Question is ⇒ Which one of the following circuits is most suitable as an oscillator at a frequency of 100Hz?, Options are ⇒ (A) Hartley oscillator, (B) Colpitts oscillator, (C) Crystal oscillator, (D) Twin-T oscillator, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following circuits is most suitable as an oscillator at a frequency of 100Hz?, Options are ⇒ (A) Hartley oscillator, (B) Colpitts oscillator, (C) Crystal oscillator, (D) Twin-T oscillator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following circuits is most suitable as an oscillator at a frequency of 100Hz?
A.	Hartley oscillator [Correct Answer]
B.	Colpitts oscillator [Wrong Answer]
C.	Crystal oscillator [Wrong Answer]
D.	Twin-T oscillator [Wrong Answer]
View Answer 4 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Photoelectric effect occurs only in semiconductors and not in metals.
TRUE
FALSE

⇒ A modem is classified as low speed if data rate handled is
upto 100 bps
upto 250 bps
upto 400 bps
upto 600 bps

⇒ Which instrument is based on induction principle?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

⇒ Which of the following is operating system?
MS WORD
Ventura
Java
Windows

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A quiescent state of a transistor implies
zero bias
no output
no distortion
no input signal

⇒ The 54/74164 chip is an 8-bit serial-input-parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is
1 μs
2 μs
8 μs
16 μs

⇒ An antenna has 40 Ω resistance and 60 Ω radiation resistance. The efficiency of the antenna is
0.3
0.4
0.5
0.6

⇒ A transmitter serial current contains
carrier frequencies
audio frequencies
radio frequencies
none of the above

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): In a perfect capacitor, the current density is given by ω ∈₀E₀∈^'_rcos(ωt + 90°), where ∈_r^' is real part of dielectric constant.

Reason (R): In a perfect capacitor, dielectric losses are zero.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒ ALU carries out
arithmetic operations
logic operations
both arithmetic and logic operations
none of the above

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ Which of the following is not a valid real constant?
-73.1
10251,3
10.23
-5.7381

⇒ If ω is the frequency of modulating voltage in FM, the modulation index is proportional to
ω
1/ω
ω
1/ω

⇒ The feedback resistance r_d in small signal model of MOSFET is of the order of
1000 MΩ
1 MΩ
1 KΩ
100 Ω

⇒ Which of the following is not true as regards communication receiver?
It is exactly same as radio receiver used in households
It can be used, besides communication, for detection in high frequency bridges
It is designed to perform the task of low and high frequency reception better than in household receiver
Its tuning and operation are more complicated than those in household receiver

⇒ Zero bias works only with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ For emitter-couple logic, the switching speed is very high because
negative logic is used
the transistors are not saturated when conducting
emitter-coupled transistors are used
multi-emitter transistors are used

⇒ n channel FETs are better as compared to p-channel FET because
they are more efficient
they have high switching time
they have higher input impedance
mobility of electrons is more than that of holes

⇒ A balun transformer gives an impedance transformation of
0.167361111111111
0.0840277777777778
0.0444444444444444
0.0430555555555556

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ In a CE amplifier
both ac and dc load lines have the same slope
the ac load line has more slope than dc load line
the ac load line has less slope than dc load line
the two load lines may have slope more than the other

⇒ If an admittance Y(s) has a term Ks, the realization would give
an inductance of value K
a resistance of value K
a capacitance of value K
either (a) or(c)

⇒ If a RAM has 34 bits in its MAR and 16 bits its MAR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ If X(z) = (1 - az^-1), and |a| < |z|, the initial value x₀ is
1
0
2
∞

⇒ For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as
2E
3E
4E
6E

⇒ DC amplifiers have a tendency to be unstable.
TRUE
FALSE

⇒ A digital frequency counter can be converted to DVM by addition of a suitable
voltage controlled oscillator
D/A converter
power amplifier
operational amplifier