]
none

⇒ If figure, I = 2A if R = 20 Ω. When R = 10 Ω current I
0.0416666666666667
0.0833333333333333
2.5 A
0.125

⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ From which instant is the turn off time of a thyristor defined
when anode voltage becomes zero
when anode current becomes zero
when both anode voltage and current become zero
none of the above

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
a few μV
about 100 μV
a few μV
a few volts

⇒ When a complex signals is used to frequency modulate a carrier, the resulting sideband distribution is
symmetrical about the carrier
not necessarily symmetrical about the carrier
decided by the predominant sidebands
none of the above

⇒ The dissipation at the collector is in the quiescent state and increases with excitation in the case of a
class A series fed Amplifier
class A transistor coupled Amplifier
class AB amplifier
class B amplifier

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ The h parameter h₁₁ is the same in CE and CC circuit.
TRUE
FALSE

⇒ The output impedance of a logic pulser is
low
high
may be Low or High
can't say

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ Which wave is also called surface wave?
Ground wave
Sky wave
Space wave
Both (b) and (c)

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ A 3 kV circuit uses SCR of 800 V rating. If derating is 25%, the number of SCRs in series is
4
5
6
8

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark