Question is ⇒ Which of these is also called 'hot carrier diode'?, Options are ⇒ (A) PIN diode, (B) LED, (C) Photo diode, (D) Schottky diode, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of these is also called 'hot carrier diode'?, Options are ⇒ (A) PIN diode, (B) LED, (C) Photo diode, (D) Schottky diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of these is also called 'hot carrier diode'?
A.	PIN diode [Wrong Answer]
B.	LED [Wrong Answer]
C.	Photo diode [Wrong Answer]
D.	Schottky diode [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Each kilometer of travel in electromagnetic radiation means a time delay of
330 μs
33 μs
3.3 μs
0.33 μs

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
196 W
73 W
36.5 W
18.25 W

⇒ In an n channel JFET, V_GS = V_GS(off). Then
I_D is zero
I_D may be zero or positive
I_D is positive
I_D may be zero or negative

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ The resistance of human body is about
5000 Ω
2000 Ω
1000 Ω
200 Ω

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ The radio horizon for space waves is about three-fourth as for as the optical horizon.
TRUE
FALSE

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4

⇒ Zero mean Gaussian noise of variance N is applied to a half wave rectifier. The mean squared value of the rectified output will be
0
N/2
N/2
N

⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
1.39 V
0.75 V
13.9 V
7.45 V

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ In the spectrum of an FM wave
When modulation index is large, carrier frequency disappears
carrier frequency cannot disappear
amplitude of any side band depends on modulation index
the total number of side bands depend on modulation index

⇒ If t is relaxation time and t_c is average time between collisions, then in an isotropic metal
t = t_c
t < t_c
t_c < t
T = 0.01 t_e

⇒ Which of the following represents the equivalent circuit of a crystal for crystal oscilla
Figure A
Figure B
Figure C
None of the above

⇒

Match the following:

	List I		List II
A.	Tunnel diode	1.	is also known as hot carrier diode
B.	PIN diode	2.	used with reverse bias
C.	Zener diode	3.	has an intrinsic layer
D.	Schottky diode	4.	v-i curve has shape of N

A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4

⇒ Examine the following statements

Air and gases are compressible.
Air, gases and some liquids are compressible.
Oil can function as hydraulic fluid as well as lubricator.

Which of the above statements are correct?
3 only
2 and 3 only
1 and 3 only
2 only

⇒ A step voltages is applied to RLC series circuit having R = 2 Ω, L = 1 H and C = 1 F. The transient current response will be
over damped
critically damped
under damped
any of the above depending the magnitude of voltage

⇒ In standard TTL the totem pole stage refers to
multiemitter input stage
phase splitter
output buffer
open collector output stage

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ At a frequency equal to cutoff frequency in a rectangular wave guide
the flow of electromagnetic energy is zero
the flow of electromagnetic energy is infinite
the flow of electromagnetic energy is 50% of maximum
the flow of electromagnetic energy is 10% of maximum

⇒ Norton's equivalent circuit
is same as Thevenin's circuit
has no relation with Thevenin's circuit
is dual of Thevenin's circuit
is reciprocal of Thevenin's circuit

⇒

Assertion (A): The colour signal consists of only luminance signal

Reason (R): In India PAL colour signal system is used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following two statements about the internal conditions in an n-channel MOSFET operating in the active re
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, but S2 is not a reason for S1
Both S1 and S2 are true, and S2 is a reason for S1

⇒ If f(t) = 1, F(jω) =
2p
p
2pδ (p)
pδ (ω)

⇒ The quiescent collector current I_C, and collector to emitter voltage V_CE in a CE connection are the values when
ac signal is zero
ac signal is low
ac signal is negative
either (a) or (b)

⇒ In an RC-coupled amplifier for improving the low frequency response
lower R_L is provided
more bias is used
less gain is provided
higher C_C is used

⇒ System bus is the communication channel between microprocessor and peripherals.
TRUE
FALSE

⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec

⇒ Which of the following combinations has no phase inversion of the signal?
Two CE stages
CE and CC stages
Three CE stages
CE stages and emitter follower