Question is ⇒ Which one of the following is D/A conversion technique?, Options are ⇒ (A) Successive approximation, (B) Weighted resistor, (C) Dual slope, (D) Single slope, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is D/A conversion technique?, Options are ⇒ (A) Successive approximation, (B) Weighted resistor, (C) Dual slope, (D) Single slope, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is D/A conversion technique?
A.	Successive approximation [Wrong Answer]
B.	Weighted resistor [Correct Answer]
C.	Dual slope [Wrong Answer]
D.	Single slope [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The forward resistance of a p-n diode is not constant.

Reason (R): The v-i characteristics of p-n diode is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒ An electric charge Q is placed in a dielectric medium which of the following quantities are independent of the dielectric constant ε of the medium
electric potential V and electric field intensity E
displacement density D and displacement φ
electric field intensity E and displacement φ
electric potential V and displacement φ

⇒ A signal m(t) = 5 cos 2p 100 t frequency modulates a carrier. The resulting FM signal
0.1 kHz
6 kHz
3.2 kHz
100 kHz

⇒ The action of backward wave oscillator is similar to that of
klystron amplifier
reflex klystron oscillator
TWT
magnetron

⇒ VLF waves are sometimes used because
they penetrate the ionosphere easily
they are very reliable
they require low power
they require transmitting antennas of convenient sizes

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ The conductivity of germanium increases by about 6 percent per degree increase in temperature.
TRUE
FALSE

⇒ A moving coil meter has a shunt of 0.02 Ω resistance. If coil resistance is 1000 Ω and a potential difference of 500 mV is required across it to cause full scale deflection, the current through shunt is
2.5 A
25 A
0.25 A
0.025 A

⇒ Choose the correct option

Transit period is the time between two steady state
Transient Response is the response due to internal energy stored in circuit
Transit response is also called natural response
Transit response arises due to presence of C and L in the circuit
Transit is due to R, L, C in the circuit

4, 3, 2 , 1
5, 4, 3, 2
5, 4, 3, 1
5, 1, 4

⇒ The potential of suppressor grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ A linear time-invariant, causal continuous time system has a rational transfer function with simple poles at s = - 2 and s = - 4, and one simple zero at s = - 1. A unit step u(t) is applied at the input of the system. At steady state, the output has constant value of 1. The impulse response of this system is
[exp (- 2t) + exp (-4t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t) - exp (-t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t)] u(t)
[-0.5 exp (- 2t) + 1.5 exp (-4t)] u(t)

⇒ Binary multiplication 1 x 0 =
1
0
10
11

⇒ The strength of controlled voltage source depends on
value of current elsewhere in the circuit
value of voltage elsewhere in the circuit
value of current or voltage elsewhere in the circuit
none of the above

⇒ Consider the following applications

Switch
Attenuator
Phase shifter
Oscillator

In which of the above can a PIN diode be used?
1 2 3 and 4
1 2 and 3 only
1 and 2 only
2, 3 and 4 only

⇒ If a sample of germanium and a sample of silicon have the same impurity density and are kept at room temperature
both will have equal value of resistivity
both will have equal negative resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than that of germanium

⇒ The number of product terms in the minimized sum of product expression obtained through the following k map is (where "d" denotes don't care states)
2
3
4
5

⇒ In a material, the Fermi level is located between the centre of the forbidden band and the conduction band. Then what is that material?
A p-type semiconductor
An n-type semiconductor
An intrinsic semiconductor
An insulator

⇒

Match the following:

	List I (F.T and F.S)		List II (Properties)
A.	Fourier Series	1.	Discrete, Periodic
B.	Fourier Transform	2.	Continuous, Periodic
C.	Discrete Time Fourier	3.	Discrete aperiodic
D.	Discrete Fourier Transform	4.	Continuous, aperiodic

A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1
A-1, B-4, C-2, D-3

⇒ A first order system will never be able to give a __________ response

band stop
band pass
all pass

Choose the correct option
1, 2, 3 true
1 and 3 true, 2 false
1, 2 are true 3 is false
1, 2 are false, 3 is true

⇒ A signal m(t) amplitude modulates a carrier A_c cos ω_ct. The final signal will be
[A_c m(t)] cos ω_ct]
A_c . [1 + m(t)] cos ω_ct
A_c + [m(t)] cos ω_ct
A_c cos ω_ct + m(t)

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ In 2's complement representation the number 11100101 represents the decimal number
37
-31
27
-27

⇒ The antenna most commonly used for TV broadcasting in the UHF band is
turnstile antenna
dipole antenna
yagi antenna
rhombic antenna

⇒ Induction wattmeter is an absolute instrument.
TRUE
FALSE

⇒ K maps can be drawn
only for 2 variables
only for 3 variables
only for 4 variables
for any number of variables

⇒ If V = 100 ∠ 16°, the (V) is
10 ∠ 32°
10 ∠ 8°
10 ∠ 16°
10 ∠ 4°