Question is ⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?, Options are ⇒ (A) Thermocouple, (B) Piezoelectric, (C) Thermistor, (D) L.V.D.T, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?, Options are ⇒ (A) Thermocouple, (B) Piezoelectric, (C) Thermistor, (D) L.V.D.T, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following transducers requires a high input impedance preamplifier for proper measurements?
A.	Thermocouple [Wrong Answer]
B.	Piezoelectric [Correct Answer]
C.	Thermistor [Wrong Answer]
D.	L.V.D.T [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The chemical properties of atoms are determined by all the electrons and their configuration.
TRUE
FALSE

⇒ In a colour TV receiver, PAL Dematrix consists of
chroma detector to separate the three primary colours
delay line and PAL matrix to give U and V signals
delay line and PAL matrix to give RGB colours
none of the above

⇒ In Z_RC(s) has a pole at s = 0, the first element in first Foster realization is
a capacitor
a resistor
R-C in series
either a capacitor or resistor

⇒ A voltage multiplier circuit, using diodes and capacitors is suitable for
high voltage high current device
high voltage low current device
low voltage low current device
low voltage high current device

⇒ The function of interface circuit is
to match output conditions of driver with input conditions of load device
to match output conditions of load device with input conditions of driver
both (a) and (b)
neither (a) nor (b)

⇒ A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is
1
0.7
0.2
1.4

⇒ Fundamental mode is another name for
level operation
pulse operation
clock operation
none of these

⇒ The power density spectrum of noise voltage of resistor R can be expressed as
2 kTR
1 kTR
0.5 kTR
0.25 kTR

⇒ The n state variables can be considered as n components of a state vector.
TRUE
FALSE

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ In an homogeneous dielectric subjected to an electric field E, the dipole moment per unit volume is ∈₀(∈_r - 1) E.
TRUE
FALSE

⇒ Find cut off wavelength for mode TE₁₁ in a circular waveguide having radius 2 cm. Assume K'_a = 1.841
4 cm
6.82 cm
8 cm
68.2 cm

⇒ The frequency at which magnitude of closed loop frequency response is 3 dB below its zero frequency value is called critical frequency.
TRUE
FALSE

⇒ The probability giving distribution of electrons over a range of allowed energy levels is known as
Maxwell's Distribution
Fermi-Dirac Distribution
Richardson Dushman Distribution
none of the above

⇒ The mass of proton and electron are
1.672 x 10^-26 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-26 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-29 kg and 9.107 x 10^-31 kg respectively
9.107 x 10^-30 kg and 9.107 x 10^-31 kg respectively

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒ For making a capacitor, the dielectric should have
high ∈_r
low ∈_r
∈_r = 1
∈_r neither too high nor too low

⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers
WESTAT
INSAT-IC
ARABSAT
INSAT-ID

⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
22000 Ω
2200 Ω
22 ± 5% Ω
22 ± 10% Ω

⇒ A microwave connector should have high SWR.
TRUE
FALSE

⇒ Which of the following is not correct?
Voltmeter should have a very high resistance
An ammeter should have a very low resistance
A shunt should have a very low resistance
An electronic voltmeter draws appreciable current from source

⇒ Modulation is also called detection.
TRUE
FALSE

⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V

⇒ A leaky dielectric has ∈_r = ∈_r^' - j∈_r^". If a field E is applied, the current component in phase with E is proportional to ∈_r^".
TRUE
FALSE

⇒ Which of the following are the properties of a medium?
Permeability, flux, magnesium
Permittivity, permeability, insulation
Permeability, resistivity, conductivity
Permittivity, permeability, conductivity

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒
Assertion (A): In Figure, the intercept of the line on y-axis is equal to N (a_e + a_i), where N is number of atoms/m³, a_e is electronic polarizability and a_i is ionic polarizability.
Reason (R): a_e and a_i are independent of temperatu
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A CB amplifier has r_e = 6 Ω, R_L = 600 Ω and a = 0.98. The voltage gain is
100
600 x 0.98
98
6

⇒ During fast forward operation of a tape recorder
all heads are withdrawn
all amplifiers are shut off
tape is not pressed against capstan
all of the above

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math