Question is ⇒ Which of the following polynomials is not Hurwitz?, Options are ⇒ (A) P1 = s8 + 2s6 + 4s4, (B) P2 = s6 - 3s4 + 2s2 + 1, (C) P3 = s4 + 3s3 + 3s2 + 2s + 1, (D) P4 = s7 + 2s6 2s4 + 4s3 + 8s2 + 8s + 4, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following polynomials is not Hurwitz?, Options are ⇒ (A) P1 = s8 + 2s6 + 4s4, (B) P2 = s6 - 3s4 + 2s2 + 1, (C) P3 = s4 + 3s3 + 3s2 + 2s + 1, (D) P4 = s7 + 2s6 2s4 + 4s3 + 8s2 + 8s + 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following polynomials is not Hurwitz?
A.	P₁ = s⁸ + 2s⁶ + 4s⁴ [Wrong Answer]
B.	P₂ = s⁶ - 3s⁴ + 2s² + 1 [Correct Answer]
C.	P₃ = s⁴ + 3s³ + 3s² + 2s + 1 [Wrong Answer]
D.	P₄ = s⁷ + 2s⁶ 2s⁴ + 4s³ + 8s² + 8s + 4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As per BIS, solid insulators are classified into 6 categories.
TRUE
FALSE

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register D are stored
054 CH
054 DH
054 EH
054 FH

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ Linear transistor circuits always operate in
saturation region
cut off region
active region
passive region

⇒ Tape recorders use
cone type loudspeakers
horn type loudspeakers
either cone type or horn type loudspeakers
none of the above

⇒ Digital technologies being used now-a-days are
DTL and EMOS
TTL, ECL, CMOS and RTL
TTL, ECL and CMOS
TTL, ECL. CMOS and DTL

⇒ A 20 m antenna gives a certain uplink gain at frequencies of 4/6 GHz. For getting same gain in the 20/30 GHz band, antenna size required is metre.
100
4
1
10

⇒ Consider the following circuits. Assume all gates to have finite propagation d
(1) only
(1) and (2) only
(2) (3) and (4) only
All (1) (2) (3) and (4)

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ Four capacitors are in parallel. Their values are 36.3 μF, 3.85 μF, 34.002 μF and 850 μF with an uncertainty of digit in the last place. The total capacitance in significant figures is
75.0 μF
75.0 ± 0.1 μF
75.1 ± 0.1 μF
75.002 ± 0.1 μF

⇒ As temperature increases the number of free electrons and holes in an intrinsic semiconductor
increases
decreases
remains the same
may increase or decrease

⇒ L [f(t - a)] = F(jω) e^-jωa
TRUE
FALSE

⇒ A small signal source v_i(t) = A cos 20t + B sin10⁶t is applied to a transistor amplifier as shown below. The transistor has β = 150 and h_ie = 3 kΩ. Which expression best approximates V₀(t<
v₀(t) = -1500 (A cos 20t + B sin 10⁶t)
v₀(t) = -150 (A cos 20t + B sin 10⁶t)
v₀(t) = -1500 B sin 10⁶t
V₀(t) = -1500 sin 10⁶t

⇒ Which mode has the lowest cut off frequency in circular wave guides?
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ Internally the two distinct units of 8086 are called
bus interface unit and execution unit
command unit and follow unit
master unit and slave unit
memory unit and operation unit

⇒
Assertion (A): If the resistance of shunt of an ammeter is increased, the range of ammeter is reduced.
Reason (R): If the series resistance of a voltmeter is increased, the range of voltmeter is increased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ A TEM wave is incident normally on a perfect conductor. The E and H fields at boundary will respectively be
minimum and maximum
minimum and minimum
maximum and minimum
maximum and maximum

⇒ The correct sequence of parts in klystron amplifier are
anode, catcher cavity, cathode, buncher cavity
cathode, buncher cavity, catcher cavity, cavity
anode, buncher cavity, catcher cavity, cathode
cathode, catcher cavity, anode, buncher cavity

⇒ If Y(s) = 1 + s, the network has
1 Ω resistor and 1 F capacitor in series
1 Ω resistor and 1 F capacitor in parallel
1 Ω resistor and 1 H inductor in series
1 Ω resistor and 1 H inductor in parallel

⇒ If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about
330 m/s
334 m/s
353 m/s
380 m/s

⇒ The PAM Signal can be detected by
Band pass filter
Band stop filter
High pass filter
Low pass filter

⇒ The diagram to show distance time history of electrons in klystron amplifier is called
apple gate diagram
asynchronous diagram
bunching diagram
velocity modulation diagram

⇒ For the system of the given figure, the closed loop poles ar
0 and -4
-2 ± j6
2 ± j6
-3 ± j8

⇒ A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is a. The period of conduction of SCR and free wheeling diode respectively are
a < ωt < p and p < ωt < (2p + a)
a < ωt < p and p < ωt < 2p
a < ωt < (p + a) and (p + a) < ωt < 2p
a < ωt < p and p < ωt < (2p - a)

⇒ A second order system will have
all resistances
resistances and inductances
resistances, inductance and capacitances
either (b) or (c)

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ Calculate the directivity of a given linear end fire, uniform array of 20 element, each separated by λ/3
100
10
26.66
30

⇒ Which of the following constitute the loss resistance of an antenna?
Dielectric loss
Leakage loss in insulation
Loss in earth connections
All of the above

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math