Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Which of the following waves has the highest value of peak factor '? |

A. | Square wave [Wrong Answer] |

B. | Sine wave [Wrong Answer] |

C. | Half wave rectifier sine wave [Correct Answer] |

D. | Triangular wave [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :Shivani saxena Said on 2017-11-16 03:53:43Kaise !! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Two waves of the same frequency have opposite phase when the phase angle between them is

360°

180°

90°

0°

⇒ Which of the following is not a non-linear element ?

Transistor

Heater coil

Diode

Electric arc with unlike electrodes

⇒ Which of the following waves has the highest value of peak factor '?

Square wave

Sine wave

Half wave rectifier sine wave

Triangular wave

⇒ While drawing vector diagram for a series circuit the reference vector is

Voltage

Current

Power

Phase angle

⇒ The reflection co-efficient of the simplest standing wave is

+1

1

Zero

Infinity

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be____ amperes.

141.4

200

200/π

40/π

⇒ Inductance affects the direct current flow

Only at the time of turning off

Only at the time of turning on

At the time of turning on and off

At all the time of operation

⇒ For the same peak value which of the following wave will have the highest r.m.s. value ?

Square wave

Half wave rectified sine wave

Triangular wave

Sine wave

⇒ Selectivities of different resonance circuits are compared in terms of their

Impedances

Reactances

Frequencies

Band widths

⇒ Two sinusoidal quantities are said to be phase quadrature, when their phase difference is

0

30°

45°

90°

⇒ For 200 V r.m.s. value triangular wave, the peak voltage will be

200 V

222 V

282 V

346 V

⇒ The power factor at resonance in RLC parallel circuit is

Zero

0.08 Lagging

0.8 Leading

Unity

⇒ Ohm is the unit of all of the following except

Inductive reactance

Capacitive reactance

Resistance

Capacitance

⇒ The capacitors for power factor correction are rated in terms of

Voltage

VA

kW

kVAR

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is

Apparent power

True power

Reactive power

None of the above

⇒ Capacitive reactance is more when

Capacitances is less and frequency of supply is less

Capacitance is less and frequency of supply is more

Capacitance is more and frequency of supply is less

Capacitance is more and frequency of supply is more

⇒ Higher the Q of a series circuit

Broader its resonance curve

Narrower its pass band

Greater its band width

Sharper its resonace

⇒ The negative maximum of a cosine wave occurs at

30

45

90

180

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.

Impedance

Susceptance

Quality factor

Selectivity

⇒ In a series resonant circuit, the impedance of the circuit is

Minimum

Maximum

Zero

None of the above

⇒ A parallel resonant circuit can be used

As a high impedance

To reject a small band of frequencies

Both (A) and (B)

To amplify certain frequencies

⇒ For the full wave rectified sine wave the r.m.s. value is

0.707 I

_{max}

0.636 I

_{max}

0.318 I

_{max}

Zero

⇒ The unit of frequency of an A.C. signal is

Cycle

Cycle-sec

Hertz

Hertz/sec

⇒ The shunt element in a band pass filter is

Capacitive

Inductive

Parallel combination of L and C

Series combination of L and C

⇒ The r.m.s. value and mean value is the same in the case of

Triangular wave

Sine wave

Square wave

Half wave rectified sine wave

⇒ A sine wave of voltage varies from zero to maximum of 200 V. How much is the voltage at the instant of 30° of the cycle ?

50V

82.8V

100V

173.2 V

⇒ The form factor is the ratio of

Peak value to r.m.s. value

r.m.s. value to average value

Average value to r.m.s. value

None of these

⇒ The product of apparent power and cosine of the phase angle between circuit voltage and current is

True power

Reactive power

Volt-amperes

Instantaneous power

⇒ In a R-L-C series circuit if voltage V across the circuit is reduced to half the current I will change to

2 I

I/2

3/4 I

5/8 I

⇒ The voltage of domestic supply is 220 V. This figure represents-

Mean value

r.m.s. value

Peak value

Average value