Question is ⇒ Which one of the following compounds is widely used for making ferrites?, Options are ⇒ (A) FeO, (B) CuO, (C) MgO, (D) Fe2O3, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following compounds is widely used for making ferrites?, Options are ⇒ (A) FeO, (B) CuO, (C) MgO, (D) Fe2O3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following compounds is widely used for making ferrites?
A.	FeO [Wrong Answer]
B.	CuO [Wrong Answer]
C.	MgO [Wrong Answer]
D.	Fe₂O₃ [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the program segment written for 8085 based sys
41
69
44
Indeterminate

⇒ A 2 bit binary multiplier can be implemented using
2 I/P only
2 I/P XOR_s and 4 I/P and gates only
two 2 I/P_s NOR and one XNOR gate
XOR gates and shift Register

⇒ The logic operations of the two circuits given below
complementary
identical
entirely different
none of these

⇒ Power Point is a presentation software.
TRUE
FALSE

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on

⇒ Z flag is reset if an ALU operation results in 0.
TRUE
FALSE

⇒ A dc network has 3 independent nodes and 4 loops. In total analysis, the number of equations is
4
3
2
1

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13

⇒ In order to achieve good stabilization in potential divider method current I₁ through R₁ and R₂ should be
I₁ > 20 I_B
I₁ > 15 I_B
I₁ < 5 I_B
I₁ > 10 I_B

⇒ The units of μ₀ and μ_r are
H/m for both
H/m for μ_r and no units for μ₀
H/m for μ₀ and no units for μ_r
Wb/m for μ₀ and no units for μ_r

⇒ Advanced low power Schottky is a part of
ECL family
CMOS family
TTL family
none of the above

⇒ Z = _______
C[A(B + C) + D]
(AB + AC + D)
(CA + AC + D)
none of these

⇒ The total number of leads in reverse conducting thyristor is
2
3
1
4

⇒ For a BJT, under the saturation region.
I_C = βI_B
I_C > βI_B
I_C is independent of other parameter
I_C < βI_B

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites

⇒ An ideal op-amp has
infinite input and output resistance
low input and output resistance
low input and high output resistance
infinite input resistance and zero output resistance

⇒ In the TTL circuit in the figure, S₂ to S₀ are select lines and X₇ to X₀ are input lines. S₀ and X₀ are LSBs. The output
Indeterminate
A ⊕ B
A ⊕ B
C . A ⊕ B + C . (A ⊕ B)

⇒ The stage marked X in the architecture shown below of a two stage op-amp
Direct coupled amplifier
Buffer amplifier
Level shifter
Blocking oscillator

⇒ The radiation resistance of a doublet antenna of length dl is proportional to
δ l
(δ l)²
(δ l)³
(δ l)⁰⁵

⇒ An air gap provided in the iron core of an inductor prevents
flux leakage
hysteresis loss
core saturation
heat generation

⇒ The HV and other voltage supplies for a TV receiver are obtained from IHVT. The full name for this device is
Internal high voltage transformer
Integrated high voltage transformer
Instant high voltage transformer
Interleaved high voltage transformer

⇒ In a 4 input AND gate, the total number of High outputs for 16 input states are
16
8
4
1

⇒ N-type silicon is obtained by doping silicon with
germanium
aluminium
boron
phosphorus

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ Shannon's Law relates
antenna gain to frequency
noise power to bandwidth
information-carrying capacity to S/N ratio
transmission losses to noise

⇒ The main advantage of TDM over FDM is that it
needs less power
needs less bandwidth
needs simple circuitry
gives better S/N ratio

⇒ The relation between thermionic emission current and temperature is known as
Richardson Dushman equation
Langmuir child law
Ohm's law
Boltzmann's law

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac