Question is ⇒ Which one is a non-causal system?, Options are ⇒ (A) y(n) = x(2n), (B) y(n) = x(n/2), (C) y(n) = x(n/2) + x(n), (D) all, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one is a non-causal system?, Options are ⇒ (A) y(n) = x(2n), (B) y(n) = x(n/2), (C) y(n) = x(n/2) + x(n), (D) all, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one is a non-causal system?
A.	y(n) = x(2n) [Correct Answer]
B.	y(n) = x(n/2) [Wrong Answer]
C.	y(n) = x(n/2) + x(n) [Wrong Answer]
D.	all [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Bode	1.	Asymptotic plots
B.	Evans	2.	Polar plots
C.	Nyquist	3.	Root locus technique
		4.	M and N circles

A-1, B-4, C-2
A-2, B-3, C-4
A-3, B-1, C-4
A-1, B-3, C-2

⇒ Stray capacitance is important at low frequencies.
TRUE
FALSE

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ A clock signal driving a 6-bit ring counter has a frequency of 1 MHz. How long is each timing bit high?
1 ms
2 ms
3 ms
6 ms

⇒ Current having waveform in figure flows through 10 Ω resistance. Average powe
1000 W
500 W
333.3 W
250 W

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ If I = J = K = 13, then in Fortran 1 = 10 - (1 / 10) * 10 + (J / 5) * 4 + K ** (- 2) is equal to
8
7
6
5

⇒ Consider the following
only statement 1 is correct
only statement 2 is correct
both statements are correct
both the statements 1 and 2 are not correct

⇒ Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode?

It has low saturation current.
It has high value of cut in voltage.
It can withstand large reverse voltage.
When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions.

Select the answer using the given below
1 and 2
1, 2, 3, 4
2, 3, 4
1, 3

⇒ In an n-p-n transistor, the majority carriers in the base are
electrons
holes
both holes and electrons
either holes or electrons

⇒

Assertion (A): The ac load line is different from dc load line

Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ Which of the following is the fastest switching device?
JFET
BJT
MOSFET
Triode

⇒ Which of these has lowest dielectric strength?
Dry air
Wet air
Cotton
Paper

⇒ In the case of the circuit shown in the figure, the collector current I_C will be, if β = 100, V_BE = 0.7 V, I_CO = 0.1 βA at 20&d
2.26 mA
1.85 mA
0.357 mA
0.185 mA

⇒ What will be BCD number when the output is 0.37 V?
110111
10110111
11001000
1001000

⇒ A class B amplifier

is biased just at cutoff
has a high theoretical efficiency of 78.5% because its quiescent current is low
is biased at midpoint of load line

Of the above statements
2 and 3 are correct
1 alone is correct
1 and 2 are correct
2 alone is correct

⇒ In which of the following semiconductor are holes minority carriers
extrinsic
p type
n type
intrinsic

⇒ Which one of the following can be used as parallel to series converter?
Decoder
Digital counter
Multiplexer
Demultiplexer

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32

⇒ In an n channel JFET, V_GS = V_GS(off). Then
I_D is zero
I_D may be zero or positive
I_D is positive
I_D may be zero or negative

⇒ X and Y are two random variable and Z = X + Y. Let σ_x², σ_y² and σ_z² be variance of X, Y and Z. Then
σ_z² = σ_x² + σ_y²
σ_z² ≤ σ_x² + σ_y²
σ_z² < σ_x² + σ_y²
σ_z² > σ_x² + σ_y²

⇒

Assertion (A): In intrinsic semiconductors, the charge concentration increases with temperature.

Reason (R): At higher temperatures, the forbidden energy gap in semiconductors is lower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is
Δ
5Δ
Δ/5
indeterminant

⇒ The loss of charge method can be used to measure
resistance of shunt
insulation resistance of cable
resistance of shunt winding
both (b) and (c)

⇒ A telephone exchange has 9000 subscribers. If the number of calls originating at peak time is 10, 000 in one hour, the calling rate is
0.9
43017
0.81
0.1

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒ Consider the following, logic diagr
0000 to 1111
0000 to 1001
0000 to 1010
1001 to 0000