Question is ⇒ Which of the following quantities cannot be measured/determined using Hall effect?, Options are ⇒ (A) Type of semiconductor (p or n), (B) Mobility of charge carriers, (C) Diffusion constant, (D) Carrier concentration, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following quantities cannot be measured/determined using Hall effect?, Options are ⇒ (A) Type of semiconductor (p or n), (B) Mobility of charge carriers, (C) Diffusion constant, (D) Carrier concentration, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following quantities cannot be measured/determined using Hall effect?
A.	Type of semiconductor (p or n) [Wrong Answer]
B.	Mobility of charge carriers [Wrong Answer]
C.	Diffusion constant [Correct Answer]
D.	Carrier concentration [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 2's complement form, - 2 is
1011
1110
1100
1010

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒ A magic tee is to be used as CW duplexer. Then port 1, port 2, port 3 (E arm), port 4 (H arm) respectively should be connected to
matched load, antenna, receiver and CW transmitter
CW transmitter, antenna, receiver and matched load
CW transmitter, receiver, antenna and matched load
CW transmitter, matched load, receiver and antenna

⇒ As the frequency is increased, the charging MVAR in a cable
decreases
increases
remain the same
decreases or remains the scheme

⇒ In an RL series circuit the inductance is 1H and current at an instant is 0.6 A. The energy stored in magnetic field is
0.36 J
0.18 J
0.09 J
0.03 J

⇒ EM 84 tube is used in radio receivers as
audio amplifier
RF amplifier
full wave rectifier
magic eye

⇒ When a BJT is operated under saturated condition
both junctions are forward biased
both junctions are reverse biased
CB junction is forward biased and EB junction is reverse biased
EB junction is forward biased and CB junction is reverse biased

⇒ For measuring mutual inductance we can use
Anderson bridge
Maxwell's bridge
Heaviside bridge
Either (a) or (b)

⇒ The inverse response of a system h(n) = aⁿ∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒ DC amplifiers have a tendency to be unstable.
TRUE
FALSE

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ Consider the following

Generation of SSB signals
Design of minimum phase type filters
Representation of band pass signals

Which of the above applications is Hilbert transform used?
1 only
1, 2 and 3
1, 2 only
1 and 3

⇒ The terms RMS and average values apply only to sine waves.
TRUE
FALSE

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ The magnitude plot of a composite signal x(t) = e^3jt + e^4jt is __________ .
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ In figure, i(0^-) and v(0^-) are zero. The switch is closed at t = 0, i(0⁺) and (∞)
3 A and 1.5 A
1.5 A and zero
3 A and zero
1.5 A and 3 A

⇒ Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded t
the output wave is distorted
the output wave is under modulated
the modulation index is 100%
the modulation index is 50%

⇒ A two branch parallel tuned circuit has a capacitance C in one of the two branches and resistance R in second branchs. As C is decreased the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is
OFFFH
1000H
B9FFH
BA00H

⇒ In an R-L-C circuit, v(t) = 20 sin (314 t + 5 p/6) and i(t) = 10 sin (314 t + 2p/3). The p.f of the circuit is
0.5 lead
0.866 lag
0.866 lead
0.5 lead

⇒ The amount of photoelectric emission current depends on the frequency of incident light.
TRUE
FALSE

⇒ Words having 8 bits are to be stored into computer memory. The number of lines required for writing into memory are
1
2
4
8

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ In 8085 microprocessor, what is the memory word size?
6 bits
8 bits
12 bits
16 bits

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ As the number of flip flops are increased, the total propagation delay of
ripple counter increases but that of synchronous counter remains the same
both ripple and synchronous counters increase
both ripple and synchronous counters remain the same
ripple counter remains the same but that of synchronous counter increases

⇒ A FET
has two P-N junctions
has three P-N junctions
depends on the variation of the depletion layer width with reverse voltage, for its operation
depends on the variation of a magnetic field for its operation

⇒ In an hydrogen atom, an electron moves in the field of a proton. The stability of orbit requires equilibrium between coulomb's force and centrifugal force.
TRUE
FALSE