Question is ⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?, Options are ⇒ (A) Power can be measured by this method only for star connected loads, (B) When two wattmeters have equal readings power factor is 0.5., (C) When power factor is 1, one of the wattmeters readings is zero, (D) When the two wattmeter read equal and opposite, p.f. is zero., (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?, Options are ⇒ (A) Power can be measured by this method only for star connected loads, (B) When two wattmeters have equal readings power factor is 0.5., (C) When power factor is 1, one of the wattmeters readings is zero, (D) When the two wattmeter read equal and opposite, p.f. is zero., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
A.	Power can be measured by this method only for star connected loads [Wrong Answer]
B.	When two wattmeters have equal readings power factor is 0.5. [Wrong Answer]
C.	When power factor is 1, one of the wattmeters readings is zero [Wrong Answer]
D.	When the two wattmeter read equal and opposite, p.f. is zero. [Correct Answer]
View Answer 3 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Boolean expression for the sub-class (Q) of all electronic instruments which are measuring instruments or are non-digital instruments with battery supply is
Q = X(Y + Z)
Q = X + YZ
Q = XY + Z
Q = XY + Z

⇒ A 37 bit mantissa has an accuracy of
6 decimal places
8 decimal places
10 decimal places
11 decimal places

⇒ In figure, the current supplied by battery immediately after switching on the circui
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ A circuit said to be lumped when physical dimensions of all the component are __________ .
greater compared with wavelength of electromagnetic signal
small compared with wavelength electromagnetic signal
negligible compared with wavelength of electromagnetic signal
equal compared with wavelength of electromagnetic signal

⇒ Read the following statements: Dual slope ADC provides

higher speed as compared to other ADC
very good accuracy
good rejection of power supply
better resolutions compared to other ADC for the same number of bits

Which of the above are correct?
1 and 2
2 and 3
1, 2, 3
1, 2, 3, 4

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ The current in a circuit is measured using a 150 : 1 CT If the ammeter reads 0.6 A, the circuit current is
250 A
90 A
156 A
144 A

⇒ An ideal rectifier should have
100% efficiency, zero ripple factor, zero harmonic factor and unity displacement factor
100% efficiency, zero tipple factor, zero harmonic factor and zero displacement factor
100% efficiency, zero ripple factor, unity harmonic factor and unity displacement factor
100% efficiency, unity ripple factor, zero harmonic factor and unity displacement factor

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ The maximum distance between television transmission and receiving antennas for reasonably good reception should be
less than 20 km
less than 100 km
less than 500 km
less than 1000 km

⇒ The electric flux and field intensity inside a conducting sphere is
minimum
maximum
uniform
zero

⇒

Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.

Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A circuit is fed by two sources of the same frequency and values 100 ∠0° V and 20 ∠30°V. The current in a particular branch is 5 ∠19° A. If the magnitudes of the sources and changed to 200 ∠0° V and 40 ∠30° V, the current in that branch should be
5 ∠19° A
10 ∠19° A
10 ∠38° A
10 ∠9.5° A

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE

⇒ What will be conversion time of a successive approximation A/D converter which uses 2 MHz clock and 5 bit binary ladder containing 8 V reference.?
2.5 μ sec
25 μ sec
3 μ sec
4 μ sec

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ The collector voltage V_C of the circuit shown in the given figure aside is approxima
2 V
4.6 V
8 V
8.6 V

⇒ Words having 8 bits are to be stored into computer memory. The number of lines required for writing into memory are
1
2
4
8

⇒ Which of the following statement is false?
Television signals are propagated as ground waves
Surface waves can propagate on piezoelectric substrates
The skip distance is the maximum distance upto which ionospheric reflection is possible
Tropospheric scatter propagation is always subjects to fading

⇒ Zip floppy has a capacity of
50 MB
500 MB
25 MB
100 MB or 250 MB

⇒ Consider the following statements about radar Beacon

It is also called transponder.
It includes pulse transmitter, receiver and antenna.
It replies with full power even when the signal receives is weak.

Which of the above statements are correct?
All
1 and 2 only
2 and 3 only
2 only

⇒ Covalent bond energy in Germanium is approximately
3.8 eV
4.7 eV
7.4 eV
12.5 eV

⇒ A digital clock uses __________ chip
SSI
LSI
VLSI
MSI

⇒ The output of a Mealy system is 1 if there has been a pattern of 11000, otherwise 0. The minimum state for this system is :
4
5
6
7

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ In a 3 phase semiconverter, the firing frequency is
equal to line frequency
3 times the line frequency
6 times the line frequency
12 times the line frequency

⇒ If σ standard deviation, probable error
σ
± 1.19 σ
± 0.6745 σ
± 0.4125 σ