Question is ⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?, Options are ⇒ (A) TTL, (B) ECL, (C) PMOS, (D) CMOS, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?, Options are ⇒ (A) TTL, (B) ECL, (C) PMOS, (D) CMOS, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
A.	TTL [Wrong Answer]
B.	ECL [Wrong Answer]
C.	PMOS [Wrong Answer]
D.	CMOS [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ The orientation polarization is

directly proportional to temperature
inversely proportional to temperature
inversely proportional to square of permanent dipole moment
directly proportional to square of permanent dipole moment.

Which of the above are correct?
1 and 3 only
2 and 3 only
1 and 4 only
2 and 4 only

⇒ An n channel JFET has I_DS whose value is
maximum for V_GS = 0 and minimum for V_GS negative and large
minimum for V_GS = 0 and maximum for V_GS negative and large
maximum for V_GS = 0 and minimum for V_GS positive and large
minimum for V_GS = 0 and maximum for V_GS positive and large

⇒ In a 3 input NOR gate, the number of states in which output is 1 equals
1
2
3
4

⇒ All network theorems of dc are applicable to ac also with different quantities taken as phasors.
TRUE
FALSE

⇒ The charge per proton is
1.6 x 10^-19 C
2.6 x 10^-19 C
0.6 x 10^-19 C
1.6 x 10^-13 C

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is
0 ≤ a ≤ p
θ ≤ a ≤ p
0 ≤ a ≤ (p - θ)
θ ≤ a ≤ (p + θ)

⇒ A computer monitor uses 180 W in normal operation and 20 W in sleep mode. The computer is on all the 24 hours but is in sleep mode for 18 hours a days. The energy units saved in 30 days are
0.54 units
86.4 units
2.88 units
4.8 units

⇒ In the full adder, denoting Sum by S and carry by C
S = 1 when two or more inputs are unity
C = 1 when two or more inputs are unity
C = 1 when all the inputs are unity
S = 1 when all the inputs are unity

⇒ If two mutually exclusive events A and B can happen in m and n ways, then either A or B can happen in (m + n) ways.
TRUE
FALSE

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively

⇒ An RLC series circuit
resonant frequency is high
Q is high
bandwidth is large
Q is low

⇒ The resistance of a superconductor is
low
very low
very very low
zero

⇒ Foster Seeley discriminator uses a
single tuned circuit
double tuned circuit with primary and secondary tuned to the same frequency
double tuned circuit with primary and secondary tuned to the different frequency
none of the above

⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ For a BJT, under the saturation region.
I_C = βI_B
I_C > βI_B
I_C is independent of other parameter
I_C < βI_B

⇒ The requirements of carrier frequency are
precise frequency value
low frequency drift
both (a) and (b)
neither (a) nor (b)

⇒ A compensator has its pole and zero as shown in the given fi
lag compensator
lead compensator
lead-lag compensator
series compensator

⇒

Match the following:

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

A-2, B-3, C-1, D-1
A-2, B-3, C-4, D-1
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2

⇒ Mark the false statement:
since wave-shape of a digital signal is unimportant, linear amplifiers are not required
the precise amplitude of a digital signal is also unimportant provided two voltage levels (0 and 1) are quite different
the leading and trailing edges of a digital signal need not be sharp
actual digital waves have rise and fall times of the order of a few nano seconds

⇒ The relative permeability is taken as unity for which of the following?
Air
Cobalt
Vacuum
Bismuth

⇒ Between which regions does BJT act like switch?
Cut off and saturation
Cut off and forward active
Forward active and cut off
Saturation and active

⇒ A linear system is characterized by H(ω) = Be^-2ω² the system is physically
unrealizable
realizable
depends upon B
depends upon constant 2

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ A dc network has an open circuit voltage of 5 V. When its terminals are short circuited a current of 5 A flows through the short circuit. If the short circuit is removed and a resistance of 1.5 Ω is connected across its terminals, the current will be
0.0416666666666667
0.0833333333333333
2.5 A
0.208333333333333

⇒ Atomic number of germanium is
24
28
32
36

⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ Which one of the following is correct? Energy of a power signal is
finite
zero
infinite
between 1 and 2