Question is ⇒ Which of these statements is correct?, Options are ⇒ (A) Ridge guide is essentially a form of capacitively loaded guide., (B) Ridge guide is essentially a form of inductively loaded guide., (C) Ridge guide is essentially a form of resistively loaded guide., (D) Ridge guide has higher power handling capacity than rectangular waveguide., (E) , Leave your comments or Download question paper.

Question is ⇒ Which of these statements is correct?, Options are ⇒ (A) Ridge guide is essentially a form of capacitively loaded guide., (B) Ridge guide is essentially a form of inductively loaded guide., (C) Ridge guide is essentially a form of resistively loaded guide., (D) Ridge guide has higher power handling capacity than rectangular waveguide., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of these statements is correct?
A.	Ridge guide is essentially a form of capacitively loaded guide. [Correct Answer]
B.	Ridge guide is essentially a form of inductively loaded guide. [Wrong Answer]
C.	Ridge guide is essentially a form of resistively loaded guide. [Wrong Answer]
D.	Ridge guide has higher power handling capacity than rectangular waveguide. [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Between which regions does BJT act like switch?
Cut off and saturation
Cut off and forward active
Forward active and cut off
Saturation and active

⇒ Which of the following operation are performed on linear queues?

Testing a linear queue for underflow
Enqueue operation
Dequeue operation
Testing a linear queue for overflow.

Select the correct answer using the codes given below the lists
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2, 3 and 4

⇒ If A = 10 + j then log_eA is
14.14 ∠45°
200 ∠45°
2.65 + j45°
2.65 + j0.785

⇒ Reciprocity theorem is applicable to
circuits with one source
circuits with only one independent source
circuits with any number of sources
circuits with any number of independent sources

⇒ The output of the 74 series of TTL gates is taken from a BST in
totem pole and common collector configuration
either totem pole or open collector configuration
common base configuration
common collector configuration

⇒ In Schering bridge, the potential of detector above earth potential is about
a few volts
10 kV
1000 V
either (a) or (b)

⇒ In push pull amplifier, each transistor conducts for
180°
360°
90°
45°

⇒ LVDT is a
pressure transducer
displacement transducer
velocity transducer
acceleration transducer

⇒ The ionosphere plays a significant role in radio wave propagation at
high frequency
ultra-high frequencies
microwave frequency
optical frequencies

⇒ If G(s)H(s) = K (T₁s + 1)/[s² (T₂s + 1)] the system stability depended an relative magnitudes of T₁ and T₂.
TRUE
FALSE

⇒ Silicon and germanium are elements in the
second column of periodic table
third column of periodic table
fourth column of periodic table
fifth column of periodic table

⇒ The following Variable Entered Map (VEM) represents which of the following funct
f(A, B, C, D) = ∑(1, 2, 3, 4, 7, 8, 9, 14, 15) + Φ(3, 5, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 8, 10, 8, 13, 15) + Φ(3, 6, 12, 14)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 10, 13, 15) + Φ(6, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 9, 12, 13) + Φ(3, 5, 14, 15)

⇒ In an end fire array, the radiation pattern
is in the plane of array
is at right angles to array
is at an angle to the plane of array
either (b) or (c)

⇒ Which inverter circuit uses coupled inductors?
Modified McMurray full bridge inverter
McMurray Bedford half bridge inverter
Modified McMurray Bedford half bridge inverter
Both (b) and (c)

⇒ A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
5 Ω and 25%
25 Ω and 20%
5 Ω and 16.7%
25 Ω and 16.7%

⇒

Match the following:

	List I (Devices)		List II (characteristic)
A.	BJT	1.	Voltage controlled negative resistance
B.	MOSFET	2.	High current gain
C.	Tunnel diode	3.	Voltage regulation
D.	Zener diode	4.	High input impedance

A-1, B-4, C-2, D-3
A-2, B-4, C-1, D-3
A-2, B-3, C-1, D-4
A-1, B-3, C-2, D-4

⇒ For a Mod 64 parallel counter we need
6 flip flops
6 flip flops and 2 AND gates
6 flip flops and 4 AND gates
none of the above

⇒ 100101₂ is equal to decimal number
47
37
21
17

⇒ A short circuited stub is preferred to an open circuited stub because an open circuited stub
is more difficult to fabricate and construct
is made of transmission line of different Z₀
is liable to radiate
is incapable of giving full range of reactance

⇒ If absolute potential of A is - 8 V and that of B is - 16 V, V_AB is equal to
24 V
8 V
- 8 V
- 24 V

⇒ If PRIN = 200.0 and BINT = 0.0525 the result of expression INCOME = PRIN * (1 + BINT) will be
210
210.5
210.5
210.5

⇒ The resistivity of ferrites is
very much lower than that of the ferromagnetic metals
slightly lower than that of the ferromagnetic materials
slightly higher than that of the ferromagnetic metals
very much higher than that of the ferromagnetic metals

⇒ If a microcomputer has a 64 K memory; what is the hexadecimal notations for the last memory location?
1111
1A1A
EEEF
FFFF

⇒ Padders are used in a receiver to
discard the carrier
facilitate tracking
filter the input signal
suppress noise

⇒ In figure V_i may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω

⇒ The charge of an electron is
1.6 x 10^-17 coulomb
1.6 x 10^-19 coulomb
1.6 x 10^-21 coulomb
1.6 x 10^-23 coulomb

⇒

Assertion (A): The conductivity of an n type semiconductor increases with increase in temperature and increase in density of donor atoms.

Reason (R): Diffusion of carriers occurs in semiconductors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An ac circuit has an impedance of (3 + j6) ohm for fundamental. The impedance for fifth harmonic is
(15 + j 30) Ω
(15 + j 6) Ω
(3 + j 30) Ω
(3 + j 1.2) Ω

⇒ Frequencies in the UHF range propagate by means of
space wave
surface waves
sky waves
ground waves

⇒ The probability giving distribution of electrons over a range of allowed energy levels is known as
Maxwell's Distribution
Fermi-Dirac Distribution
Richardson Dushman Distribution
none of the above