Question is ⇒ Which of the following statements is not correct?, Options are ⇒ (A) Propagation delay is the time required for a gate to change its state, (B) Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state, (C) Fan-in of a gate is always equal to fan-out of the same gate, (D) Operating speed is the maximum frequency at which digital data can be applied to a gate, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following statements is not correct?, Options are ⇒ (A) Propagation delay is the time required for a gate to change its state, (B) Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state, (C) Fan-in of a gate is always equal to fan-out of the same gate, (D) Operating speed is the maximum frequency at which digital data can be applied to a gate, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following statements is not correct?
A.	Propagation delay is the time required for a gate to change its state [Wrong Answer]
B.	Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state [Wrong Answer]
C.	Fan-in of a gate is always equal to fan-out of the same gate [Correct Answer]
D.	Operating speed is the maximum frequency at which digital data can be applied to a gate [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET

⇒ RMS value is always higher than average value.
TRUE
FALSE

⇒ The current wave shape shown in figure (1) is applied to a circuit element. The voltage across the element is shown in figure (2). The element
R
L
C
Semiconductor

⇒ If e = 10 cos (2p x 10⁸t + 20 cos 2p 10³t). The bandwidth is
10⁸ Hz
42 kHz
21 kHz
10⁸ ± 10³ Hz

⇒ Following figure repres
AND
OR
NAND
NOT

⇒ In an air cored coil, a current of 0.7 A causes a flux of 5 x 10^-6 Wb. If the core is made of cast iron and the coil is similar, the same current can set up a flux of about
5 x 10^-6 Wb
5 x 10^-8 Wb
10^-2 Wb
5 x 10^-4 Wb

⇒ A dielectric should have poor heat conductivity.
TRUE
FALSE

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD

⇒ Bandwidth for practical PCM system is (where n is no. of channels, N length of PCM codes)
2n N f_m Hz
4n f_m Hz
2n f_m
(N + 1)f_m

⇒ In the following non planar graph number of independent loop equations
8
12
7
5

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.
1.8 x 10⁸ m/sec
5 x 10⁸ m/sec
3 x 10⁸ m/sec
1.5 x 10⁸ m/sec

⇒ A few minutes disturbance in space communications occurs twice a year during Sunblinding when __________ are in line.
Sun and satellite
Sun and Earth station
Satellite and Earth station
Sun, satellite and Earth station

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0

⇒ Two identical FETs each having parameters g_m and r_d are connected is parallel. The composite FET has parameters
0.5 g_m and 2 r_d
0.5 g_m and 0.5 r_d
2 g_m and 2 r_d
2 g_m and 0.5 r_d

⇒ The circuit shown below is functionally equivalen
NOR gate
OR gate
EX-OR gate
NAND gate

⇒

Assertion (A): PC-XT is a personal computer.

Reason (R): PC-XT uses a floppy drive and has a medium sized hard disc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The most commonly used devices for differencing and amplification, in control systems, are
BJT amplifiers
FET amplifiers
operational amplifiers
either (a) or (b)

⇒ The common emitter short circuit current gain β of a transistor
is a monotonically increasing function of the collector current I_c
is a monotonically decreasing function of I_c
increasing with I_c, for low I_c, reaches a maximum and then decreases with further increase in I_c
is not a function of I_c

⇒ A 1 ms pulse can be stretched to 1 sec pulse by using
an astable multivibrator
a monostable multivibrator
a bistable multivibrator
a Schmitt trigger circuit

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statement is false?
Television signals are propagated as ground waves
Surface waves can propagate on piezoelectric substrates
The skip distance is the maximum distance upto which ionospheric reflection is possible
Tropospheric scatter propagation is always subjects to fading

⇒ A CW transmitter radiates
modulated RF carrier
unmodulated RF carrier
both (a) and (b)
none of the above

⇒ Junction temperature is always the same as room temperature.
TRUE
FALSE

⇒ The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W, respectively
35 A, 350 W, respectively
5 A, 250 W, respectively
11 A, 1210 W, respectively

⇒ The expression A ** B / C + D is equivalent to
AB / C + D
AB / C + D
AB / (C + D)
None of the above

⇒ Is Schottky TTL, Schottky diode is used primary to
prevent saturation of the transistor
saturate the transistor
act as a switch
act as a controlling switch

⇒ EEPROM is also known as
UVPROM
EAPROM
both UVPROM and EAPROM
none of the above

⇒ Which type of fading causes serious distortion of modulated signal?
Selective fading
Interference fading
Absorption fading
Polarization fading

⇒

Assertion (A): Charge is dual of flux.

Reason (R): Short circuit is dual of open circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true