Question is ⇒ Which one of the following can be used for amplification of microwave energy?, Options are ⇒ (A) TWT, (B) Magnetron, (C) Reflex klystron, (D) Gunn diode, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following can be used for amplification of microwave energy?, Options are ⇒ (A) TWT, (B) Magnetron, (C) Reflex klystron, (D) Gunn diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following can be used for amplification of microwave energy?
A.	TWT [Correct Answer]
B.	Magnetron [Wrong Answer]
C.	Reflex klystron [Wrong Answer]
D.	Gunn diode [Wrong Answer]
View Answer 4 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The transmitting antennas for lower frequencies (below 500 kHz) are generally
vertical grounded wire type
horizontal suspended wire type
parabolic reflector type
any of the above

⇒ Silicon and germanium are elements in the
second column of periodic table
third column of periodic table
fourth column of periodic table
fifth column of periodic table

⇒ Which amplifier has the higher power gain?
Common emitter
Common collector
Common base
Both CC and CE

⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass

⇒ The gain margin for a stable system
has a positive decibel value
has a negative decibel value
has a large negative decibel value
none of the above

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ A Hartley oscillator uses
a tapped capacitor
a tapped inductor
a tapped inductor for inductive feedback
none of the above

⇒ The output frequency of a cycloconverter can be changed by changing the firing angle.
TRUE
FALSE

⇒ In the circuit shown in the given figure, the current flowing through resistance of 100 Ω woul
8 mA
10 mA
20 mA
100 mA

⇒ In an R-L circuit, the impedance is 30 Ω at a frequency of 100 Hz. At 200 Hz, the impedance should be
30 Ω or more
60 Ω or more
15 Ω or less
more than 30 Ω but less than 60 Ω

⇒ The op amp is used in
A/D converters
D/A converters
both (a) and (b)
shift registers

⇒ In the above case the total power in the modulated wave double sideband, suppressed carrier AM will be
112 W
400 W
415 W
512 W

⇒ Which of the following is true?
Intel 8080 was the ancestor of Intel 8085
Intel 8080 was the ancestor of Intel Z 80
Intel 8080 was the ancestor of both Intel 8085 and Z 80
Intel 8085 was the ancestor of Intel 8085

⇒ In a dual converter both converters work as rectifiers.
TRUE
FALSE

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ The number of counter states which an 8 bit stair step A/D converter has to pass through before conversion takes place is equal to
1
8
255
256

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ The threshold voltage of a MOSFET can be lowered by

using thin gate oxide
reducing the substrate concentration
increasing the substrate concentration.

Of the above statement
3 alone is correct
1 and 2 are correct
1 and 3 are correct
2 alone is correct

⇒ The equivalent resistance between terminals x and y figur
150 Ω
45 Ω
55 Ω
35 Ω

⇒

Match the following:

	List I		List II
A.	Anderson Bridge	1.	Low resistance
B.	Kelvin Bridge	2.	Medium resistance
C.	Schering Bridge	3.	Inductance
D.	Wheatstone Bridge	4.	Capacitance

A-4, B-2, C-3, D-1
A-3, B-2, C-4, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ Consider the following program segment written for 8085 based sys
CE
20
indeterminate
none of these

⇒ If f₁ and f₂ and half-power frequency and f₀ be resonant frequency, the selectivity of R-L-C series circuit is given by
(f₂ - f₁)/2f₀
(f₂ - f₁)/f₀
(f₂ - f₀)/(f₁ - f₀)
(f₂ - f₁)/(f₁ - f₀)

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒

Match the following:

	List I		List II
A.	Copper	1.	produces discrete energy level just above valence band
B.	Rubber	2.	produces discrete energy level just below conduction band
C.	Antimony	3.	large forbidden gap
D.	Boron	4.	valence and conduction bands overlap

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4

⇒

Assertion (A): Shunt of an ammeter has a low resistance.

Reason (R): Shunt may be connected in series or in parallel with ammeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ To make antenna more directional, either its size must be increased or
the number of its feed horns must be increased
the frequency of its transmission must be increased
its effective isotropic radiated power (EIRP) must be increased
its footprint must be increased

⇒ Triatics are
small height antenna directly mounted on jeeps, ships, etc.
the towers or masts which are used as radiators
the towers or masts which are not used as radiators
supports for antenna conductors.