Question is ⇒ Which one of the following is transferred locking electron device <i>C</i> antenna?, Options are ⇒ (A) BARITT diode, (B) IMPATT diode, (C) Gunn diode, (D) Step recovery diode, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is transferred locking electron device <i>C</i> antenna?, Options are ⇒ (A) BARITT diode, (B) IMPATT diode, (C) Gunn diode, (D) Step recovery diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is transferred locking electron device C antenna?
A.	BARITT diode [Wrong Answer]
B.	IMPATT diode [Wrong Answer]
C.	Gunn diode [Correct Answer]
D.	Step recovery diode [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The fluctuation in the received signal strength at the receiver of a random variation in the received signal is known as
fluctuation
fading
absorption
cycling

⇒ One XOR gate can work as
one bit magnitude comparator
two bit magnitude comparator
either (a) or (b)
neither (a) nor (b)

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ If t_on and t_off are the turn on and turn off times of a thyristor, then
t_on and t_off are almost equal
t_on >> t_off
t_off >> t_on
t_on is about twice t_off

⇒

Assertion (A): The line integral of B about a closed contour, in a region containing steady current, is μ₀ times the total net current, following through the contour of integration.

Reason (R): The curl of B is equal to μ₀ times the current density vector J

Both (A) and (R) are true and (R) is the correct explanation of (A)
Both (A) and (R) are true but (R) is not the correct explanation of (A)
(A) is true but (R) is false
(A) is false but (R) is true

⇒ In figure the input and output Miller capacitances
0.25 μF each
500 pF each
0.25 μF and 500 pF respectively
500 pF and 0.25 μF respectively

⇒ Consider the following stateme
1 and 2
2 and 3
3 and 4
4 and 5

⇒ A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is
25 Ω
50 Ω
225 Ω
250 Ω

⇒ E_G for silicon is 1.12 eV and that for germanium is 0.72 eV. Therefore it can be concluded that
more number of electron-hole pairs will be generated in silicon than in germanium at room temperature
less number of electron hole pairs will be generated in silicon than in germanium at room temperature
equal number of electron-hole pairs will be generated in both at lower temperatures
equal number of electron-hole pairs will be generated in both at higher temperatures

⇒ For the gate in the given figure the output wil
0
1
A
A

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with e_r = 15. The reflection coefficient for normal incidence is
0.6 ∠0°
1 ∠0°
0.6 ∠180°
1.2 ∠180°

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒ Induction wattmeter can be used in
ac circuit only
dc circuit only
both ac and dc circuit
ac 3 phase only

⇒ A square corner reflector is used in
radio astronomy
tv broadcast
point to point communication
all of the above

⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is
same as BPSK
half of that in BPSK
one-fourth of that in BPSK
none of the above

⇒ In 8086 microprocessor, if the segment register contains 1 FAB and IP register contains 10AI, the effective memory address is
20B51
304C
FBC0
FDB5

⇒ In a power diode the reverse recovery time is the time from the instant the forward current is zero to the instant when reverse recovery current has decayed to
50% of peak reverse current
25% of peak reverse current
10% of peak reverse current
zero value

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ In 8085, the pins for SID and SOD are
4 and 5 respectively
5 and 4 respectively
3 and 4 respectively
4 and 3 respectively

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ An antenna having a high Q has
lower BW
higher BW
flat response
none of the above

⇒ Which one condition is true to check the periodically for discrete time signal (where K is any integer, N is period, f₀ is frequency of signal)
f₀ = K/N
f₀ = K + N
f₀ = KN
f₀ = N/K

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the z-transform X(z) = 5z² + 4z^-1 + 3; 0 < |z| < ∞ The inverse transform x[n] is
5δ[n + 2] + 3δ[n] + 4δ[n - 1]
5δ[n - 2] + 3δ[n] + 4δ[n + 1]
5u[n + 2] + 3u[n] + 4u[n - 1]
5u[n - 2] + 3u[n] + 4u[n + 1]

⇒ It is required to measure the true open circuit emf of a battery. The best device is
dc voltmeter
ammeter and known resistance
dc potentiometer
either (a) or (c)

⇒ The V MOS can handle __________ currents than a conventional MOSFET.
much lower
almost same
almost half
much larger

⇒ The gate current required to turn on an SCR is
few amperes
a few mA
almost equal to anode current
about 50% of anode current

⇒ Which of the following is operating system?
MS WORD
Ventura
Java
Windows

⇒

Assertion (A): Capacitance of a solid conducting spherical body of radius 'a' is given by 4 pε₀a in free space.

Reason (R): Δ x H = jωεE + J.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Logarithmic amplifiers are used in
adders
dividers
multipliers
all of the above