Question is ⇒ Which of the following statement about receivers is false?, Options are ⇒ (A) Double conversion is used to improve image rejection, (B) Double conversion is used to improve selectivity, (C) Variable sensitivity is used to improve selectivity, (D) Variable sensitivity is used to eliminate selective fading, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following statement about receivers is false?, Options are ⇒ (A) Double conversion is used to improve image rejection, (B) Double conversion is used to improve selectivity, (C) Variable sensitivity is used to improve selectivity, (D) Variable sensitivity is used to eliminate selective fading, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following statement about receivers is false?
A.	Double conversion is used to improve image rejection [Wrong Answer]
B.	Double conversion is used to improve selectivity [Wrong Answer]
C.	Variable sensitivity is used to improve selectivity [Wrong Answer]
D.	Variable sensitivity is used to eliminate selective fading [Correct Answer]
View Answer 5 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ In a NOT gate the output is always the opposite of the input.
TRUE
FALSE

⇒ A semi-conductor device that behaves like two SCRs is
UJT
MOSFET
JFET
TRIAC

⇒ The real part of complex frequency s corresponds to oscillations.
TRUE
FALSE

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒ The main disadvantage of the two-hole directional coupler is
poor directivity
narrow bandwidth
high standing wave ratio
low directional coupling

⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?
EI only
SIM only
EI and SIM both
None

⇒

Assertion (A): The advantages of totem pole output are fast switching and low power consumption.

Reason (R): IC packages available are DIP, surface mount and J lead surface mount.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If A is 1011, A" is
1011
100
1100
1010

⇒ Consider the following program in C 0.297
0.2
0
3

⇒ A presettable counter with 4 flip flops can start counting from
0
1000
any number from 0000 to 1000
any number from 0000 to 1111

⇒ The values of 2⁵ in octal system is
40
20
400
200

⇒ MS outlook is a software for DTP.
TRUE
FALSE

⇒ For the control system in the given figure, the value of K for critical dampin
1
5.125
6.831
10

⇒ In a klystron amplifier the input cavity is called
buncher
catcher
Pierce gun
collector

⇒

Assertion (A): The impedance of a matched load is equal to characteristic impedance of line.

Reason (R): A matched termination absorbs all the power incident on it.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which distortion is least objectionable in case of audio amplifiers?
Phase distortion
Frequency distortion
Harmonic distortion
Inter-modulation distortion

⇒ A 37 bit mantissa has an accuracy of
6 decimal places
8 decimal places
10 decimal places
11 decimal places

⇒ In figure base current is 10 μA and β_dc = 100. Then V_{E5 V
10 V
15 V
20 V}

⇒ The reading of the voltmeter V in figure should be __________ v
60
10
66
0

⇒ In Class C operation the collector current looks like
full sine wave
half sine wave
narrow pulses
nearly half sine wave

⇒ For a half wave rectified voltage, the form factor and peak factor respectively are
1.11 and 2
1.57 and 2
1.11 and 1.11
1.57 and 2

⇒ The units of thermal capacitance are
k cal/°C
°C/k cal
°C sec/k cal
none of the above

⇒ If q is charge on an electron, R is radius of electron orbit and ω is angular velocity of electron rotation, the magnetic dipole moment of electron in orbit is
0.5 qωR
0.5 q²ω²R²
0.5 qωR²
0.5 qω²R

⇒

Match the following:

	List I (Types of transmission structure)		List II (Modes of propagation)
A.	Strip line	1.	Quasi TEM
B.	Hollow rectangular waveguide	2.	Pure TEM
C.	Microstrip	3.	TE/TM
D.	Corrugated waveguide	4.	Hybrid

A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4
A-4, B-3, C-1, D-2

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ In a shield helix
the spacing between adjacent turns is very large
the spacing between adjacent turns approaches zero
the spacing between adjacent turns approaches zero and wire thickness approaches zero
the spacing between adjacent turns is very large wire thickness approaches zero

⇒ The number of free electrons in acceptor atom is
1
2
3
4