Question is ⇒ Which of the following term does not apply to the Yagi-Uda array?, Options are ⇒ (A) High gain, (B) Folded dipole, (C) Parasitic, (D) Good bandwidth, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following term does not apply to the Yagi-Uda array?, Options are ⇒ (A) High gain, (B) Folded dipole, (C) Parasitic, (D) Good bandwidth, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following term does not apply to the Yagi-Uda array?
A.	High gain [Correct Answer]
B.	Folded dipole [Wrong Answer]
C.	Parasitic [Wrong Answer]
D.	Good bandwidth [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the balanced bridge shown in figure. X should
a self inductance having resistance
a capacitance
a non-inductive resistance
an inductance and capacitance in parallel

⇒ As compared to a bipolar transistor, a JFET is
highly sensitive to changes in input voltage
more sensitive to changes in input voltage
less sensitive to changes in input voltage
equally sensitive to changes in input voltage

⇒ If for a silicon n-p-n transistor, the base to emitter voltage (V_BE) is 0.7 V and the collector to base voltage V_CB is 0.2 Volt, then the transistor is operating in the
normal active mode
saturation mode
inverse active mode
cut off mode

⇒ For BJT transistor. The maximum power dissipation is specified as 350 mW if ambient temperature is 25°C. If ambient temperature is 60°C the maximum power dissipation should be limited to about
100 mW
250 mW
450 mW
600 mW

⇒ For most metals, Fermi level E_F is less than
0.1 eV
2 eV
5 eV
10 eV

⇒ Ferrites are
ferromagnetic materials
ferrimagnetic materials
ferroelectric materials
ferri-ferromagnetic materials

⇒ To prevent a DC return between source and load, it is necessary to use
resistor between source and load
inductor between source and load
capacitor between source and load
either (a) or (b)

⇒ The IF stage of a receiver employs
capacitive coupling
impedance coupling
double-tuned transformer coupling
single-tuned transformer coupling

⇒ Which of the following is not a valid variable in FORTRAN 77?
BRG
VS
VS 3A
3 VSA

⇒ When a wave is incident from the more dense into a less dense medium at an angle equal to or exceeding the critical angle, the wave suffers total internal __________ .
reflection
refraction
transmission
none of the above

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p

⇒ If E is electric field intensity, the current density due to field emission is proportional to
E
E²
E^2.5
E^3/2

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ Which of the following is a valid integer constant?
17
-18.58
101.14
-810

⇒ The selectivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ Consider the following, logic diagr
0000 to 1111
0000 to 1001
0000 to 1010
1001 to 0000

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): The gate current of an SCR is always in the form of pulses.

Reason (R): The gate losses, in pulse triggering, are low.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If X = 1 in the logic equation [X + Z { Y + (Z + X Y)}] { X + Z (X + Y)} = 1, then
Y = Z
Y = Z
Z = 1
Z = 0

⇒ In an ordinary thyristor
turn on and turn off times are equal
turn on time is more than turn off time
turn off time is more than turn on time
turn on time may be equal, less than or more than turn off time

⇒ An earth mat for a communication tower consists of
one or two radials extending from base of tower at a depth of about 5 cm below ground
a large number of radials extending from base of tower at a depth of about 3 m
a large number of radials extending from base of tower at a depth of about 30 cm
none of the above

⇒ A narrow band FM does not have the following feature
it has two sidebands
both sideband equal in magnitude
both sideband have same Phase Difference
it does not show Amplitude variation

⇒ Which of the following statements is true regarding the fundamental mode of the metallic waveguides sh
Only P has no cutoff- frequency
Only Q has no cutoff- frequency
Only P has no cutoff- frequency
All there have cut-off frequency

⇒ The emission of light is LED due to
emission of holes
emission of electrons
generation of electromagnetic radiations
conversion of heat energy into illumination

⇒ Silicon diodes have __________ reverse resistance than germanium diodes.
a much smaller
a much larger
an infinite
a negligible

⇒ Consider the following about 'return' statement in C

On executing the return statement, it immediately transfers the control back to the calling program.
There is no restriction on the number of 'return' statements present in a function.
The 'return' statement must be present at the end of called function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ How many interrupts are there in 8085 microprocessor?
4
5
6
8

⇒ The main drawbacks of EEPROM are
low density
high cost
both low density and high cost
none of the above