Question is ⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z0?, Options are ⇒ (A) line open circuited at far end, (B) line terminated in Z0, (C) line short circuited at far end, (D) line terminated in inductance, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z0?, Options are ⇒ (A) line open circuited at far end, (B) line terminated in Z0, (C) line short circuited at far end, (D) line terminated in inductance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?
A.	line open circuited at far end [Wrong Answer]
B.	line terminated in Z₀ [Correct Answer]
C.	line short circuited at far end [Wrong Answer]
D.	line terminated in inductance [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an RL series circuit the inductance is 1H and current at an instant is 0.6 A. The energy stored in magnetic field is
0.36 J
0.18 J
0.09 J
0.03 J

⇒ The MOS symbol shown indicates that

It is depletion type
It is enhancement type
It is channel
It is P-channel
Electrons flow from s to D
Holes flow from D to s

The true statements
1, 3, 6
1, 3, 5
2, 4, 6
2, 3, 5

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ The five flags in 8085 are designated as
Z, CY, S, P and AC
D, Z, S, P, AC
Z, C, S, P, AC
Z, CY, S, D, AC

⇒ For a high pass filter attenuation = 0 at f = 0.
TRUE
FALSE

⇒ Automatic sensitivity control by target voltage control is easily possible in
Vidicon
Plumbicon
New vicon
both (b) and (c)

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ K maps can be drawn
only for 2 variables
only for 3 variables
only for 4 variables
for any number of variables

⇒ Push pull amplifier is
class B
class A
class C
Class A or Class C

⇒

Match the following:

	List I		List II
A.	CLP	1.	Measure of μP clock speed
B.	SHELL	2.	Double sided double density
C.	DSDD	3.	Allows you to specify file as command processor
D.	Megahertz	4.	Microcode stored in ROM

A-4, B-3, C-2, D-1
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ In control systems the magnitude of error voltage
is very small
is very large
neither small nor large
may be any value from 0 to 50 V

⇒ The pre-emphasis in FM aids in providing extra noise immunity by
emphasizing only the higher frequency components
emphasizing the entire frequency band
emphasizing only the lower frequency band
cutting down the low frequency noise

⇒ The receiver of a pulsed RADAR can detect signal power in the order of
1 W
0.1 W
10^-5 W
10^-12 W

⇒ In a hot wire instrument, the deflection is proportional to
peak value of ac current
average value of ac current
rms value of ac current
either (a) or (b)

⇒ Polystyrene has a relative permittivity of 2.7. If the wave is incident at an angle θ_i of 30° from air into polystyrene, the angle of transmission will be nearly
0.2°
2°
18°
48°

⇒ A surface charge density of 8 nc/m² is present on a plane x = z. A line charge density of 30 nC/m is present on line x = 1, y = 2 Find V_AB for points A(3, 4, 0) and B(4, 0, 1)
583.38 V
58.338 V
583.38 mV
58.338 mV

⇒ Consider the following statements about hybrid ring

Ports 1 and 2 are decoupled.
Port 3 and 4 are coupled.
A signal entering either port 1 or 2 splits equally between ports 3 and 4.
A signal entering either port 3 or 4 splits equally between ports 1 and 2.

Which of the above are correct?
1, 2, 3 and 4
1, 3 and 4
1 and 2
2, 3 and 4

⇒ An homogeneous dielectric material is subjected to an electric field E. If a small cavity is made inside the material, the electric field intensity inside and outside the cavity are different.
TRUE
FALSE

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒ Which of the following is not correct in C?
6 / 4 = 1
2 / 5 = 0
2.0 / 5 = 0
2.0 / 5.0 = 0.4

⇒ A voltage tripler circuit uses
2 diodes and 2 capacitors
3 diodes and 3 capacitors
2 diodes and 3 capacitors
3 diodes and 2 capacitors

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?
Resistance triggering
Simultaneous triggering
Sequential triggering
Optical triggering

⇒ Electrical conductivity of metals expressed in ohm^-1 m^-1 is of the order of
10¹⁰
10⁵
10^-4
10^-6

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ The bandwidth of FM for Commercial Purpose is
88 - 108 MHz
85 - 110 MHz
90 - 110 MHz
infinite Range

⇒ The 2's complement representation of - 17 is
1110
1111
11110
10001