Question is ⇒ Which of the following substances on adding in electrolyte helps in producing bright finish?, Options are ⇒ (A) Glycerine., (B) Dextrol., (C) Phenol., (D) Any of these., (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following substances on adding in electrolyte helps in producing bright finish?, Options are ⇒ (A) Glycerine., (B) Dextrol., (C) Phenol., (D) Any of these., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following substances on adding in electrolyte helps in producing bright finish?
A.	Glycerine. [Wrong Answer]
B.	Dextrol. [Wrong Answer]
C.	Phenol. [Wrong Answer]
D.	Any of these. [Correct Answer]
View Answer 5 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 24 V battery of internal resistance r = 4 ω connected to a variable resistance R. The rate of heat dissipation in the resistor is maximum when the current drawn from the battery is I. The current drawn from the battery will be 1/2 when R is equal to
8 ω
12 ω
16 ω
20 ω

⇒ If the specific gravity of the electrolyte in a lead acid cell increases beyond 1.23 there will be
loss of life.
loss of capacity.
increase in internal resistance.
corrosion of the grids of the plate.

⇒ During electroplating the weight of a substance deposited depends upon
shape of the article
quantity of electricity
room temperature
all of the above

⇒ Through an electrolyte an electric current is due to drift of
Free electrons
Positive and negative ions
Free electrons and holes
Protons

⇒ The emf of primary cell depends upon the
physical dimensions of a cell.
nature of electrolyte.
nature of electrode.
both (b) and (c).

⇒ Which of the following tests is performed for ascertaining whether the battery plates are defective or not?
Specific gravity test.
High discharge test.
Cadmium test.
None of the above.

⇒ Which of the following statements is incorrect about lead acid batteries ?
The electrolyte in weak sulphuric acid.
When fully charged both of the plates become lead-per-oxide.
The number of plates is always odd.
The number of negative plates is one more than the number of positive plates.

⇒ In lead acid batteries, sedimentation occurs due to
idleness foralongeiperiod.
overcharging at slow rate.
overcharging at high rate
slow charging at low rate.

⇒ What happens during the charging of acid cell ?
Voltage increases
Energy is given out
Both
None of these

⇒ What happens during the discharging of Edison cell ?
Relative density of electrolyte decreases
The emf does not change
The emf decreases
Relative density increases

⇒ In a lead acid battery, fillers are provided to
facilitate flow of gasses
prevent flow of gasses.
recover acid losses through vapours.
reduce tendency for polarisation.

⇒ Short circuiting of a cell results in
reduced gassing during charging.
abnormal high temperature.
low specific gravity of the electrolyte.
all of the above.

⇒ In a lead acid battery, the level of the electrolyte should be
equal to that of the plates.
below the level of plates.
above the level of plates.
none of the above.

⇒ Which of the following is not the name of a secondary cell ?
Acid cell
Alkali cell
Fuel cell
Storage cell

⇒ In a battery, cover is placed over the elements and sealed at the top of the battery container. This is done in order to
exclude dirt and foreign matter from the electrolyte.
reduce evaporation of water from electrolyte.
both (a) and (b).
none of the above

⇒ Internal resistance of primary cell varies
inversely with the distance between electrodes.
inversely with the surface area of electrodes.
directly with the distance between electrodes
with the nature of electrodes.

⇒ What causes lower efficiency of alkali cell as compared to the acid cell ?
Lower emf
Small amount of electrolyte
Longer life
Higher internal resistance

⇒ Vent plug is provided in each lead acid cell to
pour water or electrolyte when needed.
check the electrolyte level.
allow escape out of gases during charging.
all of the above.

⇒ Capacity of a dry cell is
more when it supplies current continuously.
more when it supplies current intermittently.
not affected by the type of discharge.
none of the above.

⇒ The capacity of a lead acid battery does not depend upon
charge rate.
discharge rate.
temperature.
density of electrolyte & quantity of active material.

⇒ In a lead acid battery, separators are provided to
reduce internal resistance.
facilitate flow of the current.
avoid internal short circuits.
increase the energy efficiency.

⇒ The current capacity of a cell is measured in
A
Ah
W
Wh

⇒ The arrangement of 12 cells, each of internal resistance 1.5 ω, to give maximum current in external load resistance of 2 ω will be
all 12 cells in series.
all 12 cells in parallel.
4 cells in series with 3 rows in parallel.
3 cells in series with 4 rows in parallel.

⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by
10 ω
15 ω
25 ω
40 ω

⇒ Sulphated cells are indicated by the
low specific gravity.
low voltage on discharge.
low capacity.
all of the above.

⇒ A floating battery is one
which is charged and discharged simultaneously.
in which battery voltage is equal to charger voltage.
which supplies current intermittently and also during idle period gets charged.
none of the above.

⇒ The capacity of a lead acid battery is adversely affected by increase in
discharge rate.
charge rate.
temperature.
specific gravity of the electrolyte.

⇒ Overcharging of a lead acid battery would cause
excessive gassing.
loss of active material.
increase in temperature resulting in buckling of plates.
all of the above.

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ Common impurity in a battery electrolyte is
dust particles.
iron.
lead crystals.
sodium chloride.