Question is ⇒ Which of the following statement is incorrect ?, Options are ⇒ (A) Resistance is a passive element, (B) Voltage source is an active element, (C) Conductance is a passive element, (D) Current source is a passive element, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following statement is incorrect ?, Options are ⇒ (A) Resistance is a passive element, (B) Voltage source is an active element, (C) Conductance is a passive element, (D) Current source is a passive element, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following statement is incorrect ?
A.	Resistance is a passive element [Wrong Answer]
B.	Voltage source is an active element [Wrong Answer]
C.	Conductance is a passive element [Wrong Answer]
D.	Current source is a passive element [Correct Answer]
View Answer 11 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the full wave rectified sine wave the r.m.s. value is
0.707 I_max
0.636 I_max
0.318 I_max
Zero

⇒ Which of the following circuit component opposes the change in the circuit voltage
Inductance
Capacitance
Conductance
Resistance

⇒ The best place to install a capacitor is
Very near to inductive load
Across the terminals of the inductive load
Far away from the inductive load
Any where

⇒ The value of operator j2 is equal to
Zero
+1
-1
√-1

⇒ Capacitive reactance is more when
Capacitances is less and frequency of supply is less
Capacitance is less and frequency of supply is more
Capacitance is more and frequency of supply is less
Capacitance is more and frequency of supply is more

⇒ Poor power factor results in all of the following EXCEPT.
Overloading of transformers
Overloading of altemators
Reduction in power losses
Reduction in load handling capacity of electrical system

⇒ A coil with large distributed capacitance has a
High resonant frequency
Low resonant frequency
Low quality factor
Low resistance

⇒ In a series resonant circuit, the impedance of the circuit is
Minimum
Maximum
Zero
None of the above

⇒ For 200 V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
282 V
346 V

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.
Impedance
Susceptance
Quality factor
Selectivity

⇒ Selectivities of different resonance circuits are compared in terms of their
Impedances
Reactances
Frequencies
Band widths

⇒ In a pure resistive circuit
Current lags behind the voltage by 90°
Current leads the voltage by 90°
Current can lead or lag the voltage by 90°
Current is in phase with the voltage

⇒ Inductance affects the direct current flow
Only at the time of turning off
Only at the time of turning on
At the time of turning on and off
At all the time of operation

⇒ The negative maximum of a cosine wave occurs at
30
45
90
180

⇒ The power consumed in a circuit element will be least when the phase difference between the current and voltage
180°
90°
60°
0°

⇒ Two waves of the same frequency have opposite phase when the phase angle between them is
360°
180°
90°
0°

⇒ The power is measured in terms of decibles in case of
Electronic equipment
Transformers
Current transformers
Auto-transformers

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees
90
60
45
30

⇒ The peak value of a sine wave is 200 V. Its average value is
127.4V
141.4V
282.8V
200 V

⇒ Higher the Q of a series circuit
Broader its resonance curve
Narrower its pass band
Greater its band width
Sharper its resonace

⇒ The voltage of domestic supply is 220 V. This figure represents-
Mean value
r.m.s. value
Peak value
Average value

⇒ The r.m.s. value of a half-wave rectified current is 100 A. Its value for full-wave rectification would be____ amperes.
141.4
200
200/π
40/π

⇒ In a R-L-C series circuit if voltage V across the circuit is reduced to half the current I will change to
2 I
I/2
3/4 I
5/8 I

⇒ Which of the following statement is incorrect ?
Resistance is a passive element
Voltage source is an active element
Conductance is a passive element
Current source is a passive element

⇒ For the same peak value, which of the following wave has the least mean value ?
Half wave rectified sine wave
Triangular wave
Sine wave
Square wave

⇒ While drawing vector diagram for a series circuit the reference vector is
Voltage
Current
Power
Phase angle

⇒ A network is said to be non-linear if it does not satisfy
Homogeneity condition
Superposition condition
Both (A) and (B)
Associative condition

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates
Low efficiency
High power factor
Unity power factor
Maximum Load current

⇒ In the R - L - C containing R = 4.5ω L = 0.06 H,C = 0.6 µF the power factor will be
Zero
Lagging
Leading
Unity

⇒ The dual of a link is
Twig
Node
Loop
Tree branch